10-3Vehicle care
To close, lift bonnet slightly, release
the support rod from the hole and
press it back into its retaining clip.
Lower the bonnet gradually, allowing
it to drop from a height of approx.
30 cm.
Check that the bonnet is locked in
position before driving, by pulling at
its front edge. If it is not engaged,
repeat closing procedure.
Engine oil
Information on engine oil is in the
chapter “Service and maintenance”
311-6.
We recommend the engine oil level is
checked before starting a long trip.
The engine oil level must be checked
with the vehicle horizontal and with
the engine (which must be at
operating temperature) switched off.
Wait a few minutes before checking
the level to allow the normal oil
accumulation in the engine to drain
back into the oil pan.
Pull out dipstick from the tube, wipe it
clean and re-insert it as far as it will
go. After pulling the dipstick out again, check the engine oil level,
ensuring it is between the lower and
upper (MIN and MAX) marks.
The illustrations show checking the
engine oil in the K 10 B and K 12 B
petrol engines and the diesel engines
respectively.
Top up if the engine oil level has
dropped to the "add oil" lower mark
(MIN mark).
10-4 Vehicle care
When replenishing, attempt to use
the same type of engine oil as used at
the last oil change.
The engine oil level must not go
above the upper (MAX) mark on the
dipstick.
Capacities 3 12-5.
Engine oil life monitor 3 3 5-14.
Engine coolant
Antifreeze and corrosion
protection
The antifreeze provides freeze
protection down to -28 °C.
Coolant level
The illustrations show the LOW and
FULL coolant level marks in the
petrol and diesel engines
respectively.
Caution
Overfilled engine oil must be drained
or syphoned out.
Caution
Use only approved antifreeze.
9 Warning
Allow engine to cool down before
removing coolant filler cap. If
steam is visible, move away from
the vehicle until the engine is
cool.
Remove coolant filler cap
carefully so that pressure can
escape slowly.
