2009 NISSAN LATIO wiring

EC-308< COMPONENT DIAGNOSIS >
[HR16DE]
P0448 EVAP CANISTER VENT CONTROL VALVE
Wiring Diagram INFOID:0000000004780720
Diagnosis Procedure INFOID:00000000047801891.
CHECK RUBBER TUBE
1. Turn ignition switch OFF.
2. Disconnect rubber tube connected to EV AP canister vent control valve.
3. Check the rubber tube for clogging. AABWA0310G B

EC
NP
O
Wiring Diagram
INFOID:0000000004780692
Diagnosis Procedure INFOID:0000000004780197Ground Inspection " .
Is the inspection result normal? B

EC-324< COMPONENT DIAGNOSIS >
[HR16DE]
P0453 EVAP CONTROL SYSTEM PRESSURE SENSOR
Wiring Diagram INFOID:0000000004780721
Diagnosis Procedure INFOID:00000000047802011.
CHECK GROUND CONNECTION
1. Turn ignition switch OFF.
2. Check ground connections E15, E24. Refer to EC-125, " Ground Inspection " .
Is the inspection result normal? AABWA0311G B

EC
NP
O
P0607 ECM
Description INFOID:0000000004780240
CAN (Controller Area Network) is a serial communication li ne for real time application. It is an on-vehicle mul-
tiplex communication line with high data communication speed and excellent error detection ability. Many elec-
tronic control units are equipped onto a vehicle, and each control unit shares information and links with other
control units during operation (not independent). In CAN communication, control units are connected with 2
communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.
DTC Logic INFOID:0000000004780241
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE YES >> Go to
EC-357, " Diagnosis Procedure " .
NO >> INSPECTION END
Diagnosis Procedure INFOID:0000000004780242Diagnosis Description "
3. Perform DTC CONFIRMATION PROCEDURE. Refer to
EC-357, " DTC Logic " .
4. Check DTC.
Is the DTC P0607 displayed again? YES >> GO TO 2.
NO >> INSPECTION END ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Require-
ment " .
>> INSPECTION END
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0607 CAN communication bus When detecting error during the initial diagnosis
of CAN controller of ECM. • ECM

EC
NP
O
Wiring Diagram
INFOID:0000000004780693
Diagnosis Procedure INFOID:0000000004780244Ground Inspection " .
Is the inspection result normal?

EC
NP
O
Wiring Diagram
INFOID:0000000004780697
Diagnosis Procedure INFOID:0000000004780299 B

EC
NP
O
Wiring Diagram
INFOID:0000000004780698
Diagnosis Procedure INFOID:0000000004780303 B

EC
NP
O
Wiring Diagram
INFOID:0000000004780699
Diagnosis Procedure INFOID:0000000004780306Ground Inspection " .
Is the inspection result normal? B