2008 DODGE SPRINTER handbrake

253 Controls in detail
Driving systems
3 i
Cruise control is automatically deac-
tivated if:\4
you are braking
\4
you apply the handbrake and
the
7
indicator lamp in the in-
strument cluster is lit
\4
you are driving under 20 mph
(30 km/h)
\4
ESP
® or ASR is intervening and
the yellow ASR/ESP
® warning
lamp flashes in the instrument
cluster
\4
you move the selector lever to po-
sition
N while driving
\4
ESP
®, ASR or ABS has malfunc-
tioned
Parktronic system (PTS)
*
Warning
G
Parktronic is only an aid and may not de-
tect all obstacles. This system does not
relieve you of the need to pay attention.
You are always responsible for safety and
must continue to pay attention to your im-
mediate surroundings when parking and
maneuvering. Otherwise, you could en-
danger yourself and others.
Warning
G
Make sure that no persons or animals are
in the maneuvering range of the vehicle.
They could otherwise be injured.
nf_BA.book Page 253 Friday, January 25, 2008 3:53 PM

254 Controls in detailDriving systems
3
Parktronic is an electronic parking aid
and informs you visually and audibly of
the distance between the vehicle and an
obstacle.
Parktronic is automatically switched on
when you switch on the ignition and re-
lease the handbrake. You must also
move the selector lever to position
D, N
or R.
Parktronic switches off at speeds of over
11 mph (18 km/h). It switches on again
as soon as the vehicle’s speed falls be-
low this limit speed.
Parktronic is equipped with sensors in
the front and rear bumper to monitor the
area around your vehicle.
Range of the sensorsThe sensors must be free from dirt, ice
and slush, otherwise they may not func-
tion correctly. Clean the sensors regu-
larly, taking care not to scratch or
damage them (
\2
page 422).
nf_BA.book Page 254 Friday, January 25, 2008 3:53 PM

273 Controls in detail
Operating the vehicle
3
\3 Operating the vehicleWhen activated, the operating speed
governor (ADR) automatically increases
the engine speed to a preset or adjust-
able operating speed (
\2
page 275).
Activating / deactivating ADRThe switch is between the light switch
and the steering wheel.1To switch on
2To switch off
Operating speed governor (ADR)*
iThe idle speed of the engine auto-
matically increases after a cold start.
If the set operating speed is lower
than the increased idle speed, the
set operating speed is attained only
after the engine has reached its op-
erating temperature.
It is only possible to activate ADR
with the vehicle stationary and the
handbrake applied. The selector le-
ver must be in position
P.
N54.25-2932-31
nf_BA.book Page 273 Friday, January 25, 2008 3:53 PM

274 Controls in detailOperating the vehicle
3
\1To switch on:
press upper part
1
of
the switch with the engine running.
The indicator lamp in the switch
comes on.
Vehicles without steering wheel but-
tons:
The
™
indicator lamp in the in-
strument cluster comes on.Vehicles with steering wheel but-
tons:
The
Operating speed governor ac-
tive message appears in the dis-
play.
\1To switch off:
press lower part
2
of
the switch with the engine running.
The indicator lamp in the switch and
the
™
indicator lamp in the in-
strument cluster go out.
iADR is automatically deactivated
when:\4
you release the handbrake
\4
the vehicle moves
\4
the control unit detects a mal-
function
nf_BA.book Page 274 Friday, January 25, 2008 3:53 PM

431 Practical hints
What to do if ...
5
Problem
Possible cause / result
Suggested solutions
The anti-theft alarm system is suddenly trig-
gered.
You have opened the vehicle using the key
while the anti-theft alarm system was still
primed.
Key:
\1Press theΠbutton.
or
\1Insert the key into the ignition lock.
The anti-theft alarm system is deacti-
vated.
You hear a warning signal.
A message appears in the display.
\1Observe the instructions on
(\2page 484).
You are driving with the handbrake applied.
\1Release the handbrake (\2page 191).
You opened the driver’s door and forgot to
switch off the lights.
\1Turn the light switch to0.
Warning
G
You are not wearing your seat belt.
\1Fasten your seat belt .
nf_BA.book Page 431 Friday, January 25, 2008 3:53 PM

499 Practical hints
Display messages
5
6
Brake force
distribution
Visit
workshop
WARNING
G
EBV has malfunctioned.
The rear wheels could lock up sooner than
expected when you apply the brakes.
\1Stop your vehicle as soon as it is safe to do
so.
\1Do not drive any further.
\1Consult an authorized Sprinter Dealer.
7
Parking brake
Release brakeA signal also
sounds.
You are driving with the handbrake applied.
\1Release the handbrake (\2page 191).
Display symbol
Display message
Possible cause / result
Possible solution
nf_BA.book Page 499 Friday, January 25, 2008 3:53 PM

542 Practical hintsFuel system
5
\3 Fuel systemOn vehicles with a diesel engine, it is
necessary to drain the fuel filter if
the
/
indicator lamp lights up.
To this end, have the fuel filter with wa-
ter separator drained at an authorized
Sprinter Dealer which has the necessary
specialist knowledge and tools to carry
out the work required.The fuel filter with water separator is in
the engine compartment.
1Drain hose
2Drain plug\1
Apply the handbrake and move the
selector lever to position
P.
Draining the fuel filter!
CAUTION
Drain the fuel filter with water sepa-
rator immediately if the
/
indica-
tor lamp lights up. The engine could
be damaged.
Environmental note
H
When handling, storing and disposing of
diesel and diesel mixtures, please ob-
serve the relevant regulations.
nf_BA.book Page 542 Friday, January 25, 2008 3:53 PM

545 Practical hints
Replacing the wiper blades
5
\3 Replacing the wiper blades
\1
Apply the handbrake (
\2
page 191).
1Wiper blade
2Retaining clips
3Wiper arm\1
Fold the wiper arms away from the
windshield.
!
CAUTION
Do not open the hood while the wiper
arms are folded away from the wind-
shield. You would damage the hood
and the wiper arms.
Do not fold the wiper arms onto the
windshield without wiper blades be-
ing attached. You could scratch the
windshield.
For your own convenience, have this
work carried out at an authorized
Sprinter Dealer.
Removing the wiper bladesWarning
G
When the windshield wipers are set to in-
termittent wipe or the rain sensor is ac-
tive, the windshield wipers could move at
any time and injure yourself or others
upon contact with them.
Always remove the key from the ignition
lock before replacing the wiper blades.
nf_BA.book Page 545 Friday, January 25, 2008 3:53 PM