2008 MITSUBISHI SHOGUN turn signal

3-12 Instruments and controls
3
Indicator lamps
E00501600012
Turn-signal indication lamps/Hazard warning indication lamps
E00501700068
These indication lamps blink on and off when a turn-signal lamp is operating.NOTE●
If the blinking is too fast, a lamp bulb may be blown or a turn-signal connection may be false.
When the hazard warning lamp switch is pressed, all turn-signal lamps will flash on andoff continuously.High-beam indicator lamp
E00501800072
This indicator lamp illuminates when the highbeam is used.Front fog lamp indication lamp*
E00501900132
This indication lamp illuminates while the frontfog lamps are on.
Rear fog lamp indication lamp
E00502000084
This indication lamp illuminates while the rearfog lamp is on.Position lamp indication lamp
E00508900102
This lamp illuminates with the lamp switch at “ ” or “ ” position.Diesel preheat indica
tion lamp (diesel-
powered vehicles)
E00502300029
This indication lamp illuminates when the igni- tion switch is placed in the “ON” position. Asthe glow plug becomes hot, the lamp goes out and the engine can be started.NOTE●
If the engine is cold,
the diesel preheat indi-
cation lamp is on for a longer time.
●
When the engine has not been started within about 5 seconds after the diesel preheatindication lamp went out, return the ignition switch to the “LOCK” position. Then, turn the switch to the “ON” position to preheat the engine again.
●
When the engine is warm, the diesel preheat indication lamp does not come on even if the ignition switch is placed in the “ON” position.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
12 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-65
3
Turn-signal lever
E00506500771
NOTE●
If the lamp flashes unusually quickly, the bulb in a turn- signal lamp may have burned out. We recommend you to have the vehicle inspected.
●
It is possible to activate the following functions. For fur- ther information, we recommend you to consult a MIT- SUBISHI MOTORS Author
ized Service Point.
• Sounding of a buzzer as the turn-signal lamps flash• Flashing of the turn-signal lamps when the lever is oper- ated with the ignition switch in the “ACC” position • The turn signal-lamps 3-flash function for lane changescan be deactivated. • The time required to operate the lever for the 3-flash function can be adjusted.
1- Turn-signals
When making a normal turn, use position (1). The lever willreturn automatically when cornering is completed.
2- Lane-change signals
When changing lanes, use position (2). It will return to theneutral position when released.Also, when you move the lever to (2) slightly then release it,the turn-signal lamps and indication lamp in the instrumentcluster will flash 3 times.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
65 Wednesday, January 9, 2008 4:32 PM

3-66 Instruments and controls
3
Hazard warning flasher switch
E00506600440
Use the hazard warning flasher switch when the vehicle has to be parked on the road for any emergency. The hazard warning flashers can always be operated, regard-less of the position of the ignition key. Push the switch to turn on the
hazard warning flashers, all turn-
signal lamps flash continuously. To turn them off, push the switch again.NOTE●
It is possible for a buzzer to
sound with flashing of the
turn-signal lamps. For furt
her information, we recom-
mend you to consult a MITSUBISHI MOTORS Author-ized Service Point.
Fog lamp switch
E00506700047
Front fog lamp switch*
E00508300281
The front fog lamps illuminate only when the headlamps or taillamps are on. Push the switch to turn on the front fog lamps,and push the switch again to turn them off. The indication lamp in the instrument cluster will illuminate while the front fog lamps are on.LHD RHD
BK-BK2008E1ENUK.en-uk-Section6.fm Page
66 Wednesday, January 9, 2008 4:32 PM

5-28 For pleasant driving
5
RDS uses PI (program identification) signal and AF (alterna- tive frequency) list transmitted in addition to the normal FM broadcasting programs, and picks
up the FM stations that are
transmitting the same program from the AF list and automati-cally tunes to the station with the strongest signal intensity. Therefore, you can co
ntinue listening to one program in, for
example, a long dist
ance driving without retuning to the other
station transmitting the same
program when you are leaving
the service area of the cu
rrently receiving station.
The RDS radio also features th
e limited reception of the pro-
gram types, the break-in reception of the traffic announcement to the EON (enhanced other network) and emergency broad- cast, and the limited/
unlimited reception of
the regional pro-
grams.AF (Alternative Frequencies) function
E00720900090
The AF function finds a station broadcasting the same programand selects the station with the strongest signal of AF lists. The AF function is turned on at all times unless you manually switch it off. The AF function can be turned ON and OFF. Refer to “Adjusting the time” on page 3-19.CT (Clock Time) function
E00721000085
The clock can be set automatically
by using the signal from the
local RDS stations. Refer to “Adjusting the time” on page
3-19
.
REG (Regional) function
E00721100028
REG function limits to receive the stations broadcastingregional programs. Regional programming and regional networks are organizeddifferently depending on the country or area (they may be changed according to the hour, st
ate, or broadcast area), so if
you don’t want to receive the re
gional programs automatically,
you can set up REG ON not to
receive regional programs.
The REG function can be
turned ON and OFF.
Refer to “Function setup mode” on page 5-33.PI (Program Identification) search function
E00721200133
When travelling long distance a
nd the recalled preset station is
weak, the radio searches anot
her frequency broadcasting the
same programming with the same PI code in AF list. If there are no frequencies br
oadcasting the same program-
ming, the radio searches a frequency broadcasting the regionalprogramming. The radio succeeds in searching the regional programming, then the display shows the REG indicator (13). If the radio does not succeed
in searching the regional pro-
gramming, the radio returns to
the recalled preset station.
The PI function can be turned ON and OFF on some vehicles. Refer to “Function setup mode” on page 5-33.NOTE●
While searching, the audio sy
stem is muted. The display
shows “WAIT” or “SEARCH”.
BK-BK2008E1ENUK.en-uk-Section8.fm Page
28 Wednesday, January 9, 2008 4:41 PM

5-32 For pleasant driving
5
TP (Traffic information Program) search function
E00721800100
The traffic information program
search function is turned on
(with the TP indicator (14) shown on the display), if: ●
The RDS is off for 45 seconds due to a weak signal.
●
The station is changed to another station without a TP sig- nal and then 45 seconds elapse.
When turning on, 5 beeps will
be heard and a new TP station
will be searched for.
Emergency broadcasts
E00721700138
If an emergency broadcast is caught while receiving a FMbroadcast or playing back a
compact disc, the display will
show “ALARM” and the emergency broadcast will interrupt the current program. The volume level is set separately for lis- tening to normal audio programs and for listening to emer-gency broadcasts. The volume
level will therefore change
automatically to that set when
an emergency broadcast or traf-
fic information broadcast was la
st received. When the emer-
gency broadcast is over, the radio will return to the previously received program and to the corresponding volume level.
BK-BK2008E1ENUK.en-uk-Section8.fm Page
32 Wednesday, January 9, 2008 4:41 PM

For pleasant driving
5-53
5
RDS uses PI (program identifi
cation) signal and AF (alterna-
tive frequency) list transmi
tted in addition to the normal FM
broadcasting programs, and picks up the FM stations that are transmitting the same program from the AF list and automati-cally tunes to the station with the strongest signal intensity. Therefore, you can continue listening to one program in, for example, a long distance driving without retuning to the otherstation transmitting the same
program when you are leaving
the service area of the cu
rrently receiving station.
The RDS radio also features th
e limited reception of the pro-
gram types, the break-in receptio
n of the traffic announcement
to the EON (enhanced other network) and emergency broad- cast, and the limite
d/unlimited recep
tion of the regional pro-
grams.AF (Alternative Frequencies) function
E00720900104
The AF function finds a statio
n broadcasting the same program
and selects the station with th
e strongest signal of AF lists.
The AF function is turned on at all times unless you manually switch it off. The AF function can be turned ON and OFF. Refer to “Function setup mode” on page 5-57.CT (Clock Time) function
E00721000098
The clock can be set automatically by using the signal from thelocal RDS stations. Refer to
“Adjusting the time” on page
3-19
.
REG (Regional) function
E00721100015
REG function limits
to receive the stations broadcasting
regional programs. Regional programming and regional networks are organizeddifferently depending on the country or area (they may be changed according to the hour, state, or broadcast area), so if you don’t want to receive the re
gional programs automatically,
you can set up REG ON not to
receive regional programs.
The REG function can be turned ON and OFF. Refer to “Function setup mode” on page 5-57.PI (Program Identification) search function
E00721200146
When travelling long distance an
d the recalled preset station is
weak, the radio searches another frequency broadcasting the same programming with the same PI code in AF list. If there are no frequencies broadcasting the same program- ming, the radio searches a frequ
ency broadcasting the regional
programming. The radio succeeds
in searching the regional
programming, then the display shows the REG indicator (13). If the radio does not succeed
in searching the regional pro-
gramming, the radio returns to
the recalled preset station.
The PI function can be turned ON and OFF on some vehicles. Refer to “Function setup mode” on page 5-57.NOTE●
While searching, the audio sy
stem is muted. The display
shows “WAIT” or “SEARCH”.
BK-BK2008E1ENUK.en-uk-Section8.fm Page
53 Wednesday, January 9, 2008 4:41 PM

5-56 For pleasant driving
5
TP (Traffic information Program) search function
E00721800113
The traffic information program
search function is turned on
(with the TP indicator (14) shown on the display) If: ●
The RDS is off for 45 seconds due to a weak signal.
●
The station is changed to another station without a TP sig- nal and then 45 seconds elapse.
When turning on, 5 beeps will be heard and a new TP stationwill be searched for.
BK-BK2008E1ENUK.en-uk-Section8.fm Page
56 Wednesday, January 9, 2008 4:41 PM

6-16 For emergencies
6
2. With the snap pin (C) pushed, insert the inside handle
until it is locked.
How to change a tyre
E00801201757
Before changing a tyre, first stop your vehicle in a safe, flat location. 1. Park the vehicle on level and stable ground.2. Set the parking brake firmly. 3. On vehicles with manual transmission, turn the ignition
key to the “LOCK” position, move the gearshift lever tothe “R” (Reverse) position. On vehicles with automatic transmission, move the selec- tor lever to the “P” (PARK) position, turn the ignition keyto the “LOCK” position.
4. Turn on the hazard flashers an
d set up a warning triangle,
flashing signal lamp, etc., at an
adequate distance from the
vehicle, and have all your
passengers leave the vehicle.
BK-BK2008E1ENUK.en-uk-Section9.fm Page
16 Wednesday, January 9, 2008 4:46 PM