2008 SUZUKI GRAND VITARA light

Downloaded from www.Manualslib.com manuals search engine OPERATING YOUR VEHICLE
"ESP" Warning Light
ESP
66J031
When the ESP® systems (other than ABS) have a system malfunction, the "ESP" warning light in the instrument cluster comes on.
CAUTION
If the "ESP" warning light comes on,
or stays on while driving, there may
be a malfunction of the ESP® sys­tems (other than ABS). You should
have the systems inspected by an authorized SUZUKI dealer.
NOTE: When the "ESP" warning light comes on, or stays on while driving, indicating a mal­function of the ESp!Y systems (other than ABS), the brake system will function as an
ordinary ABS that has no additional ESp!Y functions.
NOTE: The information display shows the warning and indicator message when this light
comes on.
3-35
"ESP OFF" Indicator Light
ESP
OFF
66J032
You should turn the ESP® on during your
ordinary driving, so that you have the ben­efits of all of the ESP® systems.
It may be required to turn the ESP® sys­tems (other than ABS) off if your vehicle is stuck in sand, mud, or snow, or when driv­ing in extreme off-road conditions where wheel spin is necessary.
"ESP OFF" switch
(without hill descent control)
(1)
78K045
(with hill descent control)
'"'---+-( 1 )
78K046
(1) "ESP OFF" switch
When the
"ESP OFF" switch located at the
center of the instrument panel is pushed
and held
to turn off the ESP® systems
(other than ABS), the "ESP OFF" indicator
light in the instrument cluster comes on. When you push and hold the "ESP OFF" switch again, the "ESP OFF" indicator light will go out and all of the ESP® systems will be activated.
NOTE: • When the vehicle speed is greater than
approximately 30 kmlh (19 mph), the ESp!Y systems (other than ABS) will turn on automatically and the "ESP OFP' indicator light will go out. • When the transfer switch (if equipped) is turned to the "4L LOCK" position, the

Downloaded from www.Manualslib.com manuals search engine ES~ systems (other than ABS) will be
canceled to provide improved vehicle
traction, and the
~'ESP OFF" indicator
light will come on. When the transfer switch (if equipped) is
turned to the "4L LOCK" position, brake­
traction control can be activated. Brake­
traction control brakes the spinning
wheel to distribute drive power to the other wheels for increased climbing abil­
ity or for better performance on a rolling
hill or a slipe,ery surface .. • If the ESpE> systems operate continu­ously, such as when driving on slippery roads, the traction control functions of the ES~ systems may be canceled
temporarily to avoid overheating the brake pads, and the "ESP OFF" indicator
light will come on. After a short period of time, the ES~ systems (other than ABS) will turn on automatically and the "ESP OFF" indicator light will go out. • If your vehicle is equipped with a hill
descent control system and a hill hold
control system, these systems will not be
turned off
when the "ESP OFF" switch is pushed to turn off the ES~ systems.
E'::.F' OFF I-Qf - -a.'ND S\l',/IT'_ H V"/I)R~;',. I-6-t ONL ',' IN 4HL
79K084
NOTE: If, you push the "ESP OFF" switch when the transfer switch is in the "4H" position, the ES~ systems will not be turned off, and the message shown in the above illus­
tration will appear on the information dis­play. You should turn the transfer switch to the "4H LOCK" position to turn off the ES~ systems. Refer to "Using the Transfer Switch" in this section.
ABS Warning Light I Brake System
Warning Light
See 'Braking" in the "OPERATING YOUR VEHICLE" section.
OPERATING YOUR VEHICLE
Hill descent control System
(if equipped)
The hill descent control system is designed
to reduce the driver's workload when going
down steep, rough and/or slippery hills where the vehicle cannot decelerate enough by engine braking alone. The hill descent control system helps to control
vehicle speed by automatically engaging
the vehicle's brakes, as needed, so you can concentrate on steering the vehicle.
A WARNING
Do not rely excessively on the hill
descent control system. The hill
descent control system may not con­trol vehicle speed on a hill under all load or road conditions. Always be prepared to control vehicle speed by applying the brakes. Failure to pay
attention and control vehicle speed
using the brakes when necessary
may
result in loss' of control or an accident.
3-36

Downloaded from www.Manualslib.com manuals search engine OPERATING YOUR VEHICLE
H ill descent control switch
ff--+-(1)
79K051
(1) Hill descent control switch
To activate the hill descent control system: 1) Turn the transfer switch to the "4H LOCK" or "4L LOCK" position. 2) Shift the gearshift lever into a forward
gear or reverse gear.
3) Push the hill descent control switch (1) when the vehicle speed is under 25 km/
h (15 mph). The hill descent control
indicator on the instrument cluster will come on and the hill descent control
system will be activated.
If the transfer switch is in the "4H LOCK" position, vehicle speed is maintained at
approximately 1 0 km/h (6 mph) when
going down a hill. If the transfer switch is in the "4L LOCK" position, the vehicle speed is maintained at
3-37
approximately 5 km/h (3 mph) when going
down a hill. The brake/tail lights come on and the slip
indicator light blinks while the hill descent
control system applies the brakes to main­tain the vehicle speed. If the accelerator or brake pedal is
depressed while the hill descent control
system is activated, the system will stop
working temporarily. As soon as the
accel­erator or brake pedal is released, the hill descent control system begins to function
again if the hill descent control operating
conditions are fulfilled. However, when the
vehicle speed exceeds 25 km/h (15 mph),
the
hill descent control system will be deactivated automatically.
To deactivate the hill descent control sys­tem, push the hill descent control switch
again.
CAUTION
When the hill descent control system
is used continuously for a long time,
the temperature of the brake system
may increase and the hill descent
control system may be disabled
tem­porarily. The hill descent control indi­cator blinks to let you know the
system is disabled. Depress the
brake pedal and stop the vehicle
in a
safe place. When the temperature of
the brake system goes down, the hill
descent control indicator will come
on and the system is activated again.
NOTE: You may hear a sound coming from the engine when the hill descent control sys­tem is activated. This sound is normal and
does not indicate a malfunction.
Hill descent control Indicator Light
79K050
When the hill descent control system is
activated, the hill descent control indicator
comes on.
NOTE: If any of the following conditions occur when the hill descent control system is
activated, the hill descent control indicator
blinks.
• The transfer switch is in the "4H" or "N" position • The gearshift lever is in the "P" position • The gearshift lever is moved to the "N" position while driving • The vehicle speed exceeds 25 kmlh (15
mph)