Dash View/
Need to Know
Hood
Release
Trunk Release/Fuel Fill
Door Release Accessory
Power Sockets
Moonroof Switch
Power Mirrors
Indicator
Lights/GaugesHomeLink®Rear Window
Defogger
Climate Control
System
Seat HeatersParking Brake
Audio
System
Transmission
Power Door
Locks
Power
Windows
09 Accord Coupe InsideFront:09 Accord Sedan.qxd 6/19/2008 1:40 PM Pag\
e 1
HFL/
HomeLink®
Bluetooth® HandsFreeLink®(Navi models)Your vehicle is equipped with Bluetooth
HandsFreeLink (HFL). HFL uses Bluetooth
technology to link your cell phone to your vehicle, and
you can place and receive calls through the audio
system. To use this feature, you need a Bluetooth-
compatible cell phone with the hands-free profile. For
more information (including pairing information), and
a list of compatible cell phones, visit
handsfreelink.honda.com , or call (888) 528-7876.
Tip: The maximum range between your phone and
the vehicle is 30 feet.
HFL TALK button: Activates HFL
(audio system mutes). Press and
release the button, wait for a beep,
then give a voice command in a
clear, natural speaking voice
(without pause). If a voice
command is not given within 3
seconds, the system times out (two
beeps).
HFL BACK button: Use to end a
call, to go back to the previous
command, or to cancel an
operation.HFL DisplayWhen operating HFL, the following appears in
the main and center displays.
Using Voice Control•If HFL does not recognize a command, its
response is “Pardon, please repeat.”
• To hear a list of available options at any time, say “HandsFree help.”
• Many commands can be spoken together. For example, you can say “Dial 123-456-7891.”
• To skip a voice prompt, press the HFL TALK button while HFL is speaking. HFL is then ready
for your next command.
• To end a command sequence, press and hold the HFL BACK button, or press the HFL TALK button
and say “Cancel.” The next time you press the
HFL TALK button, HFL begins from the main
menu.
• Make sure that the airflow from the A/C vents does not interfere with the system microphone in
the ceiling console.
• Close the windows/moonroof.
• If the microphone picks up other voices or if you don’t speak clearly, the system may not
understand your command.
HFL
BUTTONS
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 15
* Check the owner’s manual for additional information and instructions. HFL/
HomeLink
®
Press and hold the button on the
remote and the HomeLink button at
the same time. Then, while
continuing to hold the HomeLink
button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
Press and hold the
HomeLink button
again. Training
complete
YES
NO
HomeLink indicator
flashes for 2 seconds,
then remains on. HomeLink LED
remains on.
YES
NO YES
NO
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program.1
Press and hold the desired HomeLink
button and the button on the remote
transmitter you wish to link.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
2
aThe remote has a rolling code.
Press the “learn” button on the
remotely controlled device (e.g.,
garage door opener).
Press the programmed HomeLink
button again; the remotely
controlled device should operate. Within 30 seconds, press and hold
the programmed HomeLink button
for 2 seconds.a
Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
3
b
4
5
Training a Button
Indicator remains
on for about 25
seconds (standard
transmitter). Indicator flashes rapidly
for 2 seconds, then
remains on for about 23
seconds (rolling code
transmitter).
Press and hold the desired
HomeLink button until the HomeLink
indicator begins to flash slowly.
When the indicator begins to flash
slowly, continue to hold the HomeLink
button and follow steps 1– 4 under
Training a Button.1
2
Retraining a Button
Erasing CodesTo erase codes stored in all buttons,
press and hold the two outer buttons until
the HomeLink indicator begins to flash
(about 10 to 20 seconds), then release
the buttons.
You should erase all three codes before
selling the vehicle.
If you have any problems programming
HomeLink, see the owner's manual included with
the device you are trying to program, or call
HomeLink at 1-800-355-3515 or go online to
www.homelink.com .
HomeLink®(if equipped)The HomeLink® Universal Transceiver built into your vehicle can be programmed to operate up to th\
ree remote
controlled devices around your home, such as garage doors, lighting, or \
home security systems.
09 AccordCoupe:09 Accord Coupe.qxd 6/16/2008 1:41 PM Page 16
