2008 JEEP GRAND CHEROKEE key

5. Start engine.
6. Shift transmission into D (Drive).
7. Release brake pedal and ensure that there is no vehicle
movement.
8. Shut the engine off.
9. Shift transmission into P (Park).
10. Place the ignition key in the OFF position, and
remove key.
11. Apply parking brake.
12. Attach vehicle to the tow vehicle with tow bar.
13. Release parking brake.CAUTION!
Transmission damage may occur if the transmission
is shifted into P (Park) with the transfer case in N
(Neutral) and the engine running. With the transfer
case in N (Neutral) ensure that the engine is OFF
prior to shifting the transmission into P (Park) (refer
to steps7±8above).
366 STARTING AND OPERATING

Shifting Out Of Neutral (N)
Use the following procedure to prepare your vehicle for
normal usage.
1. Depress brake pedal.
2. Turn the ignition key ON, engine off.
3. Shift transmission into N (Neutral).
4. Shift transfer case out of N (Neutral).
Hold down N (Neutral) ªpinº switch (with a pen, etc.) for
4 seconds until the LED lamp by the switch starts to blink
indicating shift in progress. Lamp will stop blinking (go
out) when shift is complete. The ª4WD SYSTEM IN
NEUTRALº message will no longer be displayed on the
EVIC (Electronic Vehicle Information Center). Refer to
ªElectronic Vehicle Information Center (EVIC)º in Sec-
tion 4 of this manual.5. Shift transmission into P (Park).
6. Start the engine.
7. Shift transmission into D (Drive).
NOTE:
When shifting out of transfer case N (Neutral),
turning the engine OFF may be required to avoid gear clash.
Neutral Switch
STARTING AND OPERATING 367
5

Loose Fuel Filler Cap Message
After fuel is added, the vehicle diagnostic system can
determine if the fuel filler cap is loose, improperly
installed, or damaged. A ªCHECK GASCAPº message
will be displayed in the EVIC (Refer to Section 4 of this
manual). Tighten the gas cap until a9clicking9sound is
heard. This is an indication that the gas cap is properly
tightened.
This message may be temporarily overridden by pressing
either the C/T, STEP, or MENU buttons. However, after
one minute of no customer interaction, the EVIC will
display again the ªCHECK GASCAPº message. The
message will remain displayed until the vehicle diagnos-
tic system can retest the fuel system. The test will
perform the next time the vehicle is started, if the vehicle
was keyed off above 40ÉF (4ÉC) outside temperature and
the following vehicle start is above 40ÉF (4ÉC) outside
temperature. It may be possible to have a message that
will not clear due to the test being disabled due to lowoutside temperatures. If the test is performed and the
problem is gone, the message will disappear.
If the problem persists, the message will appear the next
time the vehicle is started. This might indicate a damaged
cap. If the problem is detected twice in a row, the system
will turn on the Malfunction Indicator Light (MIL).
Resolving the problem will turn the MIL light off. See
your authorized dealer for service.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle's emissions control system.
Failure to pass could prevent vehicle registration.
For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
MAINTAINING YOUR VEHICLE 391
7

is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle's OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off the
ignition key or start the engine. This means that your
vehicle's OBD system isnot readyand you shouldnot
proceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn off the ignition key or start
the engine. This means that your vehicle's OBD system
isreadyand you can proceed to the I/M station.
If your OBD system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
392 MAINTAINING YOUR VEHICLE

Cav-
ityCartridge
FuseMini Fuse Description
13 10 Amp
RedAutowipe (R/A)
14 20 Amp
YellowCigar Ltr (R/A)
15 10 Amp
RedTire Pressure Trans-
ducers (R/O)
16 10 Amp
RedSteering Control Mod-
ule (SCM), Diag. Con-
nector, Cluster (B+)
17 15 Amp
BlueFlipper Glass (B+)
19 Spare
(R/S)
20 10 Amp
RedSentry Key Remote
Entry Module
(SKREEM), Cluster
(R/S)Cav-
ityCartridge
FuseMini Fuse Description
21 Spare
(Acc De-
lay)
22 15 Amp
BlueRear Wiper (B+)
24 10 Amp
RedPower Distribution
Center (PDC) Relays,
Final Drive Control
Module (FDCM),
Front Control Module
(FCM) (R/S), A580
(R/S)
25 10 Amp
RedShifter Assy (BTSI),
Trans. Case Switch,
ESP/ABS, Brake Supp
Rly Coil (R/S)
428 MAINTAINING YOUR VEHICLE

BULB REPLACEMENT
High Intensity Discharge Headlights (HID) Ð If
Equipped
The headlights are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlight switch off and the key removed.Because of
this, you should not attempt to service a headlight bulb
yourself. If a headlight bulb fails, take your vehicle to
an authorized dealer for service.
WARNING!
A transient high tension occurs at the bulb sockets of
High Intensity Discharge (HID) headlights when the
headlight switch is turned ON. It may cause serious
electrical shock or electrocution if not serviced prop-
erly. See your authorized dealer for service.
NOTE:On vehicles equipped with High Intensity Dis-
charge Headlights (HID), when the headlights are turned
on, there is a blue hue to the lights. This diminishes and
becomes more white after approximately 10 seconds, as
the system charges.
MAINTAINING YOUR VEHICLE 435
7

Fluid Type........................... 417
Special Additives...................... 417
Torque Converter...................... 291
Autostick............................. 287
Auxiliary Electrical Outlet (Power Outlet)...... 168
Auxiliary Power Outlet................... 168
Battery............................... 401
Emergency Starting..................... 378
Keyless Transmitter Replacement (RKE)....... 25
Saving Feature (Protection)............... 124
Belts, Drive............................ 398
Belts, Seat.............................. 37
Body Mechanism Lubrication............... 405
B-Pillar Location........................ 314
Brake Assist System...................... 140
Brake Control System, Electronic............. 138
Brake Fluid............................ 414
Brake System........................... 413Anti-Lock (ABS)....................138,305
Fluid Check.......................... 414
Hoses.............................. 413
Master Cylinder....................... 414
Parking............................. 304
Warning Light........................ 188
Brake/Transmission Interlock............... 285
Break-In Recommendations, New Vehicle........ 68
Bulb Replacement.....................434,435
Calibration, Compass..................... 205
Camera, Rear........................... 156
Capacities, Fluid........................ 440
Caps, Filler
Fuel................................ 346
Radiator (Coolant Pressure)............... 409
Car Washes............................ 422
Carbon Monoxide Warning...............69,340
Cargo Area Cover....................... 173
INDEX 471
10

General Information...............20,26,108,336
Glass Cleaning.......................... 425
Glow Plug Light........................ 196
Gross Axle Weight Rating.................. 352
Gross Vehicle Weight Rating................ 351
GVWR............................... 348
Hands-Free Phone (UConnectŸ).............. 81
Hard Drive (HDD)....................... 241
Hazard Warning Flasher................... 370
Head Restraints......................... 111
Head Rests............................ 111
Headlights..........................124,435
Bulb Replacement...................... 436
Cleaning............................ 425
On With Wipers....................... 125
Replacing............................ 436
Heated Mirrors.......................... 80
Heated Seats........................ 111,113Heater, Engine Block..................... 283
High Beam Indicator..................... 188
High Beam/Low Beam Select (Dimmer) Switch . . 128
Hill Descent Control..................... 149
Hill Start Assist......................... 147
Hitches
Trailer Towing........................ 354
Holder, Cup........................... 171
HomeLinkt(Garage Door Opener) Transmitter . . . 158
Hood Release.......................... 122
Hoses................................ 412
Ignition............................... 16
Cables (Spark Plug Wires)................ 398
Key ...............................14,16
Wiring System (Spark Plug Wires).......... 398
Ignition Key Removal..................... 16
Illuminated Entry........................ 21
Immobilizer (Sentry Key)................... 17
INDEX 477
10