2008 DODGE SPRINTER high beam

19 At a glance
Cockpit
1
Function
Page
1
Door control panel
31
2
Light switch
130
3
Combination switch\4
Turn signals
\4
High-beam head-
lamps
\4
Windshield wipers
\4
Rear window wiper*
135
131
210
212
4
Cruise control lever*
249
5
Horn
6
Steering wheel without/
with* buttons
25
Function
Page
7
Instrument cluster
20,
142
8
Storage compartment
9
Storage compartment
with interior lamp
137
Overhead control panel*
27
a
Rear-view mirror*
208
b
Rear view camera moni-
tor*
261
c
Warning display for Park-
tronic system*
256
d
Opens / closes the right-
hand side window
244
Function
Page
e
Jack and vehicle tool kit
515
f
Glove box
288
g
Center console
26
h
Selector lever (automatic
transmission)
185
j
Ignition lock
111
k
Additional switch unit
29
l
Handbrake
191
m
Steering wheel adjust-
ment
127
n
Hood lock release
318
o
Additional switch unit
29
nf_BA.book Page 19 Friday, January 25, 2008 3:53 PM

24 At a glanceInstrument cluster
1
Indicator and warning lamps
Page
Water in the fuel
482
#
Battery charge mal-
function
469
.
Defective bulb
483
Handbrake applied
191
B
Low-beam headlamps
on
131
™
Operating speed gov-
ernor on*
273
A
High-beam headlamps
on
131
<
Seat belt reminder
482
iVehicles with steering wheel buttons:
Corresponding messages may also
be shown in display
9

(
\2
page 157).
nf_BA.book Page 24 Friday, January 25, 2008 3:53 PM

131 Controls in detail
Lighting
3
Switching on the low-beam head-
lamps
\1
Turn light switch to
B
.
The
B
indicator lamp in the in-
strument cluster lights up.
Switching on the high-beam head-
lampsThe combination switch is located on
the left of the steering wheel.
1High-beam headlamps
2Headlamp flasher\1
Turn key to position
1 in ignition lock
(
\2
page 111).
\1
Turn light switch to
B
.
U
Automatic headlamp control*
M
Lights off
C
Parking lamps, license plate
and instrument lighting on
B
Low-beam headlamps on
N82.10-2527-31
nf_BA.book Page 131 Friday, January 25, 2008 3:53 PM

171 Controls in detail
Operating system with steering wheel buttons*
3
Setting constant headlamp mode*If you have set constant headlamp mode
and the light switch is at
M
, the fol-
lowing light up automatically when the
engine is running:
\4
The parking lamps and low-beam
headlamps
\4
The tail lamps
\4
The license plate lamp
For safety reasons, it is only possible to
change this setting when the vehicle is
stationary. The factory setting is
Con-
stant
in countries in which constant
headlamp mode is mandatory.
\1
Press the
æ
or
ç
to select the
Lighting
submenu.
\1
Press the
j
or
k
button re-
peatedly until you see the
Hdlmp.
mode
message in the display.
The current setting is highlighted.
\1
Press the
æ
or
ç
but ton to se -
lect whether you wish to operate the
lighting manually or whether you
wish to set constant headlamp
mode.
N54.32-2268-31
iFor safety reasons, it is not possible
to reset the
Hdlmp. mode
function to
the factory setting while the vehicle
is in motion. You will see the follow-
ing message in the display:
Setting
only possible at standstill
nf_BA.book Page 171 Friday, January 25, 2008 3:53 PM

172 Controls in detailOperating system with steering wheel buttons*
3
Switching the locator lighting on or
off*If you switch the locator lighting to
On,
the following lamps light up in the dark
after you have unlocked the vehicle us-
ing the key:
\4
The parking lamps
\4
The tail lamps
\4
The license plate lamp
\4
The front foglampsThe locator lighting automatically
switches off after 40 seconds or when
you:
\4
open the driver’s door
\4
insert the key into the ignition lock
\4
lock the vehicle with the key
\1
Press the
æ
or
ç
to select the
Lighting
submenu.
\1
Press the
j
or
k
button re-
peatedly until you see the
Loc.
lighting
message in the display.
The current setting is highlighted. USA only:
If you turn the light switch to
C

or
B
, the corresponding light
switches on. Constant headlamp
mode remains activated if the light
switch is turned to
U
.
Canada only:
If you turn the light switch to
B
,
the low-beam headlamps are
switched on. Constant headlamp
mode remains activated if the light
switch is turned to
C
or
U
.
nf_BA.book Page 172 Friday, January 25, 2008 3:53 PM

211 Controls in detail
Good visibility
3
Single wipe
\1
Push the combination switch briefly
to the pressure point in the direction
of arrow
1
.
The windshield wipers wipe once
without washer fluid.
Wiping with washer fluid
\1
Press the combination switch be-
yond the pressure point in the direc-
tion of arrow
1
.
The windshield wiper will wipe with
windshield washer fluid.
Vehicles with headlamp cleaning
system*:
If the low-beam headlamps have
been switched on, a high-pressure
water jet also cleans the headlamps. For example, if you have selected
speed
II and stop the vehicle,the wip-
ers wipe at intermittent speed until
you pull away again. The wipe intervals
are longer in intermittent mode.
Vehicles with rain sensor*:
You can use speed
I as the universal
speed. The rain sensor adjusts the
wiping frequency according to how
heavy the rain is. If you stop the vehi-
cle, speeds
III and
II are automatical-
ly switched down to speed
I.
The original speed of the windshield
wipers is resumed when you drive
faster than 5 mph (8 km / h) again.
iWipe with windshield washer fluid even
when it is raining. By doing so you can
prevent smears on the windshield.
nf_BA.book Page 211 Friday, January 25, 2008 3:53 PM

503 Practical hints
Display messages
5
.
Low beam left
The left-hand low-beam headlamp is mal-
functioning.
\1Change the bulb as soon as possible.
Low beam right
The right-hand low-beam headlamp is mal-
functioning.
\1Change the bulb as soon as possible.
Turn signal left
The left-hand turn signal is malfunctioning.
\1Change the bulb as soon as possible.
Turn signal right
The right-hand turn signal is malfunctioning.
\1Change the bulb as soon as possible.
Brake lamp left
The left-hand brake lamp is malfunctioning.
\1Change the bulb as soon as possible.
Brake lamp right
The right-hand brake lamp is malfunctioning.
\1Change the bulb as soon as possible.
Third brake lamp
The third brake lamp is malfunctioning. This
message will only appear if all LEDs have
failed.
\1Visit an authorized Sprinter Dealer as soon
as possible.
High beam left
The left-hand high-beam headlamp is mal-
functioning.
\1Change the bulb as soon as possible.
Display symbol
Display message
Possible cause / result
Possible solution
nf_BA.book Page 503 Friday, January 25, 2008 3:53 PM

504 Practical hintsDisplay messages
5
.
High beam right
The right-hand high-beam headlamp is mal-
functioning.
\1Change the bulb as soon as possible.
License plate
lamp
A license plate lamp is malfunctioning.
\1Change the bulb as soon as possible.
Foglamp front
left
The left-hand front foglamp is malfunction-
ing.
\1Change the bulb as soon as possible.
Foglamp front
right
The right-hand front foglamp is malfunction-
ing.
\1Change the bulb as soon as possible.\1
Rear foglamp
The rear foglamp is malfunctioning.
\1Change the bulb as soon as possible.
Parking lamp
front left
The front left-hand standing lamp/side
marker lamp is malfunctioning.
\1Change the bulb as soon as possible.
Parking lamp
front right
The front right-hand standing lamp/side
marker lamp is malfunctioning.
\1Change the bulb as soon as possible.
Reverse lamp
A reverse lamp is malfunctioning.
\1Change the bulb as soon as possible.
Display symbol
Display message
Possible cause / result
Possible solution
nf_BA.book Page 504 Friday, January 25, 2008 3:53 PM