2009 OPEL MERIVA engine

41
Keys, doors, windows, slide and tilt sunroof
Picture no: 13992s.tif
Heated rear window 3
Heating is activated or deactivated by
pressing the Ü button.
Picture no: 16502s.tif
On vehicles with electronic climate
control Ü appears on the climate control
display.
Heating works with the engine running and
is switched off automatically after a few
minutes.
The heated rear window automatically
switches on when the dies el particle filter is
being cleaned 3 depending on the engine.
Climate control 3114. Overload
If the windows are repeatedly operated at
short intervals, the power supply is briefly
cut off.
Fault
If the windows cannot be opened and
closed automatically, activate the window
electronics as follows:
1. Close doors.
2. Switch on ignition.
3. Close the window completely and hold
the rocker switch down at least
5 seconds longer.
4. Open the window completely and hold the rocker switch down at least 1 second
longer.
5. Repeat for each window.

78 Seats, Interior
Picture no: 14111s.tif
Cigarette lighter
3
The cigarette lighter is behind the ashtray
cover in the centre console.
The ashtray cover opens when pressed at
the point indicated.
Press cigarette lighter with ignition
switched on. Switches off automatically
when element is hot. Withdraw cigarette
lighter.
Picture no: 16111s.tif
Accessory sockets
3
The accessory socket is behind the cover in
the centre console. Further accessory
sockets3 are located in the centre console
in front of the rear seats and in the luggage
compartment.
Accessory sockets are operable when the
ignition is switched on. Use of the sockets
while the engine is no t running will drain
the battery. Do not exceed the maximum power
consumption of 120 watts.
Electrical accessories connected to the
socket must comply with the
electromagnetic compatibility
requirements laid down in DIN VDE 40 839,
otherwise vehicle malfunctions may occur.
Do not connect any current-delivering
accessories, e.g. el
ectrical charging
devices or batteries.
If the tyre repair set is 3 is in operation, no
consumers may be connected to the
auxiliary socket.
Caution
Do not damage the socket by using
unsuitable plugs.

83
Instruments, Controls
Picture no: 18385s.tif
Flashes

System converted to symmetrical dipped
beam.
Control indicator
B
flashes for
approximately 4 seconds after the ignition
is switched on as a reminder that the
system has been converted 3110.
AFL 3106.
>

Fog lamps 3
Control indicator lights up green.
This comes on when the front fog lamps
are switched on 3103.
Picture no:
A

Engine electronics, transmission
electronics, immo biliser, diesel fuel filter 3
Control indicator lights up and/or flashes
yellow.
It illuminates for a few seconds when the
ignition is switched on.
Illuminates when the engine is running
Fault in engine electronics or transmission
electronics. Electr onics switches to
emergency running program, fuel
consumption may increase and driveability
of vehicle may be affected 3143. If the
fault is still there when the engine is started
again, contact a workshop for assistance.
For vehicles with diesel engine, the diesel
fuel filter may need to be drained of water
3 212.
Flashes when the ignition is onFault in the electronic immobiliser system;
the engine cannot be started 327. Z

Exhaust emission
Control indicator lights up and/or flashes
yellow.
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
Fault in emission control system. The
permissible emission limits may be
exceeded. Contact a workshop for
assistance immediately.
If it flashes when the engine is runningFault that could lead to catalytic converter
damage. Ease up on the throttle until the
flashing stops 3143. Seek the immediate
assistance of a workshop. v
Airbag systems 3, Belt tensioners
Control indicator lights up red.
Illuminates when the engine is runningFault in zone of airbag system or belt
tensioners 361, 372.

84 Instruments, Controls
Picture no: 17876s.tif
I

Engine oil pressure
Control indicator lights up red
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
1. Depress clutch.
2. Move gearshift lever to neutral, or with
manual transmissi on automated 3 place
selector lever in N.
Picture no:
3. Move out of the flow of traffic as quickly
as possible without impeding other
vehicles.
4. Switch off ignition.
Contact a workshop for assistance.
Caution
Engine lubrication may be interrupted.
This may result in damage to the engine
and/or locking of the drive wheels.
9 Warning
When the engine is off, considerably
more force is needed to brake and steer.
Do not remove key until vehicle has
come to a standstill, otherwise the
steering column lock could engage
unexpectedly.
O

Turn signal lamps
Control indicator flashes green.
The control indicator flashes if a turn signal
or the hazard warning flashers are
activated.
Rapid flashing: failure of a direction
indicator lamp or associated fuse.
Change bulbs 3 185. Fuses 3182.
C

Main beam
Control indicator lights up blue.
It is illuminated when main beam is on and
during headlamp flash 311, 3102.
j

Automatic transmission 3, start engine.
Control indicator lights up yellow.
The engine can only be started if the foot
brake is depressed. If the foot brake is not
depressed, the control indicator illuminates
3 130.

85
Instruments, Controls
Picture no: 18385s.tif
T
Winter mode for manual transmission
automated 3
Control indicator lights up yellow.
Control indicator lights up when winter
program is enabled 3132. m

Cruise control 3
Control indicator lights up green
This comes on when the system is switched
on 3148.
r
Fog tail lamp
Control indicator lights up yellow.
This comes on when the fog tail lamp is
switched on 3104.
Picture no:
p

Alternator
Control indicator lights up red.
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
Stop, switch off engine. Battery is not
charging. Contact a workshop
immediately. R

Brake system, clutch system
Control indicator lights up or flashes red.
Illuminated
Illuminates when the ignition is switched on
if the hand brake is applied 3151.
Lights up when the hand brake is released
when the fluid level for the brake or clutch
systems is low 3214.
FlashesOn vehicles with manual transmission
automated 3, control indicator R flashes
for a few seconds after the ignition is
switched off when the hand brake has not
been applied. u

Anti-lock brake system
Control indicator lights up red.
Illuminates while driving
Fault in anti-lock braking system 3152. S

Engine oil level 3
Control indicator lights up yellow.
The engine oil level is checked
automatically 3.
Illuminates when the engine is running

Engine oil level too lo w. Check engine oil
level and top up engine oil if necessary
3 210.
9 Warning
Stop. Do not continue your journey.
Consult a workshop.

86 Instruments, Controls
Picture no: 17876s.tif
EPS
1)
Electric power steering
Control indicator lights up yellow.
Fault in electr ical power steering. Vehicle
can still be driven, but greater force is
required for steering. Contact a workshop
immediately.
v
Electronic Stability Program (ESP ®
Plus
)3
Control indicator flashes or lights up
yellow.
Flashing during driving
System engages 3146.
Illuminates while drivingFault in system 3146.
Picture no:
Y
Fuel level
Control indicator lights up and/or flashes
yellow.
Lamps

Level in fuel tank too low.
Flashes
Fuel level is used up, fuel immediately.
Never let the tank run dry!
Erratic fuel supply can cause catalytic
converter to overheat 3142.
Diesel engines: Bleed the fuel system after
running empty 3165.
1)EPS
= Electric
Power
Steering.
!

Preheating system 3, Diesel particle
filter 3
Control indicator lights up and/or flashes
yellow.
Illuminated
Preheating activated. Only activates when
outside temperatures are low.
Flashes(in vehicles with dies el particle filter)
Control indicator ! flashes if the filter
requires cleaning and previous driving
conditions did not permit automatic
cleaning. Continue driving and if possible
do not allow engine speed to drop
below 2000 rpm.
The control indicator ! goes off as soon
as the self-cleaning op eration is complete.
Diesel particle filter 3 144.

87
Instruments, Controls
Picture no: 12097s.tif
y

Seat occupancy recognition 3
3 67, 372.
Picture no: 17879s.tif
Instrument display In some versions, the indicators of the
instruments briefly rotate to the end
position when the ignition is switched on.
Tachometer
Displays the engine rpm.
Drive in a low engine speed range for each
gear as much as possible.
Speedometer
Speed display. Picture no:
Kilometre display
If the ignition is off the mileage is displayed
for approx. 15 seconds by briefly pressing
the reset knob.
Top line:
Trip odometerDisplays the number of
kilometres since the
gauge was reset.
To reset, hold the reset knob depressed for
a few seconds with the ignition on.
Bottom line:
OdometerRecords the number of kilometres.
Maintenance, Inspection system, 389,
3 208.
Caution
If the pointer is in the warning zone, the
maximum permitted engine speed is
exceeded. Engine at risk.

88 Instruments, Controls
Picture no: 17906s.tif
Coolant temperature display
Coolant temperature display For physical reasons, the engine
temperature gauge shows the coolant
temperature only if the coolant level is
adequate.
During operation the system is pressurised.
The temperature may therefore rise briefly
to over 100 C.
Picture no: 17907s.tif
Fuel gauge
Fuel tank level display.
If the fuel level is too low, a warning lamp
lights up
Y. When the light flashes, refuel as
soon as possible.
Never run the tank dry!
Because of the fuel remaining in the tank,
the amount of fuel required to fill the
tank may be less than the specified tank
capacity.
Pointer in zone at
left
= Engine operating
temperature not yet
reached.
Pointer between
the zones = Normal operating
temperature.
Pointer in zone at
right (warning
zone) = Temperature too
high: Stop vehicle
and switch off
engine. Danger to
engine. Check
coolant level
immediately 3 213.