5-3Instruments and controls
Windscreen washer system
To activate, pull lever towards
steering wheel. Washer fluid is
sprayed onto the windscreen.
In vehicles with timed interval wipe
position INT 3, the wipers switch on
automatically at low speed if they are
not already activated.
Rear window wiper/washer
To activate wiper and washer, rotate
end of lever:
Washer fluid is sprayed on to rear
window when the end of the lever is
turned to position
f. When the lever
is released, it will spring back to the
ON/OFF position.Further information 3 10-5, 10-30,
10-31.
Clock
The time is shown in the odometer
display when the ignition is switched
on.
Correcting time
To set the clock, press and hold the
Öbutton for approx. 2 seconds; clock
display now in setting mode. f=Washer
ON = Wiper on
INT = Timed interval wipe 3
OFF = Wiper off
f=Washer
Minute display flashes.
Press Ö to set minutes.
10-23Vehicle care
4. Attach the jack handle to the
wheel bolt wrench (as shown in
illustration) and insert hook end
of jack handle through jack eye.
Before positioning the jack, set it
to the necessary height by
rotating the jack handle
clockwise using the attached
wheel bolt wrench.5. Position jack at the front or rear
jacking point located nearest to
the wheel concerned so that the
jack claw spans the vertical
base. Make sure it is properly
positioned, ensuring the jacking
bar fits securely into the jack
head groove.
The jack base must be on the
ground directly below the jacking
point in a manner that prevents it
from slipping.6. Rotate jack handle clockwise
using the attached wheel bolt
wrench to raise vehicle.
Raise the vehicle until the wheel
is just clear of the ground.
7. Unscrew wheel bolts completely
by turning anti-clockwise and
wipe clean with a cloth.
Put wheel bolts somewhere
where the threads will not be
soiled.
