2008 Seat Ibiza SC phone

Installation for mobile telephone with voice command system
38Control commandsThe control commands are used to carry out functions that have already been chosen.The control commands are used during or at the end of a dialogue to carry out
certain functions.
Possible commandsDial numberA telephone number can be vocally specified to the system and then dialled.– Press the talk button ⇒page 34, fig. 12 . Activation of the
system is confirmed with by a tone.
– After the tone, say the command DIAL NUMBER.
After this command the system will then request you to specify a telephone
number. A connection will then be estab lished to the specified number. The
telephone number can be specified all at once, in blocks of digits (separated
by a brief pause), or as single digits. You can specify the digits from zero to
Speech command
Effect
DIAL
Telephone number already entered is dialled.
STORE
A name is saved in the phonebook with its phone number
CANCEL
Cancels a running dialogue.
REPEAT
The specified name or all of the digits specified up to this point will be
repeated. The system will then give the cue so that you can
specify additional digits or commands.
CORRECTION
The specified name or the last entered block of digits will be deleted. The sys-
tem will then give the cue so that you can specify additional
digits or commands.
ERASE
All specified digits will be deleted. The system will then give the cue number is deleted. Please, proceed> so that you can specify new digits or com-
mands.
AC
Car stereo_EN.book Seite 38 Dienstag, 18. März 2008 4:15 16

Installation for mobile telephone with voice command system39
nine. After each block of digits you specify (separated by a brief pause) the
system will repeat the digits. The system can only recognise single digits
(two, three, etc.), and not combinations of digits (e.g. twenty-three). Notes on specifying telephone numbers:
•
If the telephone number has more than 20 digits, the system will decline
and give the cue .
•
A Plus (+) can also be placed ahead of the 20 digits.
Example for entering a telephone number:
A running dialogue can be cancelled at any time by pressing the talk button ⇒ page 34, fig. 12 .
Speech command
Condition
Message
Effect
DIAL NUMBER
Phone switched on

Dialogue
for example, ZERO, SEVEN, THREE,
ONE

Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.No command
back, or you can specify additional
digits>
Dialogue
THREE, NINE, TWO

Dialogue
DIAL

Dialogue -The telephone number
0731492 will be dialledEnd of dialogue
AC
Car stereo_EN.book Seite 39 Dienstag, 18. März 2008 4:15 16

Installation for mobile telephone with voice command system
40Redial– Press the talk button .
– After the tone, say the command REDIAL.
After giving the command the last number dialled via the hands-free system
will be dialled again.
Example for the REDIAL command:
A running dialogue can be cancelled at any time by pressing the talk button ⇒ page 34, fig. 12 .
To record names in the phone bookYou can store names along with a telephone number in the internal telephone book.– Press the talk button . The beep tone indicates that the system
is ready.
– After the tone, say the command STORE NAME.After giving the command the system will request you to specify a name and
telephone number to store in the internal telephone book. The telephone
book has enough memory for 50 names and numbers. You can specify the
digits from zero to nine .
The telephone number can be specified all at once, in blocks of digits (sepa-
rated by a brief pause), or as single digits. After each block of digits you
specify (separated by a brief pause) the system will repeat the digits. The system can only recognise single digits (two, three, etc.), and not combina-
tions of digits (e.g. twenty-three).
Say
STORE to store the entry into the telephone book.
AC
Speech command
Condition
Message
Effect
REDIAL
Phone switched on

DialogueEnd of dialogue
AC
AC
Car stereo_EN.book Seite 40 Dienstag, 18. März 2008 4:15 16

Installation for mobile telephone with voice command system41
A running dialogue can be cancelled at any time by pressing the talk button
⇒ page 34, fig. 12 .
Note
•
If the telephone number has more than 20 digits, the system will decline
and give the cue .
•
A Plus (+) can also be placed ahead of the 20 digits.
•
Say the command delete or back to delete or correct the corresponding
block of digits.
•
Say repeat to have all the digits that have been recognised up to that
point repeated.
•
If two or more names sound alike, it is better to save the names including
the first name or some other distinguishing entry.
•
A running dialogue can be cancelled at any time by pressing the talk
button .
•
The telephone book works only in conjunction with the hands-free speech
control system; the entries are not stored on the phone's SIM card.
Speech command
Condition
Message
Effect
STORE NAME
Telephone book is not full

Dialogue
COMPANY XYZ

Dialogue
COMPANY XYZ

Dialogue
ZERO, ONE, TWO, THREE

Dialogue
FOUR, FIVE, SIX

Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.No command
repeat, back, delete, or you can spec-
ify additional digits>
Dialogue
STORE

Dialogue - The name COMPANY XYZ
with the telephone number 0123456
will be storedEnd of dialogue
AC
AC
Car stereo_EN.book Seite 41 Dienstag, 18. März 2008 4:15 16

Installation for mobile telephone with voice command system
42Calling a name in the phone book– Press the talk button .
– After the tone, say the command SELECT NAME.
After the system has recognised this command, you may select a stored entry
from the telephone book to call the required number. The system best recog-
nises names spoken by the person who stored the name.
Example for selecting a name from the internal telephone book
A running dialogue can be cancelled at any time by pressing the talk button ⇒ page 34, fig. 12 .
AC
Speech command
Condition
Message
Effect
SELECT NAME
Phone is switched on, telephone book
contains entries.

Dialogue
COMPANY XYZ

Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.No command
back>
Dialogue
DIAL

Dialogue - The telephone number for
Company XYZ is being dialledEnd of dialogue
AC
Car stereo_EN.book Seite 42 Dienstag, 18. März 2008 4:15 16

Installation for mobile telephone with voice command system43
Listening to the phone bookYou can have the entries stored in the internal telephone book read out to you.– Press the talk button ⇒page 34, fig. 12 . The beep tone indi-
cates that the system is ready.
–Say the command PLAY PHONE BOOK.
After giving the command the system will read out the entries stored in the
phone book. If you press the talk button as an entry is being read, the
system will call the telephone number for that entry. Once the dialogue is
complete and the system is reactivated, you can also select an entry to call by
specifying the stored name.
Example for the PLAY PHONE BOOK command:
Example for selecting an entry:
To erase names from the phone bookYou can delete entries from the internal telephone book.– Press the talk button ⇒page 34, fig. 12 . The beep tone indi-
cates that the system is ready. – After the tone, say the command
DELETE NAME.
AC
AC
Speech command
Condition
Message
Effect
PLAY PHONE BOOK
The telephone book contains entries.
The telephone book will then be read
out.End of dialogue
Speech command
Condition
Message
Effect
PLAY PHONE BOOK
The telephone book contains entries;
the talk button is pressed as the
entry is being read out.

The selected name will be repeated.
The telephone number will be dialled.End of dialogue
AC
AC
Car stereo_EN.book Seite 43 Dienstag, 18. März 2008 4:15 16

Installation for mobile telephone with voice command system
44After giving this command you can delete a stored entry from the internal tele-
phone book.
Example for deleting single names from the internal telephone book:
A running dialogue can be cancelled at any time by pressing the talk button
⇒ page 34, fig. 12 .
Note
•
Say the command Repeat , if you would like to have the specified name
repeated by the system.
•
If you then say No, the system will answer with and the dialogue
will be ended.Speech command
Condition
Message
Effect
DELETE NAME
The telephone book contains entries.

Dialogue
COMPANY XYZ
pany XYZ?>
Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
Dialogue
No command
repeat, back>
Dialogue
YES

DialogueEnd of dialogue
AC
Car stereo_EN.book Seite 44 Dienstag, 18. März 2008 4:15 16

Installation for mobile telephone with voice command system45
To erase the phone bookYou can delete the entire phone book or single entries.– Press the talk button ⇒page 34, fig. 12 .
– After the tone, say the command DELETE PHONE BOOK .
After giving this command you can delete the entire internal phone book or
single entries as desired.
Example for deleting the entire internal telephone book:
Example for deleting single names from the internal telephone book:
AC
Speech command
Condition
Message
Effect
DELETE PHONE BOOK
The telephone book contains entries.
phone book?>
Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
Dialogue
No command

Dialogue
YES

Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
Dialogue
No command

Dialogue
YES

All entries in the phone book will be
deleted.End of dialogue
Speech command
Condition
Message
Effect
DELETE PHONE BOOK
The telephone book contains entries.
phone book?>
Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
Dialogue
No command
repeat>
Dialogue
Car stereo_EN.book Seite 45 Dienstag, 18. März 2008 4:15 16