2008 DODGE SPRINTER handbrake

19 At a glance
Cockpit
1
Function
Page
1
Door control panel
31
2
Light switch
130
3
Combination switch\4
Turn signals
\4
High-beam head-
lamps
\4
Windshield wipers
\4
Rear window wiper*
135
131
210
212
4
Cruise control lever*
249
5
Horn
6
Steering wheel without/
with* buttons
25
Function
Page
7
Instrument cluster
20,
142
8
Storage compartment
9
Storage compartment
with interior lamp
137
Overhead control panel*
27
a
Rear-view mirror*
208
b
Rear view camera moni-
tor*
261
c
Warning display for Park-
tronic system*
256
d
Opens / closes the right-
hand side window
244
Function
Page
e
Jack and vehicle tool kit
515
f
Glove box
288
g
Center console
26
h
Selector lever (automatic
transmission)
185
j
Ignition lock
111
k
Additional switch unit
29
l
Handbrake
191
m
Steering wheel adjust-
ment
127
n
Hood lock release
318
o
Additional switch unit
29
nf_BA.book Page 19 Friday, January 25, 2008 3:53 PM

24 At a glanceInstrument cluster
1
Indicator and warning lamps
Page
Water in the fuel
482
#
Battery charge mal-
function
469
.
Defective bulb
483
Handbrake applied
191
B
Low-beam headlamps
on
131
™
Operating speed gov-
ernor on*
273
A
High-beam headlamps
on
131
<
Seat belt reminder
482
iVehicles with steering wheel buttons:
Corresponding messages may also
be shown in display
9

(
\2
page 157).
nf_BA.book Page 24 Friday, January 25, 2008 3:53 PM

40 SafetyOccupant safety
2
\1
Pull the belt smoothly from the seat
belt reel holder.
\1
Route the belt over your shoulder.
\1
Click belt latch plate
2
into buckle
4
.
\1
Adjust the belt to the correct height
if necessary.
\1
Pull the shoulder section of the belt
upwards to tighten the belt against
your body if necessary.
Adjusting the belt heightYou can adjust the belt height for the fol-
lowing seats:\4
Driver’s seat
\4
Outer passenger’s seatAdjust the belt height in such a way that
the shoulder belt is routed over the mid-
dle of the shoulder.
Belt sash guide with height adjustment
5Release button
Warning
G
Only adjust the belt height when the vehi-
cle is stationary and the handbrake is ap-
plied.
You could otherwise lose control of the
vehicle as a result of the seat adjusting
movement and thereby endanger yourself
and others.
nf_BA.book Page 40 Friday, January 25, 2008 3:53 PM

112 Controls in detailSeats
3
\3 SeatsDriver’s and passenger’s seatsWarning
G
Only adjust the seats when the vehicle is
stationary and the handbrake is applied.
You could otherwise lose control of the
vehicle as a result of the seat moving and
cause an accident.
Warning
G
Make sure that nobody can become
trapped as the seat is adjusted. Never
place your hands under the seat or near to
moving parts.Your seat must be adjusted in such a way
that you can wear the seat belt correctly
(\2page 39). Observe the following points:\4Position the backrest as vertically as
possible and sit upright.
Continued
Warning (Continued)
G
\4Avoid seat positions that do not allow
the seat belt to be routed correctly.
The shoulder section of the seat belt
must be routed across the middle of
your shoulder and must fit closely
across your chest. The lap section of
the belt must be routed as low as pos-
sible across your pelvic area, i.e.
across your hip joints. Never drive
with the backrest tilted too far back.\4
Your arms should be slightly bent when
you are holding the steering wheel.
Continued
nf_BA.book Page 112 Friday, January 25, 2008 3:53 PM

116 Controls in detailSeats
3
Seat suspension adjustment* The seat suspension must be adjusted
to your body weight. Only adjust the seat
suspension when the seat is unoccup-
ied.\1
Relieve the load on the seat.
\1
Select your body weight 88 to
265 lbs (40 to 120 kg) using thumb-
wheel
6
for optimal seat suspensi-
on.
The seat suspension becomes har-
der as you adjust it to a higher body
weight. The seat will then travel
down as far.
Suspension lock* If the seat bounces up and down fre-
quently, you can engage the seat the lo-
wer position of its suspension travel.\1
Turn lever
7
downward.
The next time the seat bounces, it
will engage.
\1
Turn lever
7
upward to release the
seat from the suspension lock.The seat can now move up and down
again.
Swivelling front seats*
iThe suspension lock will engage only
if your weight is identical or above
the adjusted suspension weight.
Warning
G
Only adjust the seats when the vehicle is
stationary and the handbrake is applied.
You could otherwise lose control of the
vehicle as a result of the seat moving and
cause an accident.
nf_BA.book Page 116 Friday, January 25, 2008 3:53 PM

117 Controls in detailSeats
3
The driver’s and passenger’s seat can be
rotated by 180° to be opposite of the di-
rection of travel.The seats engage in the direction of trav-
el or opposite the direction of travel as
well as at 50° pointing towards the exit.Fold the handbrake lever down as far as
it will go. You could otherwise damage
the handbrake or the handbrake lever.
\1
Make sure the handbrake is applied
and the handbrake lever is folded
down as far as it will go
(\2
page 191).
\1
Set the steering wheel so that there
is sufficient clearance for turning and
adjusting the driver’s seat
(\2
page 127).
Warning
G
The driver’s and passenger’s seat must be
adjusted and properly engaged in the di-
rection of travel for driving. Otherwise you
will not be able to operate the vehicle
safely.
The restraint systems in your vehicle will
only function as intended when the dri-
ver’s and passenger’s seat are engaged in
the direction of travel.
!
CAUTION
When rotating the seats, make sure
there is sufficient space. If neces-
sary, move the seat fore or aft to
avoid colliding with adjacent add-on
parts.
\4
Fold the handbrake lever down
as far as it will go. You could
otherwise damage the handbra-
ke or the handbrake lever.
iMove the passenger’s seat forward
as far as it will go before rotating it
(\2
page 114).
nf_BA.book Page 117 Friday, January 25, 2008 3:53 PM

184 Controls in detailDriving and parking
3
You will find information on:\4
regular checks (
\2
page 312)
\4
driving in winter (
\2
page 406)
\4
driving when towing a trailer
(\2
page 303)
\4
and other driving tips
in the “Operation” section
(
\2
page 301).
\1
Before starting the engine, make
sure that all vehicle occupants are
wearing their seat belt correctly
(\2
page 39) and the handbrake
(
\2
page 191) is applied.
Starting the engineWarning
G
Never run the engine in an enclosed
space. The exhaust fumes contain poi-
sonous carbon monoxide. Breathing in
exhaust fumes constitutes a health haz-
ard and can lead to loss of consciousness
and death.
Warning
G
A seat belt that is worn incorrectly or not
at all, or that is not correctly engaged in
the seat belt buckle, cannot perform its
intended protective function. In certain
circumstances, you could then be seri-
ously or even fatally injured. Make sure,
therefore, that all occupants – in particu-
lar, expectant mothers – wear their seat
belt correctly at all times.
nf_BA.book Page 184 Friday, January 25, 2008 3:53 PM

187 Controls in detail
Driving and parking
3
\1
Depress the brake pedal and keep it
depressed.
The selector lever lock is released.
\1
Release the handbrake
(\2
page 191).
The7
indicator lamp in the in-
strument cluster goes out.
\1
Move the selector lever to position
D
or
R.
\1
Release the brake pedal.
\1
Carefully depress the accelerator pedal.
You will find more information about se-
lector lever positions, shift ranges and
driving tips in the “Automatic transmis-
sion” section (
\2
page 201).
iOn vehicles with a reverse warning
feature*, an audible warning sounds
for other road users when reverse
gear is engaged (
\2
page 271).
iDepending on the vehicle's settings,
the vehicle automatically locks itself
centrally after it has driven off, at the
latest (
\2
page 106). The locking
knobs on the front doors and the
sliding door drop down.
You can open the doors from the in-
side at any time.
You can also switch off the automat-
ic door lock (
\2
page 106).
!
CAUTION
Only select reverse gear when the ve-
hicle is stationary, otherwise you
could damage the automatic trans-
mission.
iWait until the gear selection has
completed before pulling away.iAutomatic transmission upshifts are
made at higher engine speeds after a
cold start. This helps the catalytic
converter to reach its operating tem-
perature more quickly.
nf_BA.book Page 187 Friday, January 25, 2008 3:53 PM