2009.5 Citroen C4 PICASSO DAG Owner's Manual

175
XI
P R A C T I C A L I N F O R M A T I O N
Main beam headlamps

Sidelamps

 Remove the rubber cover.

 Detach the clips by lowering
them on each side of the bulb.


Pull on the bulb-holder to remove it.

 Replace the faulty bulb.

 Push the bulb-holder back into
its housing.

 Reattach the clips.

 Refi t the rubber cover.
 Rotate the bulb-holder a quarter
turn anti-clockwise.

 Remove it from its housing.

 Replace the faulty bulb.

 Reposition the bulb-holder.

 Rotate it a quarter turn clockwise
to reposition in its housing. Direction indicators
The direction indicator bulb is located
underneath the main beam bulb.

 Remove the rubber cover.


Pull on the bulb-holder to remove it.

 Replace the faulty bulb.

 Reposition the bulb-holder in the
bracket and push it in.

 Refi t the rubber cover.

176
XI
P R A C T I C A L I N F O R M A T I O N
Integrated direction indicator
side repeaters
To change the repeater, press down-
wards fi rmly on the zone indicated
by the arrow, then pull the repeater.
Repeaters can be obtained from a
CITROËN dealer. Model with Xenon headlamps
and directional headlamps

1. Dual-function Xenon head-
lamps (dipped/main beam)

2. Additional main beams
(H7-
55 W
)

3. Sidelamps (H6 W-
6 W
)
(see previous page)

4. Direction indicators
(H21-
21 W
)
(see previous page) Dual-function Xenon headlamps
(dipped/main beam)
Additional main beams

 Remove the rubber cover.

 Rotate the bulb-holder a quarter
turn anti-clockwise and remove it
from its housing.

 Replace the faulty bulb.

 Reposition the bulb-holder by
pushing it in, tightening it by a
quarter turn clockwise.

 Refi t the rubber cover. If the headlamp bears this
symbol, any operation to
change the Xenon dual-
function directional head-
lamp (D1S-35 W) must be carried
out by professionals (risk of elec-
trocution).
Consult a CITROËN dealer.
It is recommended to change both
bulbs at the same time if one of
them is faulty.
When using a high-pres-
sure washer on persistent
marks, do not direct the jet
at the lamps or their edges for too
long, so as to avoid damaging their
protective coating and seals.

177
XI
P R A C T I C A L I N F O R M A T I O N
Front foglamps (H11-55 W)

 Insert the key in the notch A , tilt-
ing the bulb-holder cover, locat-
ed underneath the bumper, then
insert the key in the notch B to
remove it.

 Undo the lamp.

 Tilt the bulb-holder.

 Change the faulty bulb.

 Reposition the bulb-holder.

 Do up the lamp and refi t the bulb-
holder cover fi rmly in place.
 Pass your hand underneath the bumper to reach the bulb-holder.
 Rotate the bulb-holder a quarter turn.
 Pull on the bulb-holder.
 Rotate the bulb a quarter turn to remove it.
 Replace the faulty bulb.
 Fit the bulb.
 Reposition the bulb-holder by rotating it a quarter turn.
Rear foglamp (P21 W)

178
XI
P R A C T I C A L I N F O R M A T I O N
Rear lamps (C4 Picasso)

1. Direction indicators

(PY 21 W)

2. Stoplamps/sidelamps

(P21/5 W)

3. Reversing lamp
(P21 W )
 Identify the faulty bulb.

 With the boot open, press on the
plastic cover A , located close
to the lens, to release it from its
housing.

 Undo the two screws B on the
side of the lens and detach the
lamp by pulling it rearwards.

 Disconnect the connector linking
the lens unit with the tailgate.

 Remove the bulb-holder.

 Replace the bulbs.
To remove a bulb, rotate it a quarter turn.
To refi t the bulb, rotate it a quarter turn in the other direction.

 Reposition the bulb-holder.

 Reconnect the connector to the
lens unit.
Lamps mounted on the
bodywork

 Identify the faulty bulb.

 With the boot open, remove the
plastic cover on the tailgate.

 Remove the bulb-holder from its
housing.

 Replace the bulb.
To remove a bulb, rotate it a quarter turn.

To refi t the bulb, rotate it a quarter
turn in the other direction.

 Reposition the bulb-holder.

 Refi t the plastic cover.
Lamps mounted on the tailgate

 Refi t the lamp unit on the body
and do up the two screws.

 Reposition the plastic cover by
pressing on it.

179
XI
P R A C T I C A L I N F O R M A T I O N
Rear lamps
(Grand C4 Picasso)

1. Direction indicators
(PY 21 W)

2. Stoplamps (P21 W)

3. Reversing lamp (P21 W)

4. Sidelamps (diodes)
For this type of lamp, contact a CITROËN dealer. Changing bulbs

 Identify the faulty bulb.

 With the tailgate open, undo the
3 screws located on the side of
the lens unit and pull it rearwards
to detach.

 Disconnect the connector linking
the lens unit to the boot. Do not
disconnect the diodes.

 Remove the seal.

 Remove the bulb-holder.

 Replace the bulbs.
To remove a bulb, rotate it a quarter turn.
To fi t the bulb, rotate it a quarter turn in the other direction.

 Reposition the bulb-holder.

 Refi t the seal.

 Reconnect the connector to the
lens unit.

 Arrange the harness in the open-
ing provided in the body.

 Refi t the lens unit to the body
and fi t and tighten the 3 screws. Number plate lamps (W 5 W)

 Insert a thin screwdriver into one
of the external holes of the lens.

 Push it outwards to unclip it.

 Remove the lens.

 Change the faulty bulb.

180
XI
P R A C T I C A L I N F O R M A T I O N
Third brake lamp with bulb
(W 5 W)

 With the boot open, detach the
interior trim.

 Undo the nuts.

 Using a thin screwdriver, detach
the 3 retaining lugs.

 Remove the lamp via the exterior
of the tailgate.

 Remove the bulb-holder.

 Change the faulty bulb(s).
To refi t, carry out these operations in
reverse order.
Third brake lamp (diodes)
For the replacement of this type of
diode lamp, contact a CITROËN
dealer. Interior lighting
Interior lamp (1/W 5 W)
Detach the cover of the interior
lamp
1 with a thin screwdriver, close
to the button, to access the faulty
bulb.
Map reading lamps (2/W 5 W)
Detach the cover of the interior lamp.
To access the faulty bulb, detach the
partition for the reading lamp 2 con-
cerned, as necessary. Boot lamps (W 5 W)
Detach the unit by pushing it rear-
wards.
Torch (Krypton 3.6 V)

 Open the tab.

 Push with a fl at screwdriver
in the hole under the tab and
recover the bulb unit.

 Open the bulb unit fully to change
the bulb.

180
XI
P R A C T I C A L I N F O R M A T I O N
Third brake lamp with bulb
(W 5 W)

 With the boot open, detach the
interior trim.

 Undo the nuts.

 Using a thin screwdriver, detach
the 3 retaining lugs.

 Remove the lamp via the exterior
of the tailgate.

 Remove the bulb-holder.

 Change the faulty bulb(s).
To refi t, carry out these operations in
reverse order.
Third brake lamp (diodes)
For the replacement of this type of
diode lamp, contact a CITROËN
dealer. Interior lighting
Interior lamp (1/W 5 W)
Detach the cover of the interior
lamp
1 with a thin screwdriver, close
to the button, to access the faulty
bulb.
Map reading lamps (2/W 5 W)
Detach the cover of the interior lamp.
To access the faulty bulb, detach the
partition for the reading lamp 2 con-
cerned, as necessary. Boot lamps (W 5 W)
Detach the unit by pushing it rear-
wards.
Torch (Krypton 3.6 V)

 Open the tab.

 Push with a fl at screwdriver
in the hole under the tab and
recover the bulb unit.

 Open the bulb unit fully to change
the bulb.

181
XI
P R A C T I C A L I N F O R M A T I O N
CHANGING A FUSE
Procedure for replacing a faulty fuse
with a new fuse to rectify a failure of
the corresponding function.
There are two fuseboxes under the
dashboard, one fusebox in the en-
gine compartment and another on
the battery.
Changing a fuse
Before replacing a fuse, it is essen-
tial to fi nd the cause of the incident
and to have it rectifi ed. The fuse
identifi cation numbers are indicated
inside the fusebox.
Replace a blown fuse with one of the
same rating (the same colour). Use the special tool
A that is pro-
vided in the fuse housing fl ap, which
also contains spare fuses.

Correct Incorrect

Tool A

Access to the fi rst dashboard
fusebox
Fuses under the dashboard
Your vehicle's electrical
system is designed to oper-
ate with either standard or
optional equipment.
Before installing electrical equip-
ment or accessories on your vehi-
cle, consult a CITROËN dealer.
CITROËN declines all responsibil-
ity for the consequences and costs
that are caused by faults or repairs
on your vehicle resulting from the
installation of accessories that
are not supplied and/or not rec-
ommended by CITROËN and not
installed according to its instruc-
tions, particularly when the energy
consumption of all of the additional
accessories connected exceeds
10 milliamperes (Ma).