2009 Hyundai Santa Fe engine

6DO-IT-YOURSELF MAINTENANCE
30
OCM055020
(1)
(2) (3) (4)
(5)
5. Disconnect the power cord fromthe bulb base in the back of the headlight.
6. Turn the plastic cover counterclock- wise and remove it.
OCM055010L
G270A01CM-DAT
Headlight, Front Turn Signal Light and Front Position Light
OCM055008L
OCM055021L
OCM055009L
(1) Turn signal light (2) Front position light (3) Headlight (Low Beam) (4) Headlight (High Beam) (5) Front fog light
1. Allow the bulb to cool. Wear eye protection.
2. Open the engine bonnet.
3. Always grasp the bulb by its plastic base, avoid touching the glass. 4. Using a proper tool, remove the
headlight assembly mounting bolts and nut.
CM-aust-6.p65 5/19/2008, 6:39 PM
30

6DO-IT-YOURSELF MAINTENANCE
38FUSE PANEL DESCRIPTION
G200C01CM-DAT Engine Compartment
OCM055023
NOTE: Not all fuse panel descriptions in this manual may be applicable to your vehicle. It is accurate at the time of printing. When you inspect the fuse box on your vehicle, refer to the fuse box label.
FUSE RATING 125A 150A10A 30A 40A50A 40A 40A 40A 15A 40A 15A20A 15A40A 30A 15A 10A 15A 15A 15A10A CIRCUIT PROTECTED
FUSIBLE LINK BOX
ALTERNATOR
A/CON RELAY
RR HTD RELAY
I/PJUNCTION BOX
I/PJUNCTION BOX
I/PJUNCTION BOX
ABS CONTROL MODULE, ESP CONTROL MODULE, MULTIPURPOSE CHECK CONNECTOR
ABS CONTROL MODULE, ESP CONTROL MODULE, MULTIPURPOSE CHECK CONNECTOR
DEICER RELAY
ENGINE CONTROL RELAY
HORN RELAY IGNITION COIL #1~#6(PETROL), CONDENSOR(PETROL), ECM(DIESEL)
ECM(DIESEL), PURGE CONTROL SOLENOID VALVR(PETROL), VARIABLE
INTAKE MANIFOLD VALVE(PETROL), PCM(PETROL), OIL CONTROL
VALVE(PETROL)
RAD FAN RELAY
CON FAN #1 RELAY, CON FAN #2 RELAY
MASS AIR FLOW SENSOR(PETROL), EGR ACTUATOR(DIESEL), OXYGEN
SENSOR #1~#4(PETROL), SOLENOID VALVE(DIESEL), PCM(PETROL),
CAMSHAFT POSITION SENSOR(DIESEL), THROTTLE FLAP ACTUATOR(DIESEL),
FUSIBLE LINK BOX(DIESEL) IMMOBILISER MODULE, INJECTOR #1~#6(PETROL), PCM(PETROL) STOP LAMP
SWITCH(DIESEL), A/CON RELAY, FUEL PUMP RELAY
FUEL PUMP RELAY
H/LP LO LH RELAY
H/LP LO RH RELAY
FR FOG RELAY
DSL ALT
A/CON
RR HTD BLR
B+ #2
P/WDW ABS #1 ABS #2
DEICER
ECU MAIN HORN
IG COIL
SENSOR #3 RAD FAN
CON FAN
SENSOR #2 SENSOR #1 FUEL PUMP H/LP LO LH
H/LP LO RH
FR FOG
FUSE
CM-aust-6.p65 5/19/2008, 6:40 PM
38

7EMISSION CONTROL SYSTEMS
2EMISSION CONTROL SYSTEM
H010A01A-DAT (If installed) Your Hyundai is equipped with an emission control system to meet all ADR requirements. There are three emission control sys- tems which are as follows.
1. Crankcase emission control sys- tem
2. Evaporative emission control sys- tem
3. Exhaust emission control systemIn order to assure the proper function of the emission control systems, it is recommended that you have your carinspected and maintained by an authorised Hyundai dealer in accor- dance with the maintenance schedulein this manual. H010B01A-AAT
1. Crankcase Emission Control
System
The Positive Crankcase Ventilation
(PVC) System is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. Thissystem supplies fresh filtered air to the crankcase through the air intake hose. Inside the crankcase, the freshair mixes with blow-by gases, which then pass through the PCV valve and into the induction system. H010C02Y-GAT
2. Evaporative Emission Control
System
The Evaporative Emission Control
System is designed to prevent fuel vapors from escaping into the atmo- sphere. Canister
Fuel vapors generated inside the fuel
tank are absorbed and stored in the onboard canister. When the engine isrunning, the fuel vapors absorbed in the canister are drawn into the induc- tion system through the purge controlsolenoid valve. Purge Control Solenoid Valve
The purge control solenoid valve is
controlled by the ECM (Engine Control Module); when the engine coolant tem- perature is low, and during idling, it closes, so that evaporated fuel is nottaken into the engine. After engine warm-up, during ordinary driving, it opens so as to introduce evaporatedfuel to the engine.

7
EMISSION CONTROL SYSTEMS
3EGR SYSTEMCATALYTIC CONVERTER
H020A01A-DAT ; For a Petrol Engine The catalytic converter is part of the exhaust emission control system. Its purpose is to remove certain engineemission products from the engine's exhaust. It looks something like a muffler and is located underneath thecar in the exhaust system.
H010D01A-AAT
3. Exhaust Emission Control
System
The exhaust emission control systemis a highly effective system which controls exhaust emission while main- taining good vehicle performance. H010E01Y-GAT This system helps reduce nitrogen
oxides by recirculating a part of the exhaust gas into the engine, therebyreducing cylinder combustion tempera- ture, which results in lower output of oxides of nitrogen.
OCM055018RCatalytic Converter

7EMISSION CONTROL SYSTEMS
4
o Avoid idling the engine for periodslonger than 3 minutes.
o Your Hyundai should not be either pushed or pulled to get it started. This can cause the catalytic con-verter to overload.
o Take care not to park, idle or drive your Hyundai over or near flam- mable objects, such as grass, pa- per, leaves or rags. These materialscould come in contact with the cata- lytic converter and could cause a fire.
o Do not touch the catalytic converter or any other part of the exhaustsystem while the engine is runningas it is very hot and could result in burns.
o Remember that your Hyundai dealer is your best source of assistance.
H020B01CM-DAT About the Catalytic Converter Exhaust gases passing through the catalytic converter cause it to operate at very high temperatures. As a result, the introduction of large amounts ofunburned petrol may cause it to over- heat and create a fire hazard. This can be avoided by observing the following:
o Use unleaded fuel only.
o Maintain your engine in good condi-
tion. Extremely high converter tem- peratures can result from improper operation of the electrical, ignitionor fuel injection systems.
o If your engine stalls, pings, knocks, or is hard to start, take your car to your Hyundai dealer as soon as possible and have the difficulty cor-rected.
o Avoid driving with a very low fuel
level. If you run out of petrol, itcould cause the engine to misfire and result in excessive loading of the catalytic converter. H020D01S-GAT
; For a Diesel Engine
Hyundai vehicles are equipped with
oxidation type catalytic converter to reduce the carbon monoxide, hydro- carbons and particulate contained inthe exhaust gas.

Vehicle Identification Number (VIN) ............................. 8-2
Engine Number ............................................................. 8-2
Vehicle Compliance Plate ............................................ 8-3
Recommended Inflation Pressures .............................. 8-3
Snow Tyres .................................................................. 8-4
Tyre Chains .................................................................. 8-5
Tyre Rotation ................................................................ 8-5
Tyre Balancing ............................................................. 8-6
Tyre Traction ................................................................ 8-6
When to Replace Tyres ............................................... 8-6
Spare Tyre and Tools .................................................. 8-7
8
CONSUMER INFORMATION
8
CM-aust-8.p655/19/2008, 6:41 PM
1

8CONSUMER INFORMATION
2ENGINE NUMBERVEHICLE IDENTIFICATION NUMBER (VIN)
I010A01CM-DAT
The vehicle identification number (VIN) is the number used in registering your car and in all legal matters pertaining to its ownership, etc. It can be found inthree different places on your car:
1. On the engine side of the firewall
between the engine and driver com- partment.
2. On the left top side of the instru- ment panel where it can be seen bylooking down through the windshield.(If Installed)
3. Door edge post (Front passenger's
side).OCM056001R
OCM053107R
OCM056002
1
2
3I010B01A-AAT
OCM056003A
Petrol Engine 3.3 V6
Petrol Engine 2.7 V6
OCM056004N
CM-aust-8.p65 5/19/2008, 6:41 PM
2

8
CONSUMER INFORMATION
3TYRE
I030A01CM-DAT RECOMMENDED INFLATION PRESSURES The tyre label located on the driver's door centre pillar outer panel gives the tyre pressures recommended for your car.
I020A01A-DAT TYRE INFORMATION The tyres supplied on your new Hyundai are chosen to provide the best perfor- mance for normal driving.
OCM055119R
I010C01A-DAT A vehicle safety Compliance Plate confirming that your Hyundai vehicle complied with Australian Design Rulesapplicable at its time of manufacture is located inside engine compartment.
VEHICLE COMPLIANCE PLATE
Diesel Engine
The engine number is stamped on the
engine block as shown in the drawing.
OCM056003
CM-aust-8.p65 5/19/2008, 6:41 PM
3