Page 111 of 153
10-11Vehicle care
Interior lamps
1. Using a suitable screwdriver
covered by a cloth, pry lens away
from roof lining.
2. Remove bulb by pulling straight
out.
3. Insert new bulb, ensuring contact
springs hold the bulb securely.
4. Reinstall lens in roof lining by
pushing it back into original
position.
Instrument illumination
Have bulbs replaced by a workshop.
Electrical system
Fuses
Only install fuses of the specified
rating. Each fuse has its rating written
on it, in addition the fuses are colour
coded.
There are two fuse boxes in the
vehicle: the instrument panel fuse
box is located on the left-hand side of
the vehicle below the instrument
panel and the engine compartment
fuse box is located next to the battery.
It is advisable to carry a full set of
fuses.
Spare fuses can be kept in the engine
compartment fuse box.
When replacing a fuse, turn off the
respective switch and the ignition.
Page 113 of 153
10-13Vehicle care
Some circuits may be protected by
several fuses.
Engine compartment fuse
box
Petrol engines
The fuse box is located next to the
battery in the engine compartment.
To open, disengage cover and tilt
upwards. No. Circuit
1-
2Ignition coils
3Reversing lamp
4Instrument cluster
5Accessory socket, cigarette
lighter, power exterior mirror
6Infotainment system
7Power window
8Wipers/washer
9Power steering
10Airbag system
11ABS, ESP
12Tail lamp
13-
14Door lock
15Diesel engine
16Starter motor
17-
18Heater fan
19Rear fog lamp
20Infotainment system
21Heated rear window
22Horn, hazard warning
23Manual transmission
24Power windows No. Circuit
9 Danger
Switch off ignition before opening
the engine compartment fuse
box.
Page 114 of 153
10-14 Vehicle care
Do not store any objects behind the
cover.
Some circuits may be protected by
several fuses.Diesel engines
The fusebox is located behind the
rear of the battery.
To open, disengage cover and lift
upwards.
No. Circuit
1Heater fan
2Fuel injection
3Air conditioning compressor
4Automatic transmission
5Brake lamp switch
6ABS, ESP
7Starter motor
8-
9Power steering control
module
10Ignition switch
11Radiator fan
12-
13ABS, ESP
14-
15Engine electrics
16Front fog lamps
17Headlamp (left)
18Headlamp (right) No. Circuit
Page 126 of 153

10-26 Vehicle care
Rotate jack shaft anti-clockwise and
remove jack from storage bracket.
To stow the jack after use, place it in
its storage bracket and turn jack shaft
clockwise until jack is held securely in
place.Jump starting 3
Do not start with quick charger, to
prevent damage to electronic
components.
Never expose the battery to naked
flames or sparks.
„A discharged battery can freeze at
temperatures of 0 °C. Defrost the
battery in a warm room before
connecting the jump leads.
„Do not allow battery fluid to contact
eyes, skin, fabrics or painted
surfaces. The fluid contains
sulphuric acid which can cause
injuries and damage in the event of
direct contact. „Wear eye protection and protective
clothing when handling a battery.
„Use auxiliary battery with same
voltage (12 volts). Its capacity (Ah)
must not be considerably less than
that of the discharged battery.
Voltage and capacity information
can be found on the batteries.
„Use jump leads with insulated
terminals and a width of at least
16 mm
2 (25 mm2 for diesel
engines).
„Do not disconnect the discharged
battery from the vehicle.
„Switch off all unnecessary
electrical consumers. Infotainment
system may be damaged if
switched on while jump starting.
„Do not lean over the battery during
jump starting procedure.
„Do not allow the terminals of one
lead to touch those of the other
lead.
„The vehicles should not touch while
jump starting.
„Apply parking brake.
9 Warning
This must be done with extreme
care. Any deviation from the
following instructions could lead
to personal injury or damage
resulting from battery explosion,
as well as to damage to the
electrical systems in both
vehicles.
Page 127 of 153