III. Fault diagnosis 1. During detection, if there is no sound or display screen does not illuminate, please detect whether polarity
of power supply is connected in a wrong way, whether power cord is connected, whether supply voltage 9V,
whether display joint is inserted properly.
2. If clobber "0.0" or constant ringing occurs, please exit reverse gear, engage reverse gear again. If the
above symptom still exists, it may be deemed that principal machine is damaged, and should be replaced
completely.
3. If certain value is displayed, while there is no evident barrier at right ahead of probe. Prominence on or rear
might be detected (such as license plate, bumper bar etc). please check whether direction axis of the probe is
correct, horizontal axis of the probe should slightly upwarp.
4. When accelerating, the installed display shows irregular disordered frame, circuit interference might occur,
check earth wire of reversing radar.IV. Installation of reversing radar 1. Reversing radar system consists of reversing radar principal machine, reversing radar display screen, wiring
harness, buckle and reversing radar probe etc.Rear Parking Radar System-
Rear Parking Radar System5-132About 500 mm
About 265 mmRear parking radarsensor
Clip
Push Rear bumper bar
