2008 GREAT WALL FLORID transmission

Downloaded from www.Manualslib.com manuals search engine 61Transmission
2. Remove the output shaft's 5th driven gear shaft retainer.
3. Remove together the output shaft's 5th and 4th gear
driven gear.
4. Remove the output shaft spacer.
5. Remove the output shaft's 3rd driven gear and the 2nd
gear subassembly spacer.

Downloaded from www.Manualslib.com manuals search engine 63Transmission
10. Remove each component of output shaft's No. 1 syn-
chronizer.
11. Remove the front tapered roller bearing.

Downloaded from www.Manualslib.com manuals search engine 65Transmission
2. Remove the shaft retainer on the shift lever and the se-
lect lever.
3. Remove the lock plate.
4. Remove the pressure torsion spring.
5. Remove the No. 2 spring seat.

Downloaded from www.Manualslib.com manuals search engine 67Transmission
10. Remove the shaft retainer from the shift shaft.
11. Remove the shift shaft T oil seal from the manipulation
lid.
12. Remove the T oil seal from the manipulation lid.

Downloaded from www.Manualslib.com manuals search engine GWFLORID Maintenance Manual68
Disassembling the Differential Subassembly
Components
T oil sealClutch housing
Tapered roller bearings
Elastic cylindrical pin
Odometer drive gear
Differential case
Differential ring gear
Bolt for flange face
Gasket
Planetary gear
Adjusting shim
Axle shaft gear
Planetary gear shaft
Planetary gear
Gasket
Axle shaft gear
Adjusting shim
Tapered roller bearings
Transmission case
Adjusting shim
T oil seal
123.6
: Specified torqueN·m

Downloaded from www.Manualslib.com manuals search engine 69Transmission
1. Remove the tapered roller bearings of the left differen-
tial.
2. Remove the odometer drive gear from the differential.
3. Remove the tapered roller bearings of the right differen-
tial.
4. Remove the bolts for flange face of the differential ring
gear and the differential case.

Downloaded from www.Manualslib.com manuals search engine GWFLORID Maintenance Manual84
Drive Shaft
Components
Drive shaft removal
1. First use a M32 sleeve, ratchet wrench, and extension
bar, to remove front drive shaft nut LH. Then, according
t o t h e w h e e l a n d f r o n t s u s p e n s i o n d i s a s s e m b l y
specifications, remove the Front suspension system
LH and wheel.
2. Then use a pry bar to forcefully pry the connection
between the differential and the drive shaft until the
drive shaft obviously moves towards the outside. Do
not damage the drive shaft's dust cover.
Front shock absorber with coil spring assembly LH
Front drive shaft nut LH
Wheel assembly
Front drive shaft assembly LHTransmission assembly
F
F

Downloaded from www.Manualslib.com manuals search engine 85Suspension System
Drive shaft installation
1. Insert the drive shaft.
First, align the inner end of the drive shaft and differential
spline. Keep the drive shaft axes and the differential axes
bases uniform, then hammer towards the direction of the
differential drive shaft's outer end until a clear and sharp
clicking sound is heard. Here, the drive shaft and the
transmission should have a clearance of about 1 mm.
2. According to the front suspension and wheel assembly
installation specifications, properly install the front
shock absorber with coil spring assembly LH and
wheel.
3. Use an M32 sleeve, ratchet wrench, and extension bar
to tighten front drive shaft nut LH.
Tightening torque: 225±20 N·m
F
F