2009 Citroen C4 PICASSO Owner's Manual

180
XI
P R A C T I C A L I N F O R M A T I O N
Fuses under the dashboard
Access to the fuses

 Open the lower glovebox.

 Undo the screw by a quarter turn
and pivot the housing. Table of fuses

Fuse N° Rating Functions

F1 15 A Rear screen wipe

F2 30 A Locking and unlocking earth

F3 5 A Airbags and pretensioners

F4 10 A Multimedia, photochromic rear view mirror, particle
fi lter, diagnostic socket, air conditioning, manual
headlamp height adjustment

F5 30 A Front windows, front door electronics control pad,
panoramic glass roof

F6 30 A Rear windows

F7 5 A Interior lamps, refrigerated glovebox, radio

F8 20 A Multifunction screen, radio, steering wheel controls,
multimedia, defl ation detection, alarm, trailer

F9 30 A Multimedia, front 12 V sockets, torch, radio

F10 15 A Height corrector (suspension)

F11 15 A Brake switch, ignition switch

F12 15 A Parking assistance, automatic screen wipe and
lighting, passenger’s electric seat, lane departure
warning system, Hi-Fi amplifi er, trailer

F13 5 A Engine relay unit (BSM), driver’s electric seat

F14 15 A Air conditioning, Bluetooth
®
hands-free kit,
automatic gearbox lever, airbags, instrument panel

F15 30 A Locking and unlocking

F16 - SHUNT

F17 40 A Heated rear screen

181
XI
P R A C T I C A L I N F O R M A T I O N

Access to the second dashboard
fusebox

After any operation on the fuses
in the fusebox, check that the
fusebox cover is put back cor-
rectly for their protection. Table of fuses

Fuse N° Rating Functions

F29 20 A Heated seats

F30 - Not used

F31 40 A Trailer relay unit

F32 15 A Rear 12 V socket

F33 5 A Parking assistance, automatic screen wipe and
lighting, passenger’s electric seat, lane departure
warning system, Hi-Fi amplifi er

F34 5 A Trailer

F35 - Not used

F36 20 A Hi-Fi amplifi er

F37 10 A Air conditioning, light pack

F38 30 A Driver’s electric seat

F39 5 A Fuel fl ap

F40 30 A Passenger’s electric seat, panoramic glass roof

182
XI
P R A C T I C A L I N F O R M A T I O N
Fuses in the engine
compartment
Access to the fuses

 Detach and remove the cover.

After any operation, carefully re-
close the cover. If the cover is not
correctly positioned or not prop-
erly closed, this could cause seri-
ous problems on your vehicle. For
the same reason, take care not to
spill any liquid in the fusebox.
All work on the maxi-fuses,
which are located in these
fuseboxes and which give
extra protection, must be carried
out by CITROËN technicians.

183
XI
P R A C T I C A L I N F O R M A T I O N
Table of fuses
Fuse N° Rating
Functions

F1 20 A Engine management

F2 15 A Horn

F3 10 A Screen wash pump

F4 20 A Headlamp wash pump

F5 15 A Engine components

F6 10 A Xenon dual-function directional headlamps, automatic headla
mp height adjustment,
clutch switch, protection switch box (BCP)

F7 10 A Automatic gearbox, engine coolant level switch, power steering

F8 25 A Starter motor

F9 10 A Stoplamp switch

F10 30 A Engine components

F11 40 A Rear blower

F12 30 A Screen wipe

F13 40 A Built-in Systems Interface (BSI)

F14 30 A Air pump, heat exchange saver

F15 10 A Right-hand main beam

F16 10 A Left-hand main beam

F17 15 A Left-hand dipped beam

F18 15 A Right-hand dipped beam

F19 15 A Engine components

F20 10 A Engine components

F21 5 A Cooling fan relay

184
XI
P R A C T I C A L I N F O R M A T I O N
Fuses on the battery
After any operation, carefully re-
close the cover. If the cover is not
correctly positioned or not prop-
erly closed, this could cause seri-
ous problems on your vehicle. For
the same reason, take care not to
spill any liquid in the fusebox.
Table of fuses
Fuse N° Rating
Functions

F1 5 A Automatic gearbox actuator

F2 5 A Stop switch

F3 5 A Battery charge estimation ECU

F4 20 A ESP supply

F5 5 A ESP supply

F6 20 A ECU for 6-speed electronic gearbox/automatic gearbox
Access to the fuses

 Detach and remove the cover.
Fuses F1 to F6 are located on
the small board, clipped verti-
cally on the battery fusebox. Fuses
F7 to F12 are midi-
fuses. All work on these
fuses must be carried out
by CITROËN technicians.

185
XI
P R A C T I C A L I N F O R M A T I O N
BATTERY
Procedure for charging your battery
when it is fl at or for starting the en-
gine using another battery.
Access to the battery
The battery is located under the
bonnet.
To gain access to it:

 open the bonnet using the inte-
rior lever, then the exterior lever,

 secure the bonnet strut,

 remove the plastic cover to gain
access to the two terminals,

 unclip the fuse box to remove
the battery, if necessary.
Do not force the plate as locking
will not be possible of the clip is po-
sitioned incorrectly.
Start the procedure again. Starting using another
battery

 Connect the red cable to the
positive terminal (+) of the fl at
battery A , then to the positive ter-
minal (+) of the slave battery B .

 Connect one end of the green or
black cable to the negative ter-
minal (-) of the slave battery B .

 Connect the other end of the
green or black cable to an earth
point C on the broken down
vehicle.

 Operate the starter, let the en-
gine run.

 Wait until the engine returns to
idle and disconnect the cables.
Charging the battery using a
battery charger

 Disconnect the battery from the
vehicle.

 Follow the instructions for use
provided by the manufacturer of
the charger.

 Reconnect starting with the neg-
ative terminal (-).

 Check that the terminals and
connectors are clean. If they are
covered with sulphate (whitish or
greenish deposit), remove them
and clean them.
Disconnecting/Reconnecting
the cables

 Raise the locking plate 1 fully.

 Position the open clip of the ca-
ble on the positive (+) terminal of
the battery.

 Press vertically on the clip 2 to
position it correctly against the
battery.

 Lock the clip by lowering the
plate 1 .

186
XI
P R A C T I C A L I N F O R M A T I O N
The batteries contain harm-
ful substances such as sul-
phuric acid and lead. They
must be disposed of in accordance
with regulations and must not, in
any circumstances, be discarded
with household waste.
Take used remote control batteries
and vehicle batteries to a special
collection point.
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month.
Do not disconnect the ter-
minals while the engine is
running.
Do not charge the batteries without
disconnecting the terminals fi rst.
Do not push the vehicle to start the
engine if it is fi tted with a 6-speed
electronic gearbox system. Following reconnection of the
battery

Following reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to permit in-
itialisation of the electronic systems.
However, if slight diffi culties are en-
countered following this operation,
contact a CITROËN dealer.

Referring to the corresponding sec-
tion, you must yourself reinitialise:
- the remote control key,
-
the one-touch electric windows,
- the glass panoramic roof shutter,
- the settings of the multifunction screen,
- the audio equipment radio sta- tions,
- the GPS satellite navigation system.
Before disconnecting the
battery
Wait 2 minutes after switching off
the ignition before disconnecting
the battery.
Close the windows and the doors
before disconnecting the battery.
ENERGY ECONOMY MODE
System which manages the duration
of use of certain functions to con-
serve a suffi cient level of charge in
the battery.
After the engine has stopped, you
can still use functions such as the
audio and telematics system, wind-
screen wipers, dipped headlamps,
courtesy lamps, etc. for a maximum
combined duration of thirty minutes. Switching to economy mode

Once the thirty minutes are over, a
message appears on the multi-function
screen indicating that the vehicle has
switched to economy mode and the
active functions are put on standby.

If the telephone is being used at this
time:
- it will be maintained for 10 min- utes with your Audio system
hands-free kit,
- it will be maintained for 10 min- utes with the NaviDrive, then it
will transfer to your telephone
depending on its model.
Exiting economy mode
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, start the en-
gine and let it run for at least 5 min-
utes.
A fl at battery prevents the
engine from starting (refer
to the corresponding para-
graph).

186
XI
P R A C T I C A L I N F O R M A T I O N
The batteries contain harm-
ful substances such as sul-
phuric acid and lead. They
must be disposed of in accordance
with regulations and must not, in
any circumstances, be discarded
with household waste.
Take used remote control batteries
and vehicle batteries to a special
collection point.
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month.
Do not disconnect the ter-
minals while the engine is
running.
Do not charge the batteries without
disconnecting the terminals fi rst.
Do not push the vehicle to start the
engine if it is fi tted with a 6-speed
electronic gearbox system. Following reconnection of the
battery

Following reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to permit in-
itialisation of the electronic systems.
However, if slight diffi culties are en-
countered following this operation,
contact a CITROËN dealer.

Referring to the corresponding sec-
tion, you must yourself reinitialise:
- the remote control key,
-
the one-touch electric windows,
- the glass panoramic roof shutter,
- the settings of the multifunction screen,
- the audio equipment radio sta- tions,
- the GPS satellite navigation system.
Before disconnecting the
battery
Wait 2 minutes after switching off
the ignition before disconnecting
the battery.
Close the windows and the doors
before disconnecting the battery.
ENERGY ECONOMY MODE
System which manages the duration
of use of certain functions to con-
serve a suffi cient level of charge in
the battery.
After the engine has stopped, you
can still use functions such as the
audio and telematics system, wind-
screen wipers, dipped headlamps,
courtesy lamps, etc. for a maximum
combined duration of thirty minutes. Switching to economy mode

Once the thirty minutes are over, a
message appears on the multi-function
screen indicating that the vehicle has
switched to economy mode and the
active functions are put on standby.

If the telephone is being used at this
time:
- it will be maintained for 10 min- utes with your Audio system
hands-free kit,
- it will be maintained for 10 min- utes with the NaviDrive, then it
will transfer to your telephone
depending on its model.
Exiting economy mode
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, start the en-
gine and let it run for at least 5 min-
utes.
A fl at battery prevents the
engine from starting (refer
to the corresponding para-
graph).