2008 GEELY FC differential

Take down tapered bearing on differential shell liking that
shown in figure.
Note: put column end surface in bearing into position
reliably.
Take down cylindrical bearing of speedmeter driving wheel
side liking that shown in figure.
Take down driving gear of speedmeter
Disassemble by sequence the fastening bolts of differential.
Take out elastic cylindrical pin with pin taker, and take out
second planetary gears and gaskets, two axle shaft gears
and gaskets and planetary gear shaft by sequence.
Transmission—Disassemble assembly
 174 

Assemble two axle shaft gears and their gaskets in differen-
tial shell by sequence, then screw two planetary gears and
their gaskets in differential shell, and put planetary gear shaft,
lastly, assemble a new elastic cylindrical pin liking that shown
in figure.
Assemble differential gear ring by the direction in figure, and
screw connecting bolts of differential.
Assemble speedmeter driving gear by the direction in figure.
Transmission—Disassemble assembly
 189 

Screw support cover of output rear shaft in differential shell until reaching screwing torque that is
40N•m, then put stop disc spring of output shat bearing in support cover of output rear shaft by the
direction in figure, lastly, press down end cover and tighten connecting bolts of end cover, their
torque is 12N•m
Transmission—Assemble the assembly
Transmission
Assemble the assembly
 191 
Connecting bolt of end cover
End coverStop disc spring of output
shaft bearing
Support cover of output
rear shaft