Page 382 of 401

Service products and capacities
379
!
Do not use petrol to refuel vehicles with a
diesel engine. Do not use diesel to refuel
vehicles with a petrol engine. Never mix
diesel with petrol. Even small amounts of
the wrong fuel result in damage to the
injection system. Damage resulting from
adding the wrong fuel is not covered by the
warranty.
More information about refuelling and fuels
can be found in the "Operation" section. Introduction to fuel consumption
The vehicle will use more fuel than usual in
the following situations: R
at very low temperatures
R in urban traffic
R on short trips
R when towing a trailer
R in mountainous terrain
The consumption figures have been deter-
mined in accordance with EU Directive 80 /1 268 /EEC test conditions.
i Only for certain countries: the current
consumption and emissions values of your
vehicle can be found in the COC papers
(EC-CERTIFICATE OF CONFORMITY). These
documents are supplied when the vehicle
is delivered.
! Do not use any special additives, as they
can cause malfunctions and engine dam-
age. Damage resulting from the use of such
additives is not covered by the Mercedes-
Benz warranty. H
Environmental note
CO 2(carbon dioxide) is the gas which sci-
entists believe to be principally responsible
for global warming (the greenhouse effect).
Your vehicle's CO 2emissions are directly
related to fuel consumption and therefore
depend on:
R efficient use of the fuel by the engine
R driving style
R other non-technical factors, such as envi-
ronmental influences or road conditions
You can minimise your vehicle's CO 2emis-
sions by driving carefully and having it serv-
iced regularly. Technical data
211_AKB; 2; 5, en-GB
mkalafa
,V ersion: 2.9.4
2008-02-29T16:57:07+01:00 - Seite 379 ZDateiname: 6515_3416_02_buchblock.pdf; preflight
Page 388 of 401

Service products and capacities
385Automatic trans-
mission* E 320 CDI E 320 CDI 4MATIC E 420 CDI
Urban Saloon 10.3 – 10.6 l/100 km 10.5 – 10.7 l/100 km 13.2 l/100 km
Estate 10.6 – 11.0 l/100 km 11.0 – 11.6 l/100 km –
Extra-urban Saloon 5.6 – 6.0 l/100 km 6.4 – 6.6 l/100 km 7.0 l/100 km
Estate 5.9 – 6.4 l/100 km 6.8 – 6.9 l/100 km –
Overall (NEDC) Saloon 7.3 – 7.6 l/100 km 7.9 – 8.1 l/100 km 9.3 l/100 km
Estate 7.6 – 8.1 l/100 km 8.3 – 8.6 l/100 km –
CO
2emissions Saloon 194 – 202 g/km 210 – 215 g/km 246 g/km
Estate 202 – 215 g/km 220 – 228 g/km –
Engine oil
A list of engine oils tested and approved in accordance with the Mercedes-Benz Specifications for Service Products is available from any
Mercedes-Benz Service Centre. Approval by Mercedes-Benz is also often indicated by the MB Sheet Number on the oil container. The table
shows which MB Sheet number applies to which engine: Technical data
* optional
211_AKB; 2; 5, en-GB
mkalafa,
Version: 2.9.4 2008-02-29T16:57:07+01:00 - Seite 385 ZDateiname: 6515_3416_02_buchblock.pdf; preflight
Page 389 of 401

Service products and capacities
386 E 200
KOMPRESSOR E 230 E 280
E 280
4MATIC E 350
E 350
4MATIC
E 350 CGI E 500
E 500
4MATIC E 63 AMG
MB Sheet number 229.3/229.31
229.5/229.51 229.3/229.5 229.3/229.5 229.3/229.5 229.3/229.5
229.5
68 E 200 CDI E 220 CDI E 280 CDI
E 280 CDI
4MATIC E 320 CDI
E 320 CDI
4MATIC E 420 CDI
E 300 Bluetec MB Sheet number
With a diesel partic-
ulate filter 228.51/229.31/
229.51 228.51/229.31/
229.51 228.51/229.31/
229.51 228.51/229.31/
229.51 228.51/229.31/
229.51 MB Sheet number
Without a diesel
particle filter
69 228.3/228.5/
228.51/
229.3/229.31/ 229.5/229.51 228.3/228.5/
228.51/
229.3/229.31/ 229.5/229.51 228.3/228.5/
228.51
229.3/229.31/ 229.5/229.51 228.3/228.5/
228.51
229.3/229.31/ 229.5/229.51 —
i
In the event that the: R
engine oil brand
R grade (MB Sheet number)
R SAE classification (viscosity) corresponding to the oil used in your engine
is not available, you can use a different
mineral or synthetic engine oil approved by
Mercedes-Benz.
68 Restriction: only SAE XW-40 engine oils may be used.
69 Only for certain countries. Technical data
211_AKB; 2; 5, en-GB
mkalafa,
Version: 2.9.4 2008-02-29T16:57:07+01:00 - Seite 386Dateiname: 6515_3416_02_buchblock.pdf; preflight
Page 390 of 401

Service products and capacities
387
Mixing oils reduces the benefits of high-
grade engine oil.
! Do not use lubricant additives, since they
lead to increased wear and damage to the mechanical assemblies. The use of lubri-
cant additives limits warranty claims.
!
Engine oils for vehicles without a diesel
particle filter may also be used temporarily
in vehicles with a diesel particle filter if the
engine oil listed is not available. You must
then have an oil change carried out as soon
as possible.
Capacities The following values refer to an oil change including the oil filter.
Engine with oil filter E 200
KOMPRESSOR E 230
E 280
E 280 4MATIC E 350
E 350 4MATIC E 350 CGI E 500
E 500 4MATIC E 300 Bluetec E 63 AMG
Replacement amount 5.5 l 8.0 l 8.5 l 8.8 l
Engine with oil filter E 200 CDI
E 220 CDI E 280 CDI 4MATIC
E 320 CDI 4MATIC E 280 CDI
E 320 CDI E 420 CDI
Replacement amount 6.5 l 8.5 l 8.5 l 10.5 lTechnical data
211_AKB; 2; 5, en-GB
mkalafa,
Version: 2.9.4 2008-02-29T16:57:07+01:00 - Seite 387 ZDateiname: 6515_3416_02_buchblock.pdf; preflight
Page 391 of 401

Service products and capacities
388 Coolant
The coolant is a mixture of water and anti-
freeze/corrosion inhibitor. It performs the
following tasks:
R anti-corrosion protection
R antifreeze protection
R raising the boiling point
i When the vehicle is first delivered, it is
topped up with a coolant that will ensure
adequate antifreeze and corrosion protec-
tion.
! Only top up with coolant that has been
premixed with the desired quantity of anti-
freeze protection. You could otherwise
damage the engine.
There is more information about coolant
and topping it up on Mercedes-Benz Spec-
ifications for Service Products Sheet
310.1.
! Always use a suitable coolant mixture,
even in countries where high temperatures
prevail.
Otherwise, the cooling system will not be
sufficiently protected from corrosion, and
the boiling point will be too low. If antifreeze/corrosion inhibitor is present in
the correct concentration, the boiling point of
the coolant will be around 130 °C.
The antifreeze/corrosion inhibitor concentra-
tion in the cooling system should:
R
be at least 50%. This will protect the cooling
system against freezing down to around –
37 °C.
R not exceed 55% concentration (antifreeze
protection down to –45 °C), otherwise heat
will not be effectively dissipated.
If the vehicle has lost coolant, top it up with
equal amounts of water and antifreeze/cor-
rosion inhibitor. Mercedes-Benz recom-
mends using an antifreeze/corrosion inhibi-
tor which has been approved for Mercedes-
Benz.
! The cooling system contains a filling
which must be renewed after 15 years, or
after 250, 000 km at the latest. Have the
renewal confirmed in the Service Booklet.
The warranty is only valid if you top up with
an antifreeze/corrosion inhibitor which
has been approved by Mercedes-Benz, and
observe the recommended mixing ratios. Technical data
211_AKB; 2; 5, en-GB
mkalafa,
Version: 2.9.4 2008-02-29T16:57:07+01:00 - Seite 388Dateiname: 6515_3416_02_buchblock.pdf; preflight
Page 393 of 401

Service products and capacities
390 E 200 CDI E 220 CDI E 280 CDI
E 280 CDI
4MATIC
E 300 Bluetec E 320 CDI
E 320 CDI
4MATIC E 420 CDI
Coolant 10.2 l 10.2 l 13.0 l 13.0 l 15.3 l
Amount of antifreeze/corrosion inhibitor required for antifreeze protection
Down to –37 °C
(approx. 50%) 5.1 l 5.1 l 6.5 l 6.5 l 7.7 l
Down to –45 °C
(approx. 55%) 5.6 l 5.6 l 7.2 l 7.2 l 8.4 l
Brake fluid
Over a period of time, the brake fluid absorbs
moisture from the air; this lowers its boiling
point. G
Risk of accident
If the boiling point of the brake fluid is too
low, vapour pockets may form in the brake
system when the brakes are applied hard
(e.g. when driving downhill). This would
impair braking efficiency. Have the brake fluid renewed every two
years with a brake fluid that has been
approved by Mercedes-Benz and have this
confirmed in the Service Booklet.
i There is usually a notice in the engine
compartment to remind you when the next
brake fluid change is due. Windscreen washer system
The washer fluid reservoir holds approxi-
mately 4.5 litres; on vehicles with the head-
lamp cleaning system* it holds 7 litres.
The headlamp cleaning system* and the
windscreen washer system are both supplied
from the washer fluid reservoir.
X At temperatures above freezing point:
Top up the washer fluid reservoir with a
mixture of water and windscreen washer
concentrate (Y page 226).
X At temperatures below freezing point: Technical data
* optional
211_AKB; 2; 5, en-GB
mkalafa,
Version: 2.9.4 2008-02-29T16:57:07+01:00 - Seite 390Dateiname: 6515_3416_02_buchblock.pdf; preflight