2009 FIAT PANDA 100HP Supplement Manual

8
FIAT PANDA 100HPfig. 9F0G0647m
If the car needs to be jacked up on one side, place the slot of the jack in correspon-
dence with the arrow (
O) on the side member: the finish under the floor is interrupted
A-fig. 9to enable fitting the jack on the groove fig. 9.
JACKING THE CAR
WITH THE JACKWITH ARM HOIST
fig. 10F0G0711m
If the car needs to be jacked up, go to a
Fiat Dealership which is equipped with
shop jacks and jack arms.
Jack up the car only by positioning the jack
arms or the shop jack in the points shown
in fig. 10.
When jacking the car using
shop jack or jack arms, make
sure the arms are not inter-
fering with the car side skirts.
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 8

9
FIAT PANDA 100HP
20 40 60 80 100 120 140 160 180
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●● ● ●
●●●●● ●●●●
●●●●● ●●●●
●
●● ● ●
●● ● ●
●●
SERVICE SCHEDULE
Service coupons shall be carried out every 20,000 km
Thousands of km
Check tyre conditions/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators,
hazard lights, boot lights, warning lights, etc.)
Check windscreen wiper/washer operation, adjust nozzles
Check windscreen/rear window blade position/wear
Check front disk brake pad conditions and wear
Check rear disk brake linings and wear
Sight inspect the conditions of:- bodywork, underbody protection
pipes and hoses (exhaust - fuel - brakes), rubber parts
(boots - sleeves - bushes - etc.)
Check cleanness of locks, bonnet and boot and lever
cleanness and lubrication
Check tension and adjust accessory drive belts
(excluding engines with automatic belt tighteners)
Sight inspect accessory drive belt conditions
Check and adjust handbrake lever stroke
Check antievaporation system
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 9

10
FIAT PANDA 100HP
20 40 60 80 100 120 140 160 180
●● ●
●● ●●●●●●●
●●
●
●●●●
●●●●
●●
●● ●●●●●●●
●● ●
●● ●●●●●●●
Thousands of km
Replace air cleaner cartridge
Top up fluids (engine coolant, brakes, windscreen washer,
battery, etc.)
Check timing belt conditions
Replace timing belt (*)
Change spark plugs
Check engine control system operation
(through diagnosis socket)
Check mechanical transmission oil level
Change engine oil and oil filter
Change brake fluid (or every 2 years)
Change pollen filter (or every year)
(*) Or every 4 years for particularly demanding use (cold climates, driving in the city, idling for a long time)
Or every 5 years, regardless of the km covered
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 10

11
FIAT PANDA 100HP
CHECKING FLUID
LEVELS
1.Engine oil - 2.Battery - 3.Brake fluid - 4.Windscreen washer fluid - 5.Engine coolant.
fig. 11F0G0713m
Be careful!, when topping up
take care not to confuse the
various types of fluids: they
are all incompatible with one
another and could seriously damage
the car.
Never smoke while working
in the engine compartment:
gas and inflammable vapours may be
present, with the risk of fire.
WARNING
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 11

12
FIAT PANDA 100HP
If the oil level is near or even below the
MINmark, add oil through the filler neck
A, until reaching the MAXmark.
Oil level shall never exceed the MAX
mark.
Use engine oil with specifications de-
scribed in paragraph “Fluids and Lubri-
cants” in section “Technical Specifications”
of the Owner Handbook this Supplement
is attached to.
ENGINE OIL CONSUMPTION
Max engine oil consumption is usually 400
grams every 1000 km.
When the car is new, the engine needs
to run in, therefore the engine oil con-
sumption can only be considered stabilised
after the first 5.000 ÷ 6.000 km.
IMPORTANT The oil consumption de-
pends on driving style and the conditions
under which the car is used.
IMPORTANT After adding or changing
the oil, let the engine turn over for a few
seconds and wait a few minutes after turn-
ing it off before you check the level. ENGINE OIL fig. 12
Check the oil level a few minutes (about
5) after the engine has stopped, with the
car parked on level ground.
The oil level shall be included between
marks MINand MAXon the dipstick B.
The gap between MINand MAXmarks
corresponds to about one litre of oil.
fig. 12F0G649m
Do not add oil with specifica-
tions other than that already
in the engine.
Used engine oil and filter con-
tain harmful substances for
the environment. Contact Fi-
at Dealership to have the oil
and filter changed, as they are
equipped to dispose of the waste oil
and filters respecting the nature and
the law.
When the engine is hot, take
care when working inside the
engine compartment to avoid burns.
Remember that when the engine is
hot, fan may cut in: danger of injury.
Scarves, ties and other loose cloth-
ing might be pulled by moving parts.
WARNING
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 12

13
FIAT PANDA 100HP
ENGINE COOLANT fig. 13
The coolant level shall be checked with
cold engine and shall be within the MIN
and MAXmarks on the tank.
If the level is low, pour slowly a mixture
of 50% distilled water and 50%
PARAFLU
UPof the FL SeleniaGroup
through the filler neck Auntil the level
reaches MAX.
A 50-50 mixture of PARAFLU
UPand
distilled water gives freeze protection to
–35°C.
fig. 13F0G0107m
The engine cooling system us-
es protective antifreeze fluid
PARAFLU
UP. Use the same flu-
id type as that already in the cooling
system when topping up. PARAFLU
UP
fluid cannot be mixed with any other
type of fluid. Should it happen, under
no circumstances start the engine; con-
tact a Fiat Dealership.
The cooling system is pres-
surised. If necessary, replace
the cap only with another genuine
one, otherwise system efficiency
could be compromised. Do not re-
move the reservoir cap when the en-
gine is hot: you risk scalding yourself.
WARNING
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 13

14
FIAT PANDA 100HP
ENGINE CODES - BODYWORK VERSIONS
Version Engine code Body version
Fiat Panda 100HP169A3000 169AXE1B 0H
ENGINE
GENERAL INFORMATION
Engine code
Cycle
Number and layout of cylinders
Piston bore and stroke mm
Total displacement cm3
Compression ratio
Maximum power (EEC) kW
HP
corresponding ratio rpm
Maximum torque (EEC) Nm
kgm
corresponding ratio rpm
Spark plugs
FuelFiat Panda 100HP
169A3000
Otto
4 in line
72 x 84
1368
11
73.5
100
6000
131
13.4
4250
NGK DCPR7E - N - 10
Unleaded petrol, 95 RON (Specification EN228)
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 14

15
FIAT PANDA 100HP
TRANSMISSION
Fiat Panda 100HP
Gearbox
Clutch
DriveSix forward gears and reverse with synchromesh for
forward gear engagement
Self-adjusting pedal without idle stroke
Front
BRAKES
Fiat Panda 100HP
Service brakes:
– front
– rear
Parking brake
IMPORTANT Water, ice and antifreeze salt on roads may deposit on the brake discs thus reducing braking efficiency at first braking. disc
disc
controlled by hand lever, it works on rear brakes
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 15