Rear strut assemblyOverhaulHint: the following overhaul procedures only aim at left side (LH), and the overhaul procedures
of another side (RH) are the same as LH.
1. Remove rear wheels.2. Remove rear left seat backrest assembly [68010078] (see Page 352).
3. Remove spare tire trim cover assembly.
4. Remove rear floor trim
5. Remove trunk left garnish [68000112].
6. Remove rear left strut assembly [64000098].(a) Support rear shaft with a jack.
(b) Remove 2 nuts and bolts.Rear suspension - Rear strut assembly(c) Remove nuts, gasket and rear strut assembly.7. Remove rear left strut assembly [64000098].(a) Compress helical spring with special tool.
Note: do not use pneumatic wrench, or the special tool
will be damaged.Wooden
block
Special tool102
Tire and wheel- wheel and tire systemTire and wheelWheel and tire systemInspection1. Check tire.(a) Check tire is worn and inflation pressure is proper.
Cold tire inflation pressure:
*1 It is used under the condition of speed below 160 km/h.
(b) Check tire run-out with dial indicator.
Tire run-out: 2. Adjust tire position.
Hint:see adjusting position of tire shown in the dia-
gram whether there is spare tire or not.3. Check wheel balance.(a) Check and adjust with off-the-car balancing machine.
(b) Check and adjust with in-the-car balancing machine if
necessary.
Unbalanced mass after adjusting: 4. Check axial clearance of front wheel bearing
(see Page 123).
5. Check end surface run-out of front wheel shaft hub
(see Page 123).
6. Check axial clearance of rear wheel bearing
(see Page 129).
7. Check end surface run-out of rear wheel shaft hub
(see Page 129).
8. Check front suspension is loose.
9. Check steering linkage is loose.
10. Check ball joint is loose.Tire size Front and rear kPaFront109
