Page 7 of 666

5 Introduction
Environmental protection
Introduction
\3 Environmental protectionEnvironmental note
H
Chrysler’s declared policy is one of compre-
hensive environmental protection.The objectives are for the natural resourc-
es which form the basis of our existence
on this planet to be used sparingly and in
a manner which takes the requirements
of both nature and humanity into ac-
count.You too can contribute to environmental
protection by operating your vehicle in an
environmentally-responsible manner.
Fuel consumption and engine, transmis-
sion, brake and tire wear depend on the
two following factors:
\4Operating conditions of your vehicle
\4Your personal driving style
You can influence both factors.
Observe the following notes:
Operating conditions
\4Avoid driving short distances as this
increases fuel consumption.
\4Make sure that the tire pressures are
always correct.
\4Do not carry any unnecessary weight
in / on the vehicle.
\4Keep an eye on the vehicle’s fuel con-
sumption.
\4Remove roof racks once you no long-
er need them.
\4A regularly serviced vehicle will con-
tribute to environmental protection.
You should therefore adhere to the
specified service intervals.
\4Always have maintenance work car-
ried out at an authorized Sprinter
Dealer.
\2\2
nf_BA.book Page 5 Friday, January 25, 2008 3:53 PM
Page 24 of 666
22 At a glanceInstrument cluster
1
Function
Page
c
Fuel gauge with:\4
Reserve fuel warning
lamp
\4
Fuel filler flap location
indicatorÖ
: Fuel filler flap is
on the left-
hand side
145
475
iVehicles without steering wheel
buttons:
Display
8
contains a digital fuel
gauge.
Vehicles with steering wheel but-
tons*:
The tachometer contains an analog
fuel gauge.
Indicator and Warning Lamps
Page
v
ESP
® warning lamp
72
468
ASR warning lamp
73
74
465
/
Coolant level too low
474
D
Coolant temperature
too high
475
1
Restraint systems
malfunction
469
nf_BA.book Page 22 Friday, January 25, 2008 3:53 PM
Page 25 of 666
23 At a glance
Instrument cluster
1
Brake fluid level too
low
463
EBV malfunction
462
Malfunction in trailer's
brake booster
464
N
Engine oil level warning
as47
1
±
Engine diagnostic
indicator lamp
477
q
Pre-glow system, die-
sel engine only
186
476
Turn signal, left
135
Indicator and Warning Lamps
Page
Indicator and warning lamps
Page
X
Combination low tire
pressure/TPMS mal-
function telltale, USA
only
478
Low tire pressure tell-
tale, Canada only
478
J
Windshield washer/
headlamp cleaning sys-
tem* washer fluid level
too low
482
Door open
483
2
Brake pads / linings
worn
470
Turn signal, right
135
-
ABS malfunction
466
k
ASR malfunction
465
BAS malfunction
465
#
ESP
® malfunction
468
‰
Air cleaner dirty
477
A
Reserve fuel
475
Fuel filler flap open
476
Indicator and warning lamps
Page
nf_BA.book Page 23 Friday, January 25, 2008 3:53 PM
Page 26 of 666
24 At a glanceInstrument cluster
1
Indicator and warning lamps
Page
Water in the fuel
482
#
Battery charge mal-
function
469
.
Defective bulb
483
Handbrake applied
191
B
Low-beam headlamps
on
131
™
Operating speed gov-
ernor on*
273
A
High-beam headlamps
on
131
<
Seat belt reminder
482
iVehicles with steering wheel buttons:
Corresponding messages may also
be shown in display
9
(
\2
page 157).
nf_BA.book Page 24 Friday, January 25, 2008 3:53 PM
Page 147 of 666
145 Controls in detail
Instrument cluster
3
The red band in the tachometer indi-
cates the engine’s overrevving range.
To protect the engine, the fuel supply is
interrupted when the red band is
reached.Tachometer!
CAUTION
Do not drive in the overrevving
range. Doing so could damage the
engine.
Environmental note
H
Avoid high engine speeds. These could in-
crease your vehicle’s fuel consumption
unnecessarily and damage the environ-
ment through increased pollutant emis-
sions.SpeedometeriIn some countries, a signal sounds
when the vehicle reaches the maxi-
mum speed limit, e.g. at 75 mph
(120 km/h).
Fuel gauge
nf_BA.book Page 145 Friday, January 25, 2008 3:53 PM
Page 148 of 666
146 Controls in detailInstrument cluster
3
Resetting the trip meter
\1
Vehicles with steering wheel but-
tons*: Make sure that the display is
showing the trip meter
(\2
page 157).
\1
Keep reset button
0 pressed until
the trip meter is set to
0.0
.
Fuel gauge1
Vehicles without steering wheel
buttons
2
Vehicles with steering wheel but-
tons*
3
Fuel filler flap location indicatorÖ
: The fuel filler cap is on the
left-hand side
4
Reserve fuel warning lamp
(\2
page 475)
Trip meter
nf_BA.book Page 146 Friday, January 25, 2008 3:53 PM
Page 150 of 666
148 Controls in detailOperating system without steering wheel buttons
3
Changing the standard display
\1
Switch on the ignition (
\2
page 111).
\1
Press and hold the menu button
for more than 1 second.
The information shown in the display
changes from the outside tempera-
ture to the digital speedometer.
Outside temperature display*
Standard display1
Odometer
2
Trip meter
3
Time
4
Outside temperature* or digital
speedometer
5
Fuel gauge (
\2
page 145)
6
Selector lever position or current
shift rangeN54.32-2281-31
Warning
G
Even if the temperature displayed is just
above freezing point, the road surface may
still be icy, especially in wooded areas or on
bridges. You could skid if you do not adopt
a suitable driving style. You should there-
fore always adapt your driving style and
speed to suit the weather conditions.
nf_BA.book Page 148 Friday, January 25, 2008 3:53 PM
Page 179 of 666
177 Controls in detail
Operating system with steering wheel buttons*
3
Consumption statistics after start
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
After start
message in the display.
1Distance driven since start
2Time elapsed since start
3Average speed since start
4Average fuel consumption since start
Consumption statistics after reset
\1
Press the
è
or
ÿ
button re-
peatedly until you see the
After start
message in the display.
\1
Press the
j
or
k
button re-
peatedly until you see the
After re-
set
message.
1Distance driven since last reset
2Time elapsed since last reset
3Average speed since last reset
4Average fuel consumption since last
reset
N54.32-2274-31
iIf you turn the key to position
0 in the
ignition lock or remove it, all the val-
ues are reset after approximately 4
hours.
The values will not be reset if you turn
the key back to position
1 or
2 during
this time.
N54.32-2275-31
nf_BA.book Page 177 Friday, January 25, 2008 3:53 PM