Page 106 of 248

100 Instruments, ControlsWarning buzzersWhen starting the engine or whilst
driving:
zIf seat belt is not fastened 3.
z If the speed programmed at the
factory 3 is exceeded.
z If the car has automated manual
transmission 3 and the driver’s door is
opened when the engine is running, a
gear is engaged and the foot brake is
not depressed.
When the vehicle is parked and the
driver’s door is opened:
z when the key is in the ignition switch
z with parking lamps or dipped beam on
z if the turn signal stalk is engaged
Picture no: 14055h.tif
Windscreen wipers Windscreen wipers
To activate, press stalk briefly up Adjustable wipe interval
3
Setting wiper interval to a value between
2 and 15 seconds: Stalk to timed interval
wipe $, stalk to § , wait for desired
interval, stalk back to timed interval
wipe $.
The selected interval will remain stored
until the next time it is changed or until the
ignition is switched off.
After turning on the ignition and setting the
lever to $, the interval is set to 7 seconds.
& =Fast
% =Slow
$ = Adjustable timed interval wipe
§ =Off
Page 122 of 248
116 Climate control
Picture no: 14144s.tif
Heating and ventilation system Temperature
Adjusted using left-hand rotary switch.
The amount of heat is dependent on the
coolant temperature and is thus not fully
attained until the engine is warm.
Picture no: 14145s.tif
Air flow
Adjusted using centre rotary switch.
The rate of air flow is determined by the
fan. The fan should therefore also be
switched on during a journey.
Picture no: 14146s.tif
Air distribution
Set using right rotary switch.
Open the air vents when the switch is set
toL or M .
red area = warm
blue area = cold
x
off
1-4 selected fan speed
Vto windscreen and front side
windows
J towards windscreen, front door
windows and footwell
K to footwell
L towards head area and footwell
M towards head area
Page 125 of 248

119
Climate control
Air conditioning system
3
As a supplement to the heating and
ventilation system, the air conditioning
system cools and dehumidifies (dries)
inflowing air.
If cooling or dehumidification is not
desired, switch off cooling in order to save
fuel.
Cooling switches off automatically at low
outside temperatures.
Picture no: 14159s.tif
Cooling n
Only operate with the engine and fan
running. Activate and deactivate with
the nbutton.
When cooling is active (AC compressor) the
air is cooled and dehumid ified. If cooling or
dehumidification is not desired, switch off
cooling in order to save fuel.
Cooling switches off automatically at low
outside temperatures.
When cooling operates, condensation
forms and drips from the underside of the
vehicle.
Picture no: 14158s.tif
Air recirculation system 4
The air recirculation mode of the
ventilation system is activated and
deactivated by pressing the 4 button.
If fumes or unpleasant odours penetrate
from outside: Temporarily switch on air
recirculation system 4.
To increase cooling at high outside
temperatures, switch on the air
recirculation system briefly.
Page 127 of 248

121
Climate control
Picture no: 14162s.tif
Maximum cooling
Briefly open windows, sun roof and tilting
roof 3 so that warm air can escape quickly.
z Cooling n on
z Air recirculation system 4 on
z Turn the temperature switch
anticlockwise as far as it will go (cold)
z Set fan to 4
z Set air distribution switch to M
z Open all air vents
Picture no: 16482s.tif
Demisting and defrosting windows
Misted or icy windows, e. g. due to damp
weather, damp clothing or low outside
temperatures: z
Cooling n on, the air conditioning
compressor automatically switches itself
off at low outside temperatures (icing).
z Turn the temperature switch clockwise.
z Set fan to 3 or 4 .
z Air distribution switch to V, air
recirculation system 4 automatically
switches off,
– or –
if there is still moisture in the system after
previous air conditioning operation, the
windows may mist up. To prevent this,
set air distribution to K before starting
engine and set to V approx. 5 seconds
after starting.
z Activate heated rear window Ü.
z Open side air vents as required and
direct them towards the side windows.
9 Warning
Disregard of the instructions could lead
to misting or icing of the windows and
subsequent accidents due to impaired
visibility.
Page 128 of 248

122 Climate controlElectronic climate control
system
3
Provides a the greatest amount of comfort
in the interior regardless of the weather,
outside temperature or season.
To ensure a constant and comfortable
climate in the vehicle, the temperature of
the inflowing air, the air-flow rate and the
air distribution are changed automatically
according to climatic conditions outside
the vehicle.
The climate is regulated automatically
based on personal settings.
Picture no: 16500s.tif
Temperature changes due to external
influences, such as direct sunlight, are
automatically compensated.
When cooling (air conditioning
compressor) is active, air is cooled and
dehumidified.
The pollen filter removes dust, soot, pollen
and spores from the inflowing outside air.
Picture no:
When set to automatic mode, the climate
control system provides the optimal
settings for almost all conditions. If
necessary, climate control system settings
can be modified manually.
The climate control system is only
operational when the engine is running.
If you wish the climate control system 3 to
operate correctly, do not cover the sensor
on the instrument panel.
Cooling (air conditioning compressor)
switches off automatically at low outside
temperatures.
Page 132 of 248

126 Climate control
Picture no: 16506s.tif
Manual air recirculation mode
The air recirculation system prevents the
entry of outside air and the air in the
passenger compartment is circulated. Press button
4, % appears in the air
conditioning display.
To switch off manual air circulation: press
button 4 again.
Picture no: 16507s.tif
Air conditioning with the engine not
running
When the vehicle is stopped and the
ignition off, the residu al heat or cooling in
the system can be used for climate control
in passenger compartment, e.g. when
stopped at a level crossing.
Press AUTO with the ignition off. The
preselected temperature appears in the air
conditioning display. The temperature can
be adjusted with the left-hand rotary knob.
Residual climate control can only operate
for a limited period of time. To cancel,
press the AUTO button.
9 Warning
The exchange of fresh air is reduced in
air circulation mode. The quality of the
passenger compartment air
deteriorates which may cause the
vehicle occupants to feel drowsy. In
operation without cooling the air
humidity increases, so the windows may
mist up. Consequently, the air circulation
system should only be run for short
periods of time.
Page 133 of 248
127
Climate control
Auxiliary heater Depending on outside temperature and
engine temperature, the passenger
compartment of vehicles with Quickheat 3
electric auxiliary heating is warmed up
more quickly.
Diesel-engined vehicles have a fuel-
powered auxiliary heater 3.
Picture no: 14147s.tif
Air intake The air intakes in front of the windscreen on
the far right and left sides of the engine
compartment must be kept clear to allow
air intake. Remove any leaves, dirt or snow. Air outletDo not cover the air outlets when storing
items in the luggage compartment storage
compartments.
Pollen filter The pollen filter cleans dust, soot, pollen
and spores from the air entering from
outside. The active carbon layer 3
eliminates most odours and noxious
environmental gases from the air.
Page 136 of 248

130 Driving and operation
Picture no: 18386s.tif
Starting the engine
When starting the engine, activate the
footbrake at the same time. The engine
can only be started in position N and with
the footbrake activated. The transmission
display shows "N". If the footbrake is not
activated, the control light j 3 in the
instrument panel illuminates and "N"
flashes in the transmission display, the
engine cannot be started.
If no brake lights are operational, the
engine will not start.
Picture no: 14175s.tif
Operation of manual transmission
automated using selector lever
Always move the selector lever all the way
to the stop. Note the gear or mode
indicator in the transmission display.
Move selector lever toward N
Neutral. Selector lever in
o (centre position)
Once the selector lever has been moved
from N to position o (centre position) with
the foot brake operated, the Easytronic is
in automatic mode and first gear has been
selected (second gear with winter
programme enabled). "A" appears in the
transmission display.
When the foot brake is released the vehicle
starts to "creep". If the foot brake is not
operated, "A" flashes. Start off by pressing
the accelerator immediately or more
selector lever back to N and repeat
procedure with foot brake operated.
In Automatic mode, selection of other
gears is automatic irrespective of driving
conditions.