PARKING DISTANCE CONTROL
Fault finding - Interpretation of statuses
87F
87F - 36V4 MR-372-J84-87F000$660_eng.mif
Vdiag No: 04-08
ET003
PARKING DISTANCE CONTROL FUNCTION
NOTESSpecial note: If the parking distance control system is suspended or deactivated, the
parking distance control switch indicator light comes on.
This status indicates whether the parking distance control system is on or off:
ET003: READY This means that, when reversing, the parking distance control detects obstacles
and the buzzer sounds (the parking distance control switch indicator light goes
out).
ET003:
DETECTINGThis information is displayed when in reverse gear and indicates that the parking
distance control has detected an obstacle.
ET003:
SUSPENDEDThis means the parking distance control system is switched off (no detection
possible). The suspension is temporary because the parking distance control
system will come back on after the ignition is switched off and on. To suspend or
reactivate the system manually, briefly press (1 second) the parking distance
control switch.
ET003:
DEACTIVATEDThis means the parking distance control system is switched off (no detection
possible). This suspension is permanent (switching the + after ignition off and on
again will not reactivate the system). To deactivate or reactivate the system
manually, press and hold (3 seconds) the parking distance control switch.
If the status is not as specified, check for an earth on track A2 of the parking distance control switch. Repair if
necessary.
With the ignition off, disconnect the parking distance control switch to check the insulation (against the earth
and + 12 V), continuity and absence of interference resistance in the following connection:
Laguna II ph2, Espace IV ph2, Vel-Satis ph2, Mégane II, Scénic II, Espace IV ph1 (1 connector),
Vel-Satis ph1 (1 connector), Clio III, Modus ph2:
Parking distance control switch connector
Track B1Parking distance control computer connector
Track 12
Repair if necessary
AFTER REPAIRRepeat the conformity check from the start.
AAP_V04_ET003/AAP_V08_ET003
PARKING DISTANCE CONTROL
Fault finding - Fault Finding Chart
87F
87F - 44V4 MR-372-J84-87F000$924_eng.mif
Vdiag No: 04-08
ALP2 No buzzer
NOTESOnly investigate this customer complaint after a full check using the diagnostic tool
(no faults must be present or stored).
Using the diagnostic tool Main Data screen, check
that the parking distance control system is on.
The status ET003 Parking distance control
function must be READY (and the red warning light
on the parking distance control switch must be off).
Is status ET003 READY?
YES
Is status ET001 "YES", with reverse gear
engaged?
YES
Using the diagnostic tool configuration readings
screen, check that the buzzer volume has not been
switched off (LC001 Buzzer volume should not be
ZERO)
Is the LC001 function ZERO
NO
NOTurn on the parking distance control by
pressing the switch for 1 or 3 seconds
(the red light should go out).
Note:
For more information concerning the
activation of the system, consult the
interpretation of status ET003 Parking
distance control.
NOApply the interpretation procedure for
status ET001
YESReconfigure the buzzer volume using the
diagnostic tool (command CF001 Buzzer
volume).
AFTER REPAIRCheck that the system is operating correctly.
AAP_V04_ALP2/AAP_V08_ALP2
