2008 DODGE SPRINTER radio

371 Operation
Tires and wheels
4
Reactivating the TPMSThe TPMS must be reactivated when you
have adjusted the tire inflation pressure
to a new level (e.g. because of different
load or driving conditions). The TPMS is
then recalibrated to the current tire in-
flation pressures.
Warning (Continued)
G
TPMS malfunctions may occur for a vari-
ety of reasons, including the installation
of incompatible replacement or alternate
tires or wheels on the vehicle that prevent
the TPMS from functioning properly. Al-
ways check the TPMS malfunction telltale
after replacing one or more tires or
wheels on your vehicle to ensure that the
replacement or alternate tires and wheels
allow the TPMS to continue to function
properly.
iIf a condition causing the TPMS to
malfunction develops, it may take up
to 10 minutes for the system to sig-
nal a malfunction using the TPMS tell-
tale flashing and illumination
sequence.
The telltale extinguishes after driving
a few minutes if the malfunction has
been corrected.
iOperating radio transmission equip-
ment (e.g. wireless headsets, two-
way radios) in or near the vehicle
could cause the TPMS to malfunction
nf_BA.book Page 371 Friday, January 25, 2008 3:53 PM

378 OperationTires and wheels
4
Warning (Continued)
G
USA only:Your vehicle has also been equipped with a
TPMS malfunction indicator to indicate when
the system is not operating properly. The
TPMS malfunction indicator is combined
with the low tire pressure telltale. When the
system detects a malfunction, the telltale will
flash for approximately 1 minute and then re-
main continuously illuminated. This se-
quence will continue upon subsequent
vehicle start-ups as long as the malfunction
exists. When the malfunction indicator is illu-
minated, the system may not be able to de-
tect or signal low tire pressure as intended.
Continued
Warning (Continued)
G
TPMS malfunctions may occur for a vari-
ety of reasons, including the installation
of incompatible replacement or alternate
tires or wheels on the vehicle that prevent
the TPMS from functioning properly. Al-
ways check the TPMS malfunction telltale
after replacing one or more tires or
wheels on your vehicle to ensure that the
replacement or alternate tires and wheels
allow the TPMS to continue to function
properly.
iIf a condition causing the TPMS to
malfunction develops, it may take up
to 10 minutes for the system to sig-
nal a malfunction using the TPMS
telltale flashing and illumination se-
quence.
The telltale extinguishes after driving
a few minutes if the malfunction has
been corrected.iOperating radio transmission equip-
ment (e.g. wireless headsets, two-way
radios) in or near the vehicle could
cause the TPMS to malfunction
nf_BA.book Page 378 Friday, January 25, 2008 3:53 PM

393 Operation
Tires and wheels
4
1Plies in side wall
2Plies under tread
This marking tells you about the type of
cord and number of plies in the side wall
and under the tread.
Accessory weightThe combined weight (in excess of those
standard items which may be replaced)
of automatic transmission, power steer-
ing, power brakes, power windows, pow-
er seats, radio, and heater, to the extent
that these items are available as factory-
installed equipment (whether installed
or not).
Tire ply material
iFor illustrative purposes only. The
actual data on tires is specific to
each vehicle and may vary from the
data shown in the above illustration.
Tire and loading terminology
nf_BA.book Page 393 Friday, January 25, 2008 3:53 PM

418 OperationCleaning and care of the vehicle
4
Automatic car washYou can clean the vehicle in an automat-
ic car wash from the very start. It is pref-
erable to use a car wash that does not
have brushes.
If the vehicle is very dirty, prewash it be-
fore you drive into the car wash.\1
Remove the radio / telephone anten-
na and fold the exterior mirrors in be-
fore driving into the automatic car
wash.For information on windshield wiper
switch, see the “Controls in detail” sec-
tion (
\2
page 210).
!
CAUTION
Make sure that the automatic car
w a s h i s s u i t a b l e f o r t h e s i z e o f t h e ve -
hicle.
If you do not remove the radio / tele-
phone antenna and fold in the exteri-
or mirrors, there is a possibility that
the antenna, the exterior mirrors or
the vehicle could be damaged by the
automatic car wash.
!
CAUTION
Make sure that the windshield wiper
switch is set to
0 (\2
page 210), oth-
erwise the rain sensor could be acti-
vated, for example, and the
windshield wipers could be triggered
unintentionally. This could cause
damage to the vehicle.
nf_BA.book Page 418 Friday, January 25, 2008 3:53 PM

424 OperationCleaning and care of the vehicle
4
Heavy soiling
\1
Wipe plastic parts with a damp, lint-
free cloth (e.g. a micro-fiber cloth).
Dashboard and padded boss of the
steering wheel
\1
Moisten a clean and lint-free cloth
with water and clean the plastic
parts and the dashboard.
\1
Use a mild soap solution for particu-
larly stubborn dirt.
Radio* display and rear view cam-
era* monitor
\1
Switch off the Radio* or the rear
view camera monitor* and allow it to
cool off.
!
CAUTION
Use a low-foaming grease solvent
(e.g. washing-up liquid) diluted in wa-
ter as a cleaning agent.
The surface color may temporarily
change shade during cleaning. Sim-
ply wait for the surface to dry.
!
CAUTION
Use a solvent-free and non-caustic
cleaning agent. The manufacturer
recommends that you use a
Mercedes-Benz product.
The surface color may temporarily
change shade during cleaning. Sim-
ply wait for the surface to dry.
Warning
G
Do not use cleaners or cockpit care
sprays containing solvents to clean the
dashboard or the padded boss of the
steering wheel. Cleaners containing sol-
vents can make the surface porous, which
could lead to serious injuries if plastic
parts were to come loose when an airbag
is triggered.
nf_BA.book Page 424 Friday, January 25, 2008 3:53 PM

452 Practical hintsWhat to do if ...
5
The Parktronic* warning displays indicate im-
plausible distances.
For example, all the segments may be lit even
though there is no obstacle present.
The Parktronic* sensors are dirty or iced up.
\1Clean the Parktronic* sensors
(\2page 422).
\1Switch on the ignition again.
An external radio or ultrasonic source may be
causing interference.
\1Check whether Parktronic* works at
another location.
The license plate or other attachment parts
near the sensors may not be secured correct-
ly.
\1Check the number plate and attach-
ment parts near the sensors to see if
they are securely in place.
The speed cannot be set with cruise control*
activated
1.
The display is showing a message of high prior-
ity and cannot therefore show a change in
speed.
\1Proceed as instructed by the message
in the display.
\1Deactivate cruise control* if neces-
sary.
1 Only on vehicles with steering wheel buttons.Problem
Possible cause / result
Suggested solutions
nf_BA.book Page 452 Friday, January 25, 2008 3:53 PM

495 Practical hints
Display messages
5
Tire pres.
monitor
currently
unavailable
The TPMS or Advanced TPMS* is unable to moni-
tor the tire pressure due to
\4a nearby radio interference source.
\4excessive wheel sensor temperatures.
\1As soon as the causes of the malfunction
have been removed, the TPMS automati-
cally becomes active again after a few min-
utes of driving.
Tire pres.
monitor
inoperative
No wheel
sensors
There are wheels without appropriate wheel sen-
sors mounted (for example winter tires).
\1Have the TPMS checked at an authorized
Sprinter Dealer.
\1Have the wheel sensors installed by an au-
thorized Sprinter Dealer.
Wheel sens.
missing
One ore more sensors are malfunctioning (for ex-
ample battery discharged).
One or more wheels without appropriate wheel
sensors mounted (for example spare tire)
\1Have the TPMS checked by an authorized
Sprinter Dealer.
\1Have the wheel sensors installed by an au-
thorized Sprinter Dealer.
The tire pressure for the respective tire is
shown in the multifunction display.
Display messages
Possible cause / result
Possible solution
nf_BA.book Page 495 Friday, January 25, 2008 3:53 PM

592 Practical hintsFuses
5
No.
Consumer
Amp.
1
Horn
15 A
2
Electric steering lock ESTL
(electronic ignition switch
EIS)
25 A
3
Terminal 30 Z, vehicles
with gasoline engine/
electronic ignition switch
EIS
10 A
4
Light switch/center con-
sole switch unit
5A
5
Windshield wipers
30 A
6
Fuel pump
15 A
7
MRM (jacket tube mod-
ule)
5A
8
Terminal 87 (2)
20 A
No.
Consumer
Amp.
9
Terminal 87 (3)
20 A
10
Terminal 87 (4)
10 A
11
Terminal 15 R vehicle
15 A
12
Airbag control unit
10 A
13
Cigarette lighter/glove
box lighting/radio*
15 A
14
Diagnostic socket/light
switch/instrument cluster
5A
15
Front heating system*
5A
16
Terminal 87 (1)
10 A
17
Airbag control unit
10 A
18
Terminal 15 vehicle, brake
lamp switch
7,5 A
No.
Consumer
Amp.
19
Interior lights
7,5 A
20
Power window co-driver’s
side/terminal 30/2 signal
acquisition and actuation
module
25 A
21
Engine control unit
5A
22
Antilock Brake System
(ABS), brake lamp switch
5A
23
Starter motor
25 A
24
Diesel engine
components
10 A
25
12V socket on the bottom
of the center console
25 A
nf_BA.book Page 592 Friday, January 25, 2008 3:53 PM