2009 Alfa Romeo GT service

CAR MAINTENANCE
229
DIESEL FUEL FILTER
(diesel versions)
DRAINING CONDENSATION
WATER
The presence of water in
the supply circuit may
cause serious damage to
the entire injection system and
cause irregular running of the en-
gine. If the warning message +
symbol are shown on the recon-
figurable multifunction display con-
tact Alfa Romeo Authorized Ser-
vices as soon as possible to have
the system relieved. If warning in-
dications turn on after refuelling,
water has probably been poured
into the tank: turn the engine off
immediately and contact Alfa
Romeo Authorized Services.
AIR CLEANER
The air cleaner is connected to the tem-
perature and air flow sensors which send
to the control unit the electric signals need-
ed for correct operation of the injection and
ignition system.
It must therefore always be in perfect con-
ditions, to ensure correct operation of the
engine, low consumption and exhaust emis-
sion levels.
If the operations concern-
ing cleaner replacement de-
scribed below are not car-
ried out correctly and with the due
precautions, they may compromise
the travelling safety of the car. You
are recommended to have this op-
eration carried out by Alfa Romeo
Authorised Services.
If the car is habitually
used in dusty areas, the
cleaner should be replaced
at shorter intervals than those
specified in the Programmed Main-
tenance Schedule.
Any attempt to clean the
cleaner may damage it,
leading to serious engine
damage.

CAR MAINTENANCE
230
Incorrect fitting of electri-
cal accessories can serious-
ly damage the car. If after
buying the car, you wish to install
electric accessories (alarm, sound
system, radiotelephone, etc.) con-
tact Alfa Romeo Authorized Ser-
vices who will be able to suggest
the most suitable devices and
above all advise about the need to
use a more powerful battery.
BATTERY
The battery is of the “Limited mainte-
nance” type: under normal conditions of use
the electrolyte does not need topping up
with distilled water.
Contact Alfa Romeo Authorised Services to
have the battery checked/replaced.
fig. 14
A0A0224b
Batteries contain sub-
stances that are very harm-
ful for the environment. You
are advised to have the battery
changed at Alfa Romeo Authorized
Services, which are properly
equipped for disposing of used bat-
teries respecting nature and the law.
If the car is to remain sta-
tionary for a long time in
very cold weather, remove
the battery and take it to a warm
place, otherwise it might freeze.
POLLEN FILTER
Have the dust/pollen filter checked once
a year by Alfa Romeo Authorised Services,
preferably at the onset of summer.
If the car is mainly used in dusty or heav-
ily polluted areas, the filter should be
changed at more frequent intervals than
specified in the Scheduled Maintenance Pro-
gramme.
IMPORTANTThe failure to replace the
pollen filter can considerably reduce the ef-
fectiveness of the climate control system.
When doing any work on
the battery or near it, al-
ways wear special protec-
tive goggles.
The liquid in the battery is
poisonous and corrosive.
Avoid contact with eyes
and skin. Do not bring naked
flames or possible sources of
sparks near to the battery: risk of
fire and explosion.

CAR MAINTENANCE
231
– After charging, turn off the charger be-
fore disconnecting it from the battery.
– Re-connect the battery negative termi-
nal (–).
Never attempt to charge
a frozen battery: it must
firstly be thawed, other-
wise it may burst. If freezing has
occurred, the battery should be
checked before charging by spe-
cialised personnel, to make sure
that the internal elements are not
damaged and that the body is not
cracked, with the risk of leaking
poisonous and corrosive acid.CHARGING THE BATTERY
IMPORTANTThe battery charging pro-
cedure is described only for information pur-
poses. This operation should be carried out
by Alfa Romeo Authorised Services.
Charging should be slow at a low amp rat-
ing for 24 hours. Charging for a longer time
may damage the battery.
Charge the battery as follows:
– Disconnect the battery negative termi-
nal (–).
– Connect the charger cables to the bat-
tery terminal ensuring that the bias is cor-
rect.
– Turn on the charger.
CHECKING THE CHARGE
The battery charge may be checked
through the indicator A(where required)
set on the battery cover and acting accord-
ing to the colour the indicator shows.
Should the battery be not fitted with bat-
tery charge inspection device (optical elec-
trolyte indicator), inspection operations shall
be carried out by skilled personnel only.
Refer to the table below or to the label
(fig. 15) on the battery itself.Working with a low fluid
level may damage the bat-
tery irreversibly, even
causing it to burst.
Brilliantwhite colour
Dark colour
without green
area in the centre
Dark colour with green
area in the centre
Top up the electrolyte
Low charge level
Sufficient electrolyte
level and chargeContact Alfa Romeo
Authorised Services
Charge the battery
(you are advised to contact
Alfa Romeo Authorised Services)
No action
fig. 15
A0A0393b

CAR MAINTENANCE
232
Proceed as follows with doors closed:
1.open completely the driver’s window
keeping the button pressedfor at
least 3 seconds after full opening;
2.close completely the driver’s window
keeping the button pressedfor at
least 3 seconds after full closing;
3.proceed as described in points 1 and
2 also for the passenger’s side;
4.check for proper initialisation by oper-
ating the windows in automatic.
USEFUL HINTS TO EXTEND
THE LIFE OF YOUR BATTERY
To avoid rapidly draining the battery and
ensure that it continues to work correctly,
the following should be noted:
– The terminals must always be firmly
tightened.
– As far as possible, avoid keeping ser-
vices on for a long time with the engine
stopped (radio, hazard lights, parking lights,
etc.). IMPORTANTIf the battery is kept with
a charge of below 50% it is damaged by sul-
phation, its starting capability is reduced and
it is also more subject to the possibility of
freezing (this may occur already at -10 °C).
In the event of a prolonged inactivity, refer
to the paragraph “car inactivity”, in the
chapter “Correct use of the car”.
CHANGING
THE BATTERY
When changing the battery it should be re-
placed with another original one with the
same characteristics. If it is replaced by a
battery with different characteristics, the
maintenance intervals given in the Sched-
uled Maintenance Programme in this chap-
ter are no longer valid and for maintenance
it will be necessary to follow the battery
Manufacturer’s instructions.
IMPORTANTLacking power to control
units (e.g. battery change/disconnection
and replacement of power window control
unit protection fuses), window automatism
must be reset.– When leaving the car parked in a
garage, make sure that the doors, bonnet,
boot and interior lids are properly shut to
prevent lights from staying on.
– Before carrying out any work on the
electric system, disconnect the negative ca-
ble from the battery.
– If after buying the car, you wish to in-
stall electric accessories which require a per-
manent electric supply (alarm, voice feature,
radionavigator with satellite antitheft func-
tion etc.) or accessories that burden the elec-
tric system, contact Alfa Romeo Authorised
Services whose qualified personnel, in ad-
dition to suggesting the most suitable de-
vices belonging to Lineaccessori Alfa Romeo,
will evaluate the overall electric absorption,
checking whether the car’s electric system
is capable of withstanding the load required,
or whether it should be integrated with a
more powerful battery. In fact, as some of
these devices continue absorbing energy
even when the ignition key is off (car sta-
tionary, engine off), they gradually drain the
battery.

CAR MAINTENANCE
233
Incorrect pressure causes abnormal tyre
wear:
(A): normal pressure: tread evenly worn.
(B): low pressure: tread particularly worn
at the edges.
(C): high pressure: tread particularly worn
in the centre.
Tyres should be changed when the tread
thickness is reduced to 1.6 mm.
In any case follow local regulations.
You are also reminded that services with
high current absorption switched on by the
user, such as for example: baby bottle warm-
ers, vacuum cleaner, mobile phone, mini
fridge, etc., quicken the battery drain-
ing processif they are turned on with the
engine off or running at idle speed.
IMPORTANTWhen installing addition-
al systems on the car, bear in mind that im-
proper branches on connections of the car
wiring are dangerous, particularly if safety
devices are involved.
WHEELS AND TYRES
TYRE PRESSURE
Check the tyre pressure of every wheel, in-
cluding the spare, every two weeks and be-
fore a long journey. The pressure should be
checked with the tyre rested and cold.
It is normal for the pressure to increase
when the car is in use; for the correct tyre
inflation pressure, see “Wheels” in the
“Technical Specifications” chapter.
Battery
60 Ah
70 AhMaximum permissible
loadless absorption
36 mA
42 mA
The maximum absorption of all the ac-
cessories (standard and fitted afterwards)
should be 0,6 mA x Ah (of the battery), as
shown in the following table:
fig. 16
A0A0225b

CAR MAINTENANCE
236
HEADLIGHT WASHERS
(fig. 19)
Regularly check that the spray jets are in-
tact and clean.
If it is necessary to direct the jet, contact
an Alfa Romeo Authorized Service.
BODYWORK
PROTECTION FROM
ATMOSPHERIC AGENTS
The main causes of corrosion are:
– atmospheric pollution
– salty air and humidity (coastal areas, or
hot humid climates)
– seasonal environment conditions.
Not to be underestimated is also the abra-
sive action of wind-borne atmospheric dust
and sand and mud and gravel raised by oth-
er cars.
On your car, Alfa Romeo has implement-
ed the best manufacturing technologies to
effectively protect the bodywork against cor-
rosion.
fig. 19
A0A0704b
These include:
– Painting products and systems which
give the car particular resistance to corrosion
and abrasion.
– Use of galvanised (or pretreated) steel
sheets, with high resistance to corrosion.
– Spraying of the underbody, engine com-
partment, wheel arches and other parts with
highly protective wax products.
– Spraying of plastic parts, with a protec-
tive function, in the more exposed points:
underdoor, inner wheel arch linings, etc.
– Use of “open” boxed sections to pre-
vent condensation and pockets of moisture
from triggering rust inside.
CAR EXTERIOR AND
UNDERBODY WARRANTY
Your car is covered by warranty against
perforation due to rust of any original ele-
ment of the structure or body. For the gen-
eral terms of this warranty, refer to Alfa
Romeo Warranty booklet.

2.0 JTS
2.0 JTS
Selespeed
937A1000
Otto
4 in line
83 x 91
1970
11.5 : 1
121
165
6400
206
21
3250
NGK PFR6B
NGK BKR6EKPA
Unleaded
petrol
95 RON2.0 JTS (**)
932A2000
Otto
4 in line
83 x 91
1970
11.5 : 1
119
163
6400
201
20
3250
NGK PFR6B
NGK BKR6EKPA
Unleaded
petrol
95 RONJTD16V
937A5000
Diesel
4 in line
82 x 90.4
1910
17.5 : 1
110
150
4000
305
31
2000
Diesel fuel for motor
vehicles
(Specification EN 590) 3.2
V6
936A000
Otto
6 in 60° V
93 x 78
3179
10 : 1
176,5
240
6200
300
30.6
4800
NGK PFR6B
Unleaded
petrol
95 RON 1.8 T. SPARK
AR32205
Otto
4 in line
82.7
1747
11.5 : 1
103
140
6500
163
16.6
3900
NGK PFR6B+
NGK PMR7A
NGK BKR6EKPA+
NGK PMR7A
Unleaded
petrol
95 RON
TECHNICAL SPECIFICATIONS
242
ENGINE
(*) There are two different spark plugs for each cylinder, one per type (**) For versions/markets where applicable
To change plugs contact Alfa Romeo Authorized Services.
Code type
Cycle
Number and position of cylinders
Piston bore and stroke mm
Total displacement cm3
Compression ratio
Maximum horsepower (EEC):
kW
HP
at rpm
Maximum torque (EEC):
Nm
kgm
at rpm
Spark plugs (*)
Fuel

TECHNICAL SPECIFICATIONS
245
Service brakes:
– front
– rear
Parking brake
BRAKES
Front
Rear
Type
Turning radius
(between pavements) m
1.8 T. SPARK - 2.0 JTS - 3.2 V6 - JTD16V
rack and pinion with hydraulic power steering
11.5
SUSPENSION
STEERING SYSTEM
1.8 T. SPARK - 2.0 JTS - 3.2 V6- JTD16V
Disk
Disk
Controlled by hand lever, acting on the rear brakes
1.8 T. SPARK - 2.0 JTS - 3.2 V6 - JTD16V
quadrilateral system with stabiliser bar
Mc Pherson type