Air conditioning with climate control*
152
>> Controls.
Setting the temperaturei
You should raise or lower the temperature
setting in small increments, preferably
starting at 70°F (21°C).
> Increasing or decreasing: Push tempera
ture control
6 up or down.
The selected temperature is set.
i
To achieve a lower temperature setting
more quickly, activate the air recirculation
mode (
page 153).
Adjusting air distributionYou can adjust the air distribution using air
distribution control
5.
The following symbols are found on the air
distribution control:>Turn air distribution control
5 to the
desired symbol.
The air distribution is controlled depending
on the position of the air distribution con
trol.
i
You can also turn the air distribution
control to a position between two symbols.
!
Do not turn the air distribution control
permanently to positionP. The air condi
tion switches on independently of other set
tings. The indicator lamp on switch
2 then
does not come on.
The vehicle’s fuel consumption increases and
the driving performance may be influenced.
Symbol
Function
P
Directs air to the windshield
and side windows
Y
Directs air to the footwells and
air distribution is reduced at
the center and side air vents
a
Directs air through the center
and side air vents
Driving instructions
>> Operation
215 Drive sensibly save fuel
Fuel consumption, to a great extent, depends
on driving habits and operating conditions.
To save fuel you should:
• Shift gears in a timely manner.
• Avoid frequent acceleration and decelera
tion.
• Keep tires at the recommended inflation
pressures.
• Remove carriers* when not in use.
• Remove unnecessary loads.
• Allow engine to warm up under low load use.
• Have all maintenance work performed at the
intervals specified in the Maintenance
Booklet and as required by the Maintenance
System. Contact an authorized smart cen
ter.
Fuel consumption is also increased by driving
in cold weather, in stopandgo traffic, on
short trips, and in hilly areas.
Catalytic converterYour smart is equipped with monolithictype
catalytic converter, an important element in
conjunction with the oxygen sensors to
achieve substantial control of the pollutants
in the exhaust emissions. Keep your vehicle in
proper operating condition by following our
recommended maintenance instructions as
outlined in your Maintenance Booklet.
G
Warning
The catalytic converter can become very
hot. Coming into contact with the catalytic
converter could result in burns.
Note the following:
• Do not remove the protective heat
guards.
• Do not apply any underseal.
• As with any vehicle, do not idle, park, or
operate this vehicle in areas where
combustible materials such as grass,
hay, or leaves can come into contact
with the hot exhaust system, as these
materials could be ignited and cause a
vehicle fire.
Rims and tires
298
>> Technical data.
!
Only use tires which have been tested and
approved by smart. Tires approved by smart
are developed to provide best possible
performance in conjunction with the driving
safety systems on your vehicle such as ABS
or ESP
®.
Using tires other than those approved by
smart may result in damage that is not
covered by the smart Limited Warranty.
!
Using tires other than those approved by
smart can have detrimental effects, such as
• poor handling characteristics
• increased noise
• increased fuel consumption
Moreover, tires and rims not approved by
smart may, under load, exhibit dimensional
variations and different tire deformation
characteristics that could cause them to come
into contact with the vehicle body or axle
parts. Damage to the tires or the vehicle may
be the result.
i
Further information on tires and rims is
available at any authorized smart center.
A placard with the recommended tire inflation
pressure is located on the driver’s door
Bpillar (
page 185).
The tire inflation pressure should be checked
regularly and should only be adjusted on cold
tires. Follow tire manufacturer’s maintenance
recommendation included with vehicle.
