291IV. ABS Operation Inspection1. Check the Wheel Speed Sensor Output Voltage
1Check whether the clearance between the wheel speed sensor and the ring gear is within the specification
For front wheel standard value, refer to "Front Wheel Sensor Installation Drawing"
For rear wheel standard value, refer to "Rear Wheel Sensor Installation Drawing"
3Jack up the wheel and release the manual brake
2Remove the ABS wire harness, measure at the wire harness connector
4Rotate the wheel at the speed of 1/2 turn/second, and use the multimeter or oscilloscope to measure the
output voltage
Terminal 1-2
Terminal 19-20
Terminal 5-6
Terminal 22-23
Output Voltage
zWhen use the multimeter to measure
For front wheel, refer to "Front Wheel Sensor Drawing".
For rear wheel, refer to "Rear Wheel Sensor Drawing".
zWhen use the oscilloscope to measure
For front wheel, refer to the related standard.
For rear wheel, refer to the related standard.
5The fact that the output voltage is not within the above range may result from the following causes:
zExcessive clearance between the sensor and the ring gear.
zSensor fault.
zCheck the sensor resistance£¨1.0 - 1.3k¦¸£©.
zSelect the 4 points on the ring gear to check the clearance (ring gear distortion) between the ring
gear and the wheel speed sensor.
2.Check the Hydraulic Control Unit (HCU).
1Jack up the vehicle, make sure the wheel can rotate freely.
2Release the manual brake.
3Turn the ignition switch to ON after connecting the scan meter, do not start the engine this time.
4Refer to the HCU Diagnosis for inspection.
Note: when connecting or removing the scan meter, the ignition switch must be turned to OFF.
