Downloaded from www.Manualslib.com manuals search engine 231Airbags
Driver side airbag module
Wi r e h a r n e s s u s e d for deployment
Old tire with no hub
Wire harness used for deployment
Wire harness used for deployment
Wire harness used for deploymentShort circuit area
Longer than 6 m
4. Deploy the wire harness after removing the No. 2
connector of the clock spring.
Prepare two wire harnesses longer than 6 m for deployment,
and connect one of their ends together (to short circuit).
Caution: When deploying the airbag, make sure to
maintain a distance of at least 6 m away from objects
or people, and perform the deployment on a flat sur-
face. While deploying the airbag module outdoors,
avoid strong winds, and ignite it against the wind.
8. Place three old tires with no hub on the tires which are
used to fix in place the driver side airbag module (shown
on the left).
9. Cut off the connection of the driver side airbag module's
wire harness which is used for deployment at a place as
far away from the vehicle as possible and connect it to
the two terminals removed from the vehicle battery, caus-
ing it to deploy (shown on the left).
Caution: Deploy it only after ensuring that there are no
people around the airbag module. After the deployment
of driver side airbag module, the gas generator will be ex-
tremely hot. Continue to use it only after 30 min cooling.
10. Discard the deployed driver side airbag module accord-
ing to the discarding essentials.
5. Insert the airbag deployment wire harness into the
airbag execution device.
6. Install the unused bolts on the driver side airbag
module's inner side bolts, and bound the wheel rim with
a thick metal wire, so as to set the wheel rim in place.
7. Connect the wire harness used for deployment which is
connected with the driver side airbag module with the
lower part of the old tire which is used for installing the
wheel rim. Upwardly fix the driver side airbag module
with the metal wire which is connected to the bolt
(shown on the left).
