2008 MITSUBISHI GRANDIS reset

3-2 Instruments and controls
3Instruments
E00500100137
Speedometer
E00500200154
Indication for km/hThe speedometer indicates the vehicle’s speed in kilometers
per hour (km/h).
1- Tachometer
2- Speedometer
3- Water temperature gauge
4- Fuel gauge
5- Daytime dipper button
6- Odometer/Tripmeter
7- Tripmeter reset button
BK-XP08E1ENUK.en-uk.book Page 2 Monday, August 13, 2007 2:20 PM

3-4 Instruments and controls
3
Odometer/Tripmeter
E00500600897
When the ignition key is turned to the “ON” position, odometer
and tripmeter indications are given.Odometer The odometer indicates the total distance the vehicle has trav-
elled.
TripmeterThe tripmeter indicates the distance travelled during a particu-
lar trip or period.
There are two tripmeter displays: TRIP and .
TRIP can be used to measure the distance travelled since
the current trip began. At the same time, TRIP can be used
to measure the distance from an intermediate location.
Every time the reset button (3) is pressed lightly (less than
1 second), tripmeter indications (TRIP and ) are
changed.
To reset the tripmeter
To return the display to “0”, press the reset button for more
than 1 second. Only the currently displayed value will be reset.
If TRIP is displayed, for example, only TRIP will be
reset.
1- Odometer
2- Tripmeter
3- Reset button
TRIP TRIP
BK-XP08E1ENUK.en-uk.book Page 4 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-5
3
NOTE●Display TRIP and each have a maximum distance
of 999.9 km (999.9 miles).
●Even when the ignition switch has been turned to the
“LOCK” position, pressing the tripmeter reset button
causes the odometer/tripmeter indication to appear for
approximately 30 seconds.
●When disconnecting the battery terminal for a long time,
the memory of tripmeter display TRIP and are
cleared, and the display returns to “0”.
Fuel gauge
E00500700481
The fuel gauge indicates the fuel level in the fuel tank when the
ignition switch is “ON”.Fuel lid markThe fuel lid mark (A) indicates that the fuel tank filler door is
located on the left side of the vehicle (Refer to “Filling the fuel
tank” on page 3).1- Full
0- Empty
CAUTION
!●For petrol-powered vehicles, do not drive with an
extremely low fuel level; running out of fuel could
cause damage to the catalytic converter.
BK-XP08E1ENUK.en-uk.book Page 5 Monday, August 13, 2007 2:20 PM

3-20 Instruments and controls
3
Manual modeThe manual mode is also available in case the “Automatic
mode” shows the incorrect time when the adjacent local RDS
stations are located in a different time zone. Refer to “Radio
data system (RDS)” on page 5-29.
Set the time by pressing the various buttons as described
below.
Outside temperature
E00503900019
This value shows the outside temperature of the vehicle.
If the outside air temperature drops below approx. 3 °C, the
alarm sounds and the outside air temperature figure flashes for
about 10 seconds.
H- To adjust the hour
M- To adjust the minutes
SET- To reset the minutes to zero
10:30-11:29...Changes to 11:00
11:30-12:29...Changes to 12:00
CAUTION
!●There is a danger the road might be icy, even when
the outside air temperature figure is not flashed, so
please take care when driving.
BK-XP08E1ENUK.en-uk.book Page 20 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-23
3
Average fuel consumption
E00509300060
This value shows the average fuel consumption (in L/100 km,
km/L or mpg).NOTE●When the ignition switch is turned on, the average fuel
consumption which was being displayed when the igni-
tion switch was previously turned off will be displayed
once again.
●Average fuel consumption varies according to the condi-
tions under which a vehicle is travelling (road conditions,
the manner in which the vehicle is being driven, etc.).
Observe this display for reference because the fuel con-
sumption display may differ from the actual fuel con-
sumption.To r e s e t t h e d i s p l a y
You can switch from the automatic reset mode to the manual
reset mode by performing the following operations:
1. Press and hold down button (A), then press the “SET”
button (B) within 1 second, and a buzzer will sound and
the reset mode will be changed.
BK-XP08E1ENUK.en-uk.book Page 23 Monday, August 13, 2007 2:20 PM

3-24 Instruments and controls
3
2. The name of the newly selected mode will flash, then the
display will return to its original indications.3. The status of the selected mode will be shown on the dis-
play.
1- Automatic reset mode
2- Manual reset mode
or
BK-XP08E1ENUK.en-uk.book Page 24 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-25
3
●Automatic reset mode
When 4 hours have passed after the ignition switch is
turned to the “OFF” or “ACC” position, the display is
automatically reset. It then shows “---”.
●Manual reset mode
If you reset the display at the time when you want to start
the measurements, average fuel consumption from that
point of time can be displayed.
Push the “DISP” button for more than 5 seconds.NOTE●While the ignition switch is in the “ON” position, the
automatic reset mode is permanently selected. If you wish
to make continuous measurements, select the manual
mode.
Driving range
E00509400016
This value shows the distance (in km or miles) that can be
driven on the fuel remaining in the fuel tank.
BK-XP08E1ENUK.en-uk.book Page 25 Monday, August 13, 2007 2:20 PM

3-26 Instruments and controls
3
NOTE●If the driving range drops below 50 km (30 miles) while
the driving range is displayed, the display shows “---”.
When this occurs, top up the fuel tank as soon as possible.
●The driving range varies depending on road conditions,
the manner of driving and other related factors. Conse-
quently, the display should be used only as a guide. It is
recommended to add fuel as soon as the low fuel warning
lamp in the instrument cluster illuminates.
(Refer to “Low fuel warning lamp” on page 3-6.)
●Refueling will update the driving range indication.
●The driving range displayed is based on previous fuel con-
sumption data. Disconnecting the battery cable will result
in the deletion of existing fuel consumption data, which
will affect the unit’s calculations.
●The driving range figure can occasionally increase if the
vehicle is stopped on an incline. This is because the fuel
has moved in the tank because of the incline and is not
considered as a fault.
Average speed
E00509500062
This value shows the average speed (in km/h or mph) since the
display was reset. Refer to “To reset the display” on page 3-23.
BK-XP08E1ENUK.en-uk.book Page 26 Monday, August 13, 2007 2:20 PM