FOLD FLAT FRONT PASSENGER SEAT (if so equipped)
Tofold thefront passenger’s seatbackflatfor
extra storage lengthwhentransporting long
items:
Slide theseat tothe rearmost position.Lift
up on the recline lever
, located on the
outside edge of the seat, and fold the seat-
back forward as far as it will go.
Lift up on the latch
located on the upper corner of the seatback to release the back
of the seat.
Once the seatback is released, it will enable you to fold the front passenger seatback flat
over the seat cushion.
FOLDING THE REAR BENCH SEAT (Crew Cab Model only)
FOLDING THE SEATBACK DOWN:
To fold therear bench seatback downtoaccess the
jacking tools, pull up on the straps
located on the
outer edgeofthe seatbacks andfoldtheseatback
forward.
FOLDING THE SEAT BASE UP
To fold therear bench seatbase uptoaccess the
under-seat storage bins:
Lift up on the lever
located on the side of the
seat, while lifting up the front of the seat cushion.
Repeat thisprocess toraise andsecure theseat
cushion on the other side of the vehicle. Fold the
bottom of the seat cushion toward the back of the
vehicle until it locks into place.
Repeat thisprocess toraise andsecure theseat
cushion on the other side of the vehicle.
UTILITY BED WITH SPRAY-ON BED LINER AND UTILI-TRACK™
SYSTEM (if so equipped)
The Utili-track™ channel system allows you to move
tie-down clampsinthe bed tothe best location to
secure a load.
The tie-down cleatsmustbeinstalled sothe
clamp isproperly seatedinthe notches inthe
rail. Ifthe tie-down cleatisnot seated inthe
notches, itwill not beflush withtherailand
cannot beproperly tightened. Thebolt inthe
center of the cleat must be tightened hand-tight
(20 – 40 inch pounds) .
13
