2009 FIAT PANDA turn signal

5KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0Z0003m
fig. 3
THE FIAT CODE SYSTEMTo further protect your car from theft, it has been fitted
with an engine immobilising system. It is automatically acti-
vated when the ignition key is removed.
An electronic device, in fact, is fitted in each ignition key grip.
The device transmits a radio-frequency signal when the en-
gine is started through a special aerial built into the igni-
tion switch. The modulated signal, which changes each time
the engine is started, is the “password”, by means of which
the control unit recognises the key and enables to start
the engine.
OPERATION
Each time the car is started by turning the ignition key to
MAR, the Fiat CODE system control unit sends an ac-
knowledgement code to the engine management control
unit to deactivate the inhibitor.
The acknowledgement code is sent only if the Fiat CODE
system control unit has recognised the code transmitted
from the key.
Each time the ignition key is turned to STOP, the Fiat
CODE system deactivates the functions of the engine man-
agement control unit.
If the code has not been recognised correctly, the instru-
ment panel warning light
Y
turns on.
In this case, turn the key to STOP and then back to MAR;
if the lock continues, possibly try with the other keys pro-
vided with the car. If you still cannot start the engine, per-
form the emergency start procedure (see chapter “In an
emergency”) and then contact the Fiat Dealership.
SYMBOLSSpecial coloured labels have been attached near or actu-
ally on some of the components of your car. These labels
bear symbols that remind you of the precautions to be tak-
en as regards that particular component.
The plate summarising the symbols used can be found un-
der the bonnet, fig. 3.
001-030 PANDA EN 7-10-2009 13:39 Pagina 5

17KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0Z0185m
fig. 22
F0Z0016m
fig. 23
MULTIFUNCTION DISPLAY STANDARD SCREEN fig. 23
The standard screen shows the following information:
A Headlight aiming position (only with dipped beam head-
lights on).
B Clock.
C Odometer (display of covered km or miles).
NOTE With key removed (when opening at least one of
the front doors) the display turns on and shows the time
and covered km or miles, for a few seconds. WARNING LIGHT TEST fig. 22
The following warning lights are tested:
❒
engaged handbrake/low brake fluid level;
❒
ABS and EBD system (where provided);
❒
ESP system (where provided);
❒
“Dualdrive” electrical power steering failure (where
provided).
The diagnosis is automatically run when the ignition key
is turned to MAR and during standard operation when
a fault is signalled. At the end of the initial warning light
check, the message “LEd Error” will flash on the display
for about 10 seconds if a faulty warning light is found.
001-030 PANDA EN 7-10-2009 13:39 Pagina 17

Do not take unnecessary risks, even if your
vehicle is fitted with an ESP system. Your
driving style must always be suited to the road
conditions, visibility and traffic. The driver is ulti-
mately responsible for road safety.
WARNING
Failure indications
In the event of a failure, the ESP system will be automati-
cally switched off and warning light
á
will appear on
the instrument panel along with a message on the recon-
figurable multifunction display (where provided). The LED
on the button ASR OFF will light up (see “Warning lights
and messages”) In this case, contact a Fiat Dealership.
HILL HOLDER SYSTEM
(for versions/markets, where provided)
This system is integral part of the ESP system and it is pro-
vided to facilitate starting on slopes. It is automatically ac-
tivated in the following conditions:
❒
uphill: car at a standstill on a road with a gradient high-
er than 2%, engine running, clutch and brake pedal
pressed, gearbox in neutral or engaged gear other than
reverse.
ESP SYSTEM
(Electronic Stability Program) (for versions/markets where provided)
GENERAL INFORMATION
This is an electronic system controlling car stability in
the event of tyre grip loss, helping to maintain direction-
al control.
The ESP system is therefore particularly useful when grip
conditions of road surfaces change.
Besides the ESP, the car is provided with ASR (traction
control with interventions on brakes and engine), HILL
HOLDER (device for start on gradient without using
the brakes), MSR (control of engine braking torque when
shifting gear down) and HBA (automatic increase of brak-
ing pressure in case of emergency braking).
SYSTEM INTERVENTION
It is signalled by the blinking of the warning light
á
on the
instrument panel, to inform the driver that the car is in
critical stability and grip conditions.
System engagement
The ESP system comes on automatically when the vehi-
cle is started and cannot be turned off.
76
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 76

F0Z0267m
fig. 88
When the ASR is switched off whilst driving, the next time
the car is started up the ASR is automatically switched
on by the system. When travelling on snowy roads with
snow chains, it may be helpful to turn the ASR off: in fact,
in these conditions, slipping of the drive wheels when mov-
ing off makes it possible to obtain better traction. The action of the ASR system is particularly helpful in
the following circumstances:
❒
slipping of the inner wheel when cornering due to the
effect of dynamic load changes or excessive accelera-
tion;
❒
too much power transmitted to the wheels also in re-
lation to the conditions of the road surface;
❒
acceleration on slippery, snowy or icy surfaces;
❒
in the event of loss of grip on a wet surface
(aquaplaning).
MSR system (engine drive regulation)
This is integral part of the ASR system that, in the event
of a sudden gear downshifting, cuts in and provides torque
to the engine thus preventing excessive drive wheel dri-
ve which, especially in poor grip conditions, can lead to
loss of stability.
Switching the ASR system on/off fig. 88
The ASR system switches on automatically each time
the engine is started. Whilst driving, the ASR can be
switched off and subsequently switched on again by press-
ing the C ASR OFF button. When the system is switched
on, this is signalled by a message on the reconfigurable mul-
tifunction display (where provided).
When the system is switched off, this is signalled by
the LED on the ASR OFF button lighting up and by a mes-
sage on the reconfigurable multifunction display (for ver-
sions/markets where provided).
Do not take unnecessary risks, even if your
vehicle is fitted with this system. Your dri-
ving style must always be suited to the road con-
ditions, visibility and traffic. The driver is ulti-
mately responsible for road safety.
WARNING
78
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 78

127KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CARWARNING LIGHTS
AND MESSAGESIN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
INJECTION SYSTEM FAILURE
(Multijet versions – amber)
EOBD ENGINE CONTROL SYSTEM
FAILURE (petrol versions – amber)
Injection system failure
Under standard conditions, when the ignition key is moved
to MAR, the warning light turns on and should go off af-
ter engine start-up.
The warning light staying on or turning on when travelling,
signal a fault in the supply/ignition system which could cause
possible lack of performance, poor handling and high con-
sumption levels.
On some versions the display shows the dedicated message.
Under these conditions, you may continue travelling at mod-
erate speed without demanding excessive effort from the en-
gine. Contact a Fiat Dealership as soon as possible.
EOBD ENGINE CONTROL SYSTEM FAILURE
Under standard conditions, when the ignition key is moved
to MAR, the warning light turns on and should go off after
engine start-up. The initial switching-on indicates that the
warning light is working properly. If the warning light ei-
ther stays on or comes on while travelling:
❒switched on steadily: it signals a failure in the supply/
ignition system which could cause high emissions at the
exhaust, possible lack of performance, poor handling
and high consumption levels.
On some versions the display shows the dedicated message. “DUALDRIVE” ELECTRIC POWER
STEERING FAILURE (red)
Turning the ignition key to MAR the warning light
turns on, but it should go off after a few seconds.
If the warning light stays on, you will not have the steer-
ing assistance and the effort on the steering wheel will be
increased, steering is still however possible. Contact a Fiat
Dealership.
On some versions the display shows the dedicated message.
g
INCOMPLETE DOOR LOCKING (red)
On some versions the warning light turns on when
one or more doors or the tailgate are not prop-
erly closed.
On some versions the display shows the dedicated message.
A buzzer will sound (for versions with reconfigurable mul-
tifunction display only) when doors are open and the car
is moving.
´
U
123-134 PANDA EN 7-10-2009 13:49 Pagina 127

128
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
INCOMPLETE DOOR LOCKING
(red)
On some versions the warning light turns on
when one or more doors or the tailgate are not
properly closed.
On some versions the display shows the dedicated message.
A buzzer will sound (for versions with reconfigurable mul-
tifunction display only) when doors are open and the car
is moving.
´
INJECTION SYSTEM FAILURE
(Multijet versions – amber)
EOBD ENGINE CONTROL SYSTEM
FAILURE (petrol versions – amber)
Injection system failure
Under standard conditions, when the ignition key is moved
to MAR, the warning light turns on and should go off af-
ter engine start-up.
The warning light staying on or turning on when travelling,
signal a fault in the supply/ignition system which could cause
possible lack of performance, poor handling and high con-
sumption levels.
On some versions the display shows the dedicated message.
Under these conditions, you may continue travelling at mod-
erate speed without demanding excessive effort from the en-
gine. Contact a Fiat Dealership as soon as possible.U
Under these conditions, you may continue travelling at
moderate speed without demanding excessive effort from
the engine. Prolonged use of the car with the warning light
on may cause damages. Contact a Fiat Dealership as soon
as possible. The warning light goes off if the failure disap-
pears, but it is still stored by the system.
❒flashing: it indicates the possibility of damage to the cat-
alytic converter (see “EOBD system” in section “Know
your vehicle”).
If warning light
v
flashes, contact a
Fiat Dealership as soon as possible to have
engine oil changed and instrument panel warning
light turned off.
WARNING
“DUALDRIVE” ELECTRIC POWER
STEERING FAILURE (red)
Turning the ignition key to
MAR
the warning light
turns on, but it should go off after a few seconds.
If the warning light stays on, you will not have the steer-
ing assistance and the effort on the steering wheel will be
increased, steering is still however possible. Contact
a Fiat Dealership.
On some versions the display shows the dedicated message.
g
123-134 PANDA EN 7-10-2009 13:49 Pagina 128

129KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CARWARNING LIGHTS
AND MESSAGESIN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
EOBD ENGINE CONTROL SYSTEM FAILURE
Under standard conditions, when the ignition key is moved
to MAR, the warning light turns on and should go off after
engine start-up. The initial switching-on indicates that the
warning light is working properly. If the warning light ei-
ther stays on or comes on while travelling:
❒switched on steadily: it signals a failure in the supply/
ignition system which could cause high emissions at the
exhaust, possible lack of performance, poor handling
and high consumption levels.
On some versions the display shows the dedicated message.
Under these conditions, you may continue travelling at
moderate speed without demanding excessive effort from
the engine. Prolonged use of the car with the warning light
on may cause damages. Contact a Fiat Dealership as soon
as possible. The warning light goes off if the failure disap-
pears, but it is still stored by the system.
❒flashing: it indicates the possibility of damage to the cat-
alytic converter (see “EOBD system” in section “Know
your vehicle”).
If the warning light flashes, it is necessary to release the ac-
celerator pedal to lower the speed of the engine until the
warning light stops flashing; continue the journey at mod-
erate speed, trying to avoid driving conditions that may
cause further flashing and contact Fiat Dealership as soon
as possible.
If, turning the ignition key to MAR, the
warning light Udoes not turn on or if it
turns on steadily or flashing when travelling
(on certain versions together with the message on
the display), contact a Fiat Dealership as soon as
possible. The operation of the warning light Umay
be checked by the traffic control authorities using
specific devices. Always comply with the traffic
regulations in force in the country where you are
driving.
123-134 PANDA EN 7-10-2009 13:49 Pagina 129