Page 239 of 314
What to do if ...
238
>> Practical hints. Battery indicator lamp
Illuminates:
• when the ignition is switched on.
The indicator lamp goes out if the engine is
running.
If the Battery indicator lamp illuminates while
driving or does not go out after the engine is
started, the battery is no longer charged.
Possible causes:
• Alternator malfunctioning
• Broken polyVbelt>Stop the vehicle immediately in a safe
location.
>Do not continue to drive.
>Turn off the engine.
>Set the parking brake when leaving the
vehicle.
>Contact Roadside Assistance or an autho
rized smart center.
!
Among other possible causes, the
polyVbelt could be broken. Do not continue
to drive. Otherwise, the engine will overheat
due to an inoperative water pump which may
result in damage to the engine.Brake warning lamp (USA only)
Brake warning lamp (Canada only)
Illuminates:
• when the ignition is switched on.
Goes out:
• at least after 10 seconds
or
• after starting the engine.
Page 240 of 314
What to do if ...
>> Practical hints.
239
• with the parking brake set.
• if the brake circuit fails or the brake fluid
level in the brake fluid reservoir is too low.
>Stop the vehicle immediately in a safe
location.
>Do not continue to drive.
>Turn off the engine.
>Do not add brake fluid as this will not solve
the problem.
>Set the parking brake when leaving the
vehicle.
>Contact Roadside Assistance or an autho
rized smart center.
!
If you find that the brake fluid in the brake
fluid reservoir has fallen to the minimum mark
or below, have the brake system checked for
brake pad thickness and leaks.
• together with the ABS indicator lamp
(page 237) when the ABS system fails.
>Stop the vehicle immediately in a safe
location.
>Do not continue to drive.
>Turn off the engine.
>Set the parking brake when leaving the
vehicle.
• Contact Roadside Assistance or an autho
rized smart center.Combination low tire pressure/
TPMS malfunction telltale
Illuminates continuously:
• when the TPMS detects a loss of pressure in
at least one tire.
>Carefully bring the vehicle to a halt,
avoiding abrupt steering and braking
maneuvers. Observe the traffic situation
around you
.
>Check and correct tire inflation pressure
as required (
page 190).
G
Warning!
Driving with the brake warning lamp illu
minated can result in an accident. Have
your brake system checked immediately
if the brake warning lamp stays on.
Do not add brake fluid before checking
the brake system.
Page 242 of 314
What to do if ...
>> Practical hints.
241
Coolant temperature warning lamp
Illuminates:
• when the ignition is switched on.
The warning lamp goes out if the engine is
running.
• if the coolant is too hot.
>Stop the vehicle immediately in a safe
location.
>Do not continue to drive.
>Turn off the engine.
>Set the parking brake when leaving the
vehicle.
>Contact Roadside Assistance or an autho
rized smart center.If the coolant level has fallen below the
marking bar on the coolant reservoir
(
page 178):
>Add coolant as required.
>Have the coolant system checked for leaks
at an authorized smart center.
!
Among other possible causes, the
polyVbelt could be broken. Do not continue
to drive. Otherwise, the engine will overheat
due to an inoperative water pump which may
result in damage to the engine.
When the system detects a malfunction,
the telltale will flash for approximately
1 minute and then remain continuously
illuminated.
This sequence will continue upon subse
quent vehicle startups as long as the
malfunction exists. When the malfunction
indicator is illuminated, the system may
not be able to detect or signal low tire
pressure as intended.
TPMS malfunctions may occur for a vari
ety of reasons, including the installation
of incompatible replacement or alternate
tires or wheels on the vehicle that pre
vent the TPMS from functioning properly.
Always check the TPMS malfunction tell
tale after replacing one or more tires or
wheels on your vehicle to ensure that the
replacement or alternate tires and
wheels allow the TPMS to continue to
function properly.
G
Warning!
Driving when your engine is overheated
can cause some fluids, which may have
leaked into the engine compartment, to
catch fire. You could be seriously burned.
Turn off the engine, get out of the vehicle
and do not stand near the vehicle until
the engine has cooled down.
Page 243 of 314
What to do if ...
242
>> Practical hints. Engine malfunction indicator lamp
Illuminates:
• when the ignition is switched on.
Goes out:
• at least after 10 seconds if the engine elec
tronics are functioning properly
or
• after starting the engine.
If illuminated while driving:
>Have the vehicle checked at an authorized
smart center immediately.
i
Some states may by law require you to visit
a workshop as soon as the engine malfunction
indicator lamp comes on. Check local require
ments.Engine oil pressure indicator lamp
i
The engine oil pressure indicator lamp
indicates low engine oil pressure.
Check the engine oil level at regular intervals
(page 173).
Illuminates:
• when the ignition is switched on.
The indicator lamp goes out after starting
the engine and if there is sufficient engine
oil pressure.
If illuminated while driving:
>Stop the vehicle immediately in a safe
location.
>Do not continue to drive.
!
The engine oil pressure indicator lamp
should not be ignored. Extended driving with
the indicator lamp illuminated could result in
serious engine damage that is not covered by
the smart Limited Warranty.
>Turn off the engine.
>Set the parking brake when leaving the
vehicle.
>Contact Roadside Assistance or an autho
rized smart center.
Goes out:
• before the engine starts.
The indicator lamp has failed.
>Check the engine oil level.
>Have the system checked at an authorized
smart center.
Page 249 of 314
What to do if ...
248
>> Practical hints. Flashes at double frequency:
• if one of the turn signals is malfunctioning.
>Replace the bulb as soon as possible
(page 254).
or
>Have the turn signal checked at an autho
rized smart center as soon as possible.
EngineThe engine does not start:
>Check if
• the gear selector lever is in park
positionP,
• the brake pedal has been depressed,
• the transmission position indicator is on
or
.
The engine does not start within 4 seconds:
>Wait for a few seconds.
>Repeat the starting procedure.
Remember that extended starting attempts
can drain the vehicle battery.
The engine does not start after several
starting attempts:
>Set the parking brake when leaving the
vehicle.
>Contact Roadside Assistance or an autho
rized smart center.
Loss of keyIf you lose a key, you should do the following:
>Have the key deactivated at an authorized
smart center.
>Report the loss of the key to your car
insurance company immediately.
>If necessary have the mechanical lock
replaced.
Your authorized smart center will be glad to
supply you with a replacement following an
identity check.
Page 250 of 314
What to do if ...
>> Practical hints.
249 Acoustic warning signals
Door warning
A warning signal sounds if the door is opened
while a gear is engaged with the engine run
ning and neither the brake nor accelerator
pedals are depressed.
In addition a warning signal sounds if you
open the driver’s door with the key in the
starter switch position 0 to remind you not to
leave the key in the vehicle.Antitheft warning system*
Once the antitheft warning system has been
armed, a visual and audible alarm is triggered
when someone opens
• a door or the tailgate,
• when the vehicle's interior is entered,
• if there is motion inside the vehicle,
• if the vehicle is raised.
The alarm is also triggered if the passenger
door is unlocked with the key (
page 250).
To cancel the alarm:
>Insert the key in the starter switch.
>Turn starter switch in Position 1
(
page 91).
or
>Press button
©
or
ª
on the key.Seat belt reminder system
If seat belts are not fastened when the engine
is started, a warning chime will sound, for de
tails see seat belt telltale (
page 245).
Mechanical/acoustic brake pad indicator
The vehicle is equipped with a mechanical/
acoustic brake pad indicator. If you can hear
a continuous noise from the front axle when
braking, have the brake pads checked at an
authorized smart center.
Page 252 of 314
Unlocking/locking manually
>> Practical hints.
251 Closing the rear soft top
If the rear soft top does not lock properly
after being closed, proceed as follows:
>Stop the vehicle in a safe location.
>Set the parking brake.
>Make sure that the key in the starter switch
is turned to position1.
>Fold up the rear soft top completely.
The rear soft top stops in the unlocked
position.
>Within one minute, press and hold
symbol± on the retractable soft top
switch for 15 seconds twice.
The rear soft top closes the locking hooks.
>Close the retractable soft top completely.
>Have the rear soft top checked at an autho
rized smart center.
Page 256 of 314
Replacing bulbs
>> Practical hints.
255 Overview bulbs
Front lamps Rear lamps
P82.10483731
Lamp
Type
1
Turn signal lamp
PY 21 W
2
Low beam headlamp
H7 (55W)
3
Parking and side
marker lamp
WY 5 W
4
Front fog lamp*
H11
5
High beam headlamp
H7 (55W)
6
Side turn signal lamp
WY 5 W
Lamp
Type
7
Highmounted brake
lamp
W16W
8
Brake, tail, turn
signal, and
sidemarker lamp
12 V 21/5 W
9
Reflector
a
Backup lamp
12 V 21 W
b
License plate lamp
C5W
