2008 SKODA SUPERB technical data

Fuses and light bulbs247
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
WARNING
•Bulbs H7 and H3 are pressurised and may burst when changing the bulb
- risk of injury!
•It is recommended to wear gloves and eye protection when changing a
light bulb.
•Gas discharge bulbs* (xenon bulbs) op erate with a high voltage, profes-
sional knowledge is required - danger to life!
Caution
Do not take hold of the glass bulb with naked fingers (even the smallest amount of
dirt reduces the working life of the light bu lb). Use a clean cloth, serviette or some-
thing similar.
Note
This Owner's Manual only describes the replacement of bulbs where it is assumed
that no major complications wi ll arise. Other light bulbs should be changed by your
specialist garage.
Front headlight
Positions of the light bulbs in the front headlight ⇒fig. 217 .
Front headlightHalogen headlightXenon headlight
Low beam H7D1S
Main beamH3D1S, H3
Parking lightsW5W
Tu r n s i g n a l sPY 24W
Fog lightsH8
Rear light unitBulb
Reversing lightW16W
Tu r n s i g n a l sPY21W
Light bulb for the brake lights and tail
lightsW16W
Parking lightsW5W
Fog lightsP21W
OthersBulb
Licence plate lightC5W
front interior lightingW5W
3. Brake lightLED
Rear interior lightingW5W
Storage compartment light - front pas-
senger sideC3W
Footwell lightW5W
Luggage compartment lightW5W
Door warning lightW5W
Lighting for vanity mirrorC5W
Entry lightW5W
Fig. 217 Front headlight:
Installing the light bulbs
NKO B6 20.book Page 247 Wednesday, March 26, 2008 3:15 PM

Fuses and light bulbs249
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
– Replace the lamp, insert the connector with the new lamp and turn to
the right up to the stop.
– Insert the protective cover.
Note
We recommend that you have the headli ght setting checked by a Skoda Service
Partner after replacing the light bulb.
Fog lights
– Switch the ignition and all lights off. – Grasp the grille at the point marked with the arrow and take it out
⇒fig. 220 .
– Guide your hand into the opening in which the grille was located and
press the spring bolt ⇒fig. 221 .
– Take out the fog light.
– Turn the connector with the light bulb up to the stop towards the left and remove.
– Replace the lamp, insert the connector with the new lamp and turn to the right up to the stop.
– To re-insert the fog light, first of all place the fog light with the bolt on the side opposite the marking.
– Press into place the headlight onto the side facing the marking.
– FIrst of all put the grille in place on the side opposite the marking.
– Press into place the protective grille onto the side facing the
marking.
Rear light unitFig. 220 Front bumper:
Protective grille
Fig. 221 Remove front fog
lightFig. 222 Remove the outer
part of the rear light unit
NKO B6 20.book Page 249 Wednesday, March 26, 2008 3:15 PM

Fuses and light bulbs251
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Change bulbs in the outer part of the rear light unit
– To change a bulb, turn its fixture to the left up to the top and take it out.
– Now change the bulb, insert again the fixture with the bulb into the
housing and turn it to the right up to the stop.
Change bulbs in the inner part of the rear light unit
– To change a bulb of the rear light ⇒fig. 225 , pull the defective bulb
out of the fixture and insert a new one.
– To change the bulb of the rear fog light ⇒fig. 225 , turn the defec-
tive bulb to the left up to the stop and take it out.
– Press a new bulb into the fixture and turn the bulb to the right as far as the stop.
Fitting position of the bulbs in the outer rear light unit ⇒page 250, fig. 224 .
1 - Turn signal light
2 - Parking lights / Brake light
3 - Parking lights
Fitting position of the bulbs in the inner rear light unit ⇒fig. 225 .
1 - Reversing lights 2 - Rear fog light
Licence plate light
– Unscrew the glass cover of the light
⇒fig. 226 .
– Take the faulty bulb out of the fixture and insert a new one.
– Replace the the glass cover of the light and press it down to the stop - ensure that the glass cover is correctly installed.
– Screw the glass cover tight.
Fig. 225 Inner part of the
rear light unit: Lamps
A1
A2
Fig. 226 Rear bumper:
Licence plate light
NKO B6 20.book Page 251 Wednesday, March 26, 2008 3:15 PM

Fuses and light bulbs253
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
– Take the faulty bulb out of the fixture and insert a new one.
– Insert the light first of all on the side opposite the arrows ⇒page 252,
fig. 229 and press it in carefully until it locks in place.
Warning light in the doors and entry light
– Fold out the light in direction of arrow ⇒fig. 230 .
– Take the faulty bulb out of and insert a new one.
– First of all insert the light at the bottom and press in the upper part.
Fig. 230 Front door: Warning
light
NKO B6 20.book Page 253 Wednesday, March 26, 2008 3:15 PM

Technical Data255
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Technical Data
Technical Data
General information
The details given in the official vehicle registration documents always take prece-
dence over the details in th e Owner's Manual. Please refer to the official vehicle
registration documents or consult your Škoda Service Partner concerning the
engine with which your vehicle is equipped.
Used abbreviations
Performances
The listed performance values were de termined without performance-reducing
equipment, e.g. air conditioning system.
Weight
The loading capacity is reduced in line with the range of the special equipment. The
unloaden weight contains a fu el tank topped up to 90%.
Identification details
AbbreviationImportance
kWKilowatt, measuring unit for the engine output
rpmEngine revolutions per minute
NmNewton meter, measuring unit for the engine torque
CO2 in g/kmdischarged quantity of carbon dioxide in grams per driven kilom-
eter
RONResearch octane number, measur ing unit for the knocking resist-
ance of petrol
TSIFuel Stratified Injection
DPFDiesel particle filter
M55-speed manual gearbox
M66-speed manual gearbox
DQ66-speed automatic gearbox DSG
DQ77-speed automatic gearbox DSG
Fig. 231 Vehicle data sticker
NKO B6 20.book Page 255 Wednesday, March 26, 2008 3:15 PM

Technical Data
256
Vehicle data sticker
The vehicle data sticker ⇒page 255, fig. 231 is located on the floor of the luggage
compartment and is also stated in the Service schedule.
The vehicle data sticker co ntains the following data:
Vehicle identification number (VIN).
Vehicle type.
Gearbox code, paint number, interior equipment number, engine output,
engine code.
Partial description of the vehicle.
7GG - vehicles with DPF ⇒page 186.
Vehicle identification number (VIN)
The vehicle identification num ber - VIN (vehicle body number) is stamped into the
engine compartment on the right hand shoc k absorber dome. This number is also
located on a sign on the lower left hand edge below the windscreen (together with
a VIN bar code).
Engine number
The engine number is stamped into the engine block.
Type plate (production plate)
Is located on the left midd le pillar of the bodywork.
Homologation sign
The homologation sign is located on the lo ck carrier. Vehicles for certain countries
do not have an homologation sign.
Sticker on inside of fuel filler flap
The sticker is affixed to the inside of the fuel filler flap. The sticker contains the
following data:
•The prescribed types of fuel,
•Tyre si z e,
•Tyre pressure.
Fuel consumption according to the regulations
(99/100/EU)
Depending on the range of the special equipment, style of driving, traffic situation,
weather influences and vehi cle condition, the consumption values which in prac-
tice result when using the vehicle ca n deviate from the indicated values.
Urban traffic
The consumption measurement in urban traf fic begins with starting of the cold
engine. Afterwards the normal urban traffic is simulated.
Non-urban traffic
For the consumption measurement in non-ur ban traffic the vehicle, as in daily
motoring, is accelerated and braked several times in all gears. The vehicle speed
changes within the range from 0 to 120 km/h.
Combined traffic
The consumption value in the combined traf fic consists of 37% from the value for
the urban traffic and of 63% from the value for the non-urban traffic.
Note
•Please note that the information stated in the official vehicle registration
documents always takes priority.
A1
A2
A3
A4
A5
NKO B6 20.book Page 256 Wednesday, March 26, 2008 3:15 PM

Technical Data257
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Dimensions
Dimensions (mm)
Length4838
Width1817
Width including exterior mirror2009
Height1462/1482a)/1447b)
a)The value is valid for vehicles with rough road package.b)The value corresponds to the status with sport chassis.
Wheel base2761
Tr a c k g a u g e f r o n t / r e a r1545/1518
NKO B6 20.book Page 257 Wednesday, March 26, 2008 3:15 PM

Technical Data
258
1.8 ltr./118 kW TSI - EU 4
Engine
Performances
Fuel consumption (in ltr./100 km) and CO
2 emission (in g/km)
M6
Power outputkW per rpm118/5000 - 6200
Maximum torqueNm per rpm250/1500 - 4200
Number of cylinders/Displacement (cm3)4/1798
Fuel - unleaded petrol min. RON95
M6
Maximum speedkm/h220
Acceleration 0 - 100 km/hs8,6
M6
Urban10,4
Non-urban6,0
Combination7,6
CO2 emission - combination180
NKO B6 20.book Page 258 Wednesday, March 26, 2008 3:15 PM