2008 MITSUBISHI GRANDIS belt

2-30 Seat and seat belts
2
3. Slide the second seats to the fully forward position.
(Refer to “To adjust forward or backward” on page 2-9.)4. Tip the seatbacks of the second seats backward.
(Refer to “To recline the seatback” on page 2-10.)
BK-XP08E1ENUK.en-uk.book Page 30 Monday, August 13, 2007 2:20 PM

Seat and seat belts
2-31
2
5. Tip the seatbacks of the third seats backward.
(Refer to “To recline the seatback” on page 2-17.)6. Move the front seats backward until they touch the second
seats. Lock them in that position. The flat seat configura-
tion is now complete.
To return the seats to their normal positions, reverse the
above procedure.
BK-XP08E1ENUK.en-uk.book Page 31 Monday, August 13, 2007 2:20 PM

2-32 Seat and seat belts
2
NOTE●You can store the head restraints (A) removed from the
second seat (except the middle seating position) by insert-
ing their rods between the tipped third seat and the wall of
the luggage area on the right side.●The head restraints (B) removed from the third seat and
the second seat (the middle seating position) can be fitted
together and stored in the cargo net in the luggage area.
BK-XP08E1ENUK.en-uk.book Page 32 Monday, August 13, 2007 2:20 PM

Seat and seat belts
2-33
2 Seat belts
E00404800593
To protect you and your passengers in the event of an accident,
it is the most important that the seat belts be worn correctly
when you drive.
The front seat belts have a pre-tensioner system. These belts
are used the same way as a conventional seat belt.
Refer to “Seat belt pre-tensioner system and force limiter sys-
tem” on page 2-39.
WARNING
!●Always place the shoulder belt over your shoulder
and across your chest. Never put it behind you or
under your arm.●One seat belt should be used by only one person.
Doing otherwise can be dangerous.●The seat belt will provide its wearer with maximum
protection if the recliner seatback is placed in fully
upright position. When the seatback is reclined,
there is greater risk that the passenger will slide
under the belt, especially in a forward impact acci-
dent, and may be injured by the belt or by striking
the instrument panel or seatbacks.●Seat belts should always be worn by every adult who
drives or rides in this vehicle, and by all children
who are large enough to wear seat belts properly.●Remove any twists when using the belt.●No modifications or additions should be made by the
user which will either prevent the seat belt adjusting
devices from operating to remove slack, or prevent
the seat belt assembly from being adjusted to
remove slack.●To reduce risk of serious or fatal injury in an acci-
dent, including the deploying driver air bag, the
driver should adjust the driver’s seat to the rear
most position that still allows good visibility and
good control of the steering wheel, the brake and
accelerator, and vehicle controls.
BK-XP08E1ENUK.en-uk.book Page 33 Monday, August 13, 2007 2:20 PM

2-34 Seat and seat belts
2
3-point type seat belt (with emergency locking
mechanism)
E00404900754
This type of belt requires no length adjustment. Once worn, the
belt adjusts itself to the movement of wearer, but in the event of
a sudden or strong shock, the belt automatically locks to hold
the wearer’s body.To fasten 1. Pull the seat belt out slowly while holding the latch plate.NOTE●When the seat belts cannot be pulled out in a locked con-
dition, pull the belts once forcefully and then return them.
After that, pull the belts out slowly once again.
2. Insert the latch plate into the buckle until a “click” is
heard.
WARNING
!●Never hold a child in your arms or on your lap when
riding in this vehicle, even if you are wearing your
seat belt. To do so risks severe or fatal injury to your
child in a collision or sudden stop.●Always adjust the belt to a snug fit.
BK-XP08E1ENUK.en-uk.book Page 34 Monday, August 13, 2007 2:20 PM

Seat and seat belts
2-35
2
3. Pull the belt slightly to adjust slackness as desired.To unfasten Hold the latch plate and push the button on the buckle.NOTE●As the belt retracts automatically, keep the latch plate held
while retracting so that the belt stows slowly. Failure to do
this could damage the vehicle.
Seat belt reminder/warning lamp
E00409800022
A tone and warning lamp are used to remind the driver and
front passenger to fasten the seat belt.NOTE●For the front passenger seat, the warning function works
only while a person is sitting on the seat.
WARNING
!●Never wear the lap portion of the belt across your
abdomen. During accidents it can press sharply
against abdomen and increase the risk of injury.●The seat belts must not be twisted when worn.
BK-XP08E1ENUK.en-uk.book Page 35 Monday, August 13, 2007 2:20 PM

2-36 Seat and seat belts
2
When the ignition key is turned to the “ON” position, the warn-
ing lamp will come on and a tone will sound for about 6 sec-
onds. If the front seat belt remains unfastened approximately
1 minute later, the warning lamp will flash and the tone sound
intermittently (each 12 seconds) when the vehicle is driven. If
the passenger subsequently unfastens the seat belt while driv-
ing, the warning lamp and tone will issue further warnings.
And if the seat belt remains unfastened, the warning lamp and
tone will issue further warnings each time the vehicle starts
moving from a stop. When the seat belt is fastened, the warn-
ings will stop. NOTE●When luggage is placed on the front passenger seat, a sen-
sor in the seat cushion may, depending on the weight and
position of the luggage, cause the warning tone to sound
and the warning lamp to come on.
Adjustable seat belt anchor (front seats)
E00405000433
The seat belt anchor height can be adjusted.
Move the seat belt anchor (A) down with the lock knob (B)
depressed. To move the anchor up, slide it without depressing
the lock knob.
WARNING
!●In order to reduce the risk of serious or fatal injury
in an accident, always wear your own seat belt. Do
not allow anyone to ride in your vehicle unless he or
she is also seated and wearing a seat belt. Children
should additionally be restrained in a secure child
restraint system.
WARNING
!●When adjusting the seat belt anchor, set it at a posi-
tion that is sufficiently high so that the belt will
make full contact with your shoulder but will not
touch your neck.●Adjust the shoulder belt anchor only when the vehi-
cle is not in motion.●Make sure the anchor is securely locked in position
after adjusting it.
BK-XP08E1ENUK.en-uk.book Page 36 Monday, August 13, 2007 2:20 PM

Seat and seat belts
2-37
2
Rear seat belt storage
E00405300045
When the second (except centre) and third seat belts are not in
use, store them as shown in the illustrations.
The openings in the front and rear of the holder (A) can be used
for storage.After passing the belt through the rear notch (B), insert the
plate into the front notch (C).
BK-XP08E1ENUK.en-uk.book Page 37 Monday, August 13, 2007 2:20 PM