2008 Peugeot 407 C Dag display
[x] Cancel search: displayPage 112 of 211
8
101
Deactivation
Press button A to deactivate the sys-
tem (child asleep in the rear...). The in-
dicator light on the button comes on.
Note: this function will be de-
activated automatically when
a trailer is being towed (vehi-
c l e fi t t e d w i t h a t o w b a r r e c o m -
mended by PEUGEOT ).
Reactivation
Press button A again to reactivate the
system. The indicator light on the button
is switched off.
If there is an operating fault,
when reverse gear is en-
gaged, the indicator light
fl a s h e s , a c c o m p a n i e d b y a n
audible signal and a message on the
multifunction display.
Page 113 of 211
8
102
TYRE UNDER-INFLATION DETECTION
Sensors check the tyre pressure dur-
ing driving and trigger a warning in the
event of malfunction.
Pressure Check With the ignition on and the
vehicle having been stationary
for approximately 15 minutes,
and after the engine oil level,
this indicator light comes on
on the instrument panel screen to indi-
cate that the system is measuring the
tyre pressures.
Pressure OK
This indicator light comes
on on the instrument panel
screen if all of the tyre pres-
sure values measured are
correct.
If this indicator light does not appear,
contact a PEUGEOT dealer to have
the system checked. Puncture
This warning light, accom-
panied by the audible signal
and the message on the
multi-function display loca-
ting the wheel concerned, is
followed by illumination of the STOP
warning light.
Stop immediately, avoiding any sud-
den movement of the steering wheel
and the brakes.
Change the damaged wheel (punc-
t u r e d o r v e r y d e fl a t e d t y r e ) , a n d h a v e
the tyre pressure checked as soon as
possible.
Note: this message is also dis-
played when one of the wheels
is away from the vehicle (be-
ing repaired) or when one or
more wheels without a sensor
a r e fi t t e d . All repairs and changing of
t y r e s o n a w h e e l fi t t e d w i t h t h i s
system must be carried out by
a PEUGEOT dealer.
If, when changing a tyre, you install a
wheel which is not detected by your
vehicle, you must have the system
reinitialised by a PEUGEOT dealer.
T h e t y r e u n d e r - i n fl a t i o n d e t e c t i o n s y s -
tem is an aid to driving which does not
replace the need for the driver to be
vigilant or to drive responsibly.
This system does not eliminate the
need to have the tyre pressure checked
regularly (see manufacturer's label) to
ensure that the optimum dynamic per-
formance of the vehicle is maintained
and prevent premature wear of the
tyres, particularly in arduous driving
conditions (heavy load, high speed).
The tyre pressures must be checked
cold, at least once a month. Remember
to check the pressure of the spare
wheel.
T h e t y r e u n d e r - i n fl a t i o n d e t e c t i o n s y s -
tem may experience temporary inter-
ference due to radioelectric emissions
on a frequency close to that used by
the system.
Flat tyre
This warning light is accom-
panied by the audible si gnal
and the message on the
multi-function display loca-
ting the wheel concerned.
If this warning light comes on, have
the tyre pressure checked as soon as
possible. Sensor(s) not detected or faulty
This warning light is accom-
panied by the audible si gnal
and the message on the
multi-function display which
i n d i c a t e s t h a t u n d e r - i n fl a t i o n
detection is absent from one (or seve-
ral) wheel(s) or that there is a fault in
the system.
Contact a PEUGEOT dealer to replace
the faulty sensor(s).
Page 128 of 211
1010
115
Fuse N° Rating
Functions
F1 - Not used.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners control unit.
F4 10 A Automatic gearbox switch, diagnostic socket, electrochromatic mirror .
F5 30 A Driver and passenger electric windows.
F6 30 A Sunroof.
F7 5 A Glove box light, map reading lights, courtesy lights, court esy mirrors.
F8 20 A Multifunction display, audio equipment, top-of-column, trai
ler fuse box (accessory), alarm,
alarm siren.
F9 30 A Front lighter, 12 V rear socket, glove box light, map reading
lights, courtesy lights, courtesy
mirrors.
F10 15 A T y r e u n d e r - i n fl a t i o n d e t e c t i o n , C D c h a n g e r .
F11 15 A Diagnostic socket, ignition switch.
F12 15 A Trailer fuse box (accessory), parking assistance control unit supply,
passenger seat
memory unit, rain and brightness sensor.
F13 5 A Windscreen wipers relay control, engine fuse box.
F14 15 A Driver's seat memory unit, instrument panel, air bags and pre-tensi
oners control unit, air
conditioning control panel, steering wheel adjustment switch , hands-free kit.
F15 30 A Locking and deadlocking.
F16 - PARC shunt.
Page 131 of 211
1010
118
CHANGING A WINDSCREEN WIPER BLADE
ECONOMY MODE FUNCTION
After the engine has stopped, certain
electrical functions can be used for a
maximum duration of approximately
one hour, to prevent discharging of the
battery.
LOAD REDUCTION FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
heating system for passenger com-
partment of diesel vehicles, etc.) may
be switched off temporarily, depending
on the level of battery charge.
Reactivation of these functions is au-
tomatic, once the battery charge is
s u f fi c i e n t .
Note: at the risk of discharg-
ing the battery, the functions
that have been switched off
may be reactivated manually.
Note: if the telephone is being
used when economy mode
starts, it will still be possible to
fi n i s h t h e c a l l .
A fl a t b a t t e r y p r e v e n t s t h e e n -
gine from starting.
Replacing a blade
Lift the arm, then unclip the blade
and remove it.
Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk. Once the hour is over, a switching to
economy mode message appears on
the multi-function display and the ac-
tive functions are put on standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then be
approximately double the duration
for which the engine is left running.
However, this period will always be
b e t w e e n fi v e a n d t h i r t y m i n u t e s .
T h i s t i m e m a y b e s i g n i fi c a n t l y
reduced if the battery charge
is low.
Placing the wiper blades in the
maintenance position
Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades at the top of the windscreen
(maintenance position).
Page 144 of 211
1
2 0 2 0
8 8
9 9
5 5
4 4
3 3 2 2
1 9 1 9
1 6 1 61111
1010 1 8 1 8
1 2 1 2
6 6 7 7
1 3 1 3
1 5 1 5
1 4 1 4
1 7 1 7
01
131
1 . On/Off and Volume adjustment.
2 . Selection of the source: radio, Jukebox, CD, CD changer a n d a u x i l i a r y ( A U X , i f a c t i v a t e d o n t h e C o n fi g u r a t i o n m e n u ) . Long press: CD copy to hard disc.
3 . Audio option adjustments: front/rear, left/right balance, loudness, sound ambiences.
4 . Displaying of the list of local radio stations, of the tracks on the CD or of the MP3/Jukebox directories.Long press: updating of the local radio stations.
5 . Automatic search for a lower/higher frequency. Selection of the previous/next CD, MP3 or Jukebox t rack.
6 . Selection of the wavebands FM1, FM2, FMast, AM.
7 . T A ( T r a f fi c A n n o u n c e m e n t ) f u n c t i o n o n / o f f . L o n g p r e s s : a c c e s s t o t h e P T Y ( r a d i o P r o g r a m m e T Y p e s ) m o d e .
8 . Ejection of the CD.
9 . SIM card slot.
1 0 . Keypad for entering descriptions by successive presses.
1 1 . Access to the " PEUGEOT " services menu.
1 2 . S e l e c t i o n a n d c o n fi r m a t i o n .
1 3 . Selection of the previous/next CD. Selection of the previous/next MP3/Jukebox directory.
1 4 . Selection of a lower/higher frequency.
1 5 . Cancellation of the current operation. Long press: return to the current application.
1 6 . Displaying of the general menu.
1 7 . Deletion of the last character entered or of the entire line.
1 8 . M o d i fi c a t i o n o f t h e s c r e e n d i s p l a y . Long press: reinitialisation of the WIP Com audio a nd telematics system.
1 9 . Selection of the display on the screen from the m odes: TRIP, TEL, CLIM, NAV and AUDIO.
2 0 . Long press on the SOS button: emergency call.
FIRST STEPS
Page 145 of 211
0 2
132
G E N E R A L M E N U
MAP: orientation, details, display. AUDIO FUNCTIONS: radio, CD, Jukebox, options.
For maintenance of the display, the use of a soft, non-abrasive cloth ( s p e c t a c l e s c l o t h ) i s recommended without any additional product.
TELEMATIC: telephone, directory, SMS.
CONFIGURATION: vehicle, display, time, languages, voice, auxiliary s o c k e t ( A U X ) p a r a m e t e r s .
VIDEO: activation, parameters. VEHICLE DIAGNOSTICS: warnings log.
AIR CONDITIONING: on/off and dual zone control ( a c c o r d i n g t o e q u i p m e n t ) .
NAVIGATION GUIDANCE:GPS, stages, options.
TRAFFIC INFORMATION: TMC information, messages.
Page 152 of 211
11
2 2
3 3
4 4
5 5
6 6
7 7
0 3
139
Press the MENU button.
P r e s s t h e d i a l t o c o n fi r m t h e s e l e c t i o n .
Turn the dial and select the MAP function.
Turn the dial and select the MAP IN WINDOW or FULL SCREEN MAP tab.
Select OK and press the dial t o c o n fi r m .
P r e s s t h e d i a l t o c o n fi r m t h e s e l e c t i o n .
Turn the dial and select the DISPLAY MAP function.
D I S P L A Y I N G T H E M A P I N A W I N D O W O R
I N F U L L S C R E E N M O D E
GPS
D I S P L A Y M A P
F U L L S C R E E N M A P
OK
M A P I N W I N D O W
Page 155 of 211
11
2 2
3 3
4 4
6 6
5 5
7 7
0 4
142
Turn the dial and select the CONFIGURE MESSAGE ANNOUNCEMENT function.
Select the READ MESSAGES tab.
T h e T r a f fi c I n f o r m a t i o n M e s s a g e s w i l l be read by the voice synthesiser.
Select the NEW MESSAGE DISPLAY tab. T h e t r a f fi c i n f o r m a t i o n m e s s a g e s a r e e x t e n d e d t o t h e fi l t e r s s e l e c t e d ( g e o g r a p h i c . . . ) a n d c a n a l s o b e displayed when guidance is not active.
Press the MENU button.
N E W M E S S A G E D I S P L A Y
OK
C O N F I G U R I N G T H E T M C M E S S A G E
A N N O U N C E M E N T S
We recommend that you do not tick the NEW MESSAGE DISPLAY tab for r e g i o n s w i t h h e a v y t r a f fi c .
Turn the dial and select the TRAFFIC INFORMATION function.
P r e s s t h e d i a l t o c o n fi r m t h e s e l e c t i o n .
P r e s s t h e d i a l t o c o n fi r m t h e s e l e c t i o n .
T R A F F I C I N F O R M A T I O N
Select OK and press the dial to c o n fi r m .
R E A D M E S S A G E S
C O N F I G U R E M E S S A G E A N N O U N C E M E N T