2008 DODGE SPRINTER check oil

325 Operation
Engine compartment
4
Vehicles with steering wheel buttons*
\1
Press the button on the instru-
ment cluster (
\2
page 142).
\1
The following message is displayed
for the duration of the measurement
process:N
Engine oil level Measuring
in progress
The following messages may be dis-
played:NEngine oil
level OK
\1
Do not add oil.
Engine oil
Add
1.0 quart
\1
Add the amount of
oil shown
(\2
page 328).
\1
Check the engine oil
level again after a
few minutes.
Engine oil
Add
1.5 quartsEngine oil
Add
2.0 quarts
Engine oil
level Re-
duce oil
level
\1
The engine oil level is
too high. Have the oil
siphoned off.
Eng. oil
lev. Turn
ignition
on for lev-
el
\1
Switch on the igni-
tion (
\2
page 111).
N
nf_BA.book Page 325 Friday, January 25, 2008 3:53 PM

326 OperationEngine compartment
4
Checking the engine oil level with the
dipstickWhen the oil is being checked, the vehi-
cle must\4
be at normal operating temperature
\4
be standing level
\4
have been standing with the engine
switched off for at least five minutes
Observe
wait. pe-
riod
\1
Carry out another
measurement after
approximately 5 min-
utes when the en-
gine is at normal
operating tempera-
ture.
\1
Carry out another
measurement after
approximately
30 minutes when the
engine has cooled
down.
N
Engine oil
level Not
when eng.
running
\1
Switch off the engine
and wait for approxi-
mately 5 minutes if
the engine is at nor-
mal operating tem-
perature.
iEngine oil level display:\4
quart(s)
in USA only
\4
liter(s)
in Canada only
N
nf_BA.book Page 326 Friday, January 25, 2008 3:53 PM

328 OperationEngine compartment
4
3
Engine oil dipstick
\1
Check the engine oil level.
The oil level is correct if the oil is be-
tween the lower
min
and upper
max

marks on the dipstick.
\1
Add engine oil if necessary
(\2
page 328).
Adding engine oilFor specifications of engine oils see
"Service products and capacities"
(\2
page 604).
\1
Unscrew the cap on engine oil filler
neck
1
.
Make sure that you only fill the en-
gine oil as far as the upper
max

mark.
\1
Unscrew the cap on filler neck
1
. N18.00-2041-31
!
CAUTION
Have any excess engine oil drained
or siphoned off at an authorized
Sprinter Dealer. Otherwise, the en-
gine or catalytic converter could be
damaged.
The alternator is underneath the en-
gine oil filler neck. For this reason,
add the engine oil carefully. There is
a risk of damage to the alternator
from engine oil dripping down.
nf_BA.book Page 328 Friday, January 25, 2008 3:53 PM

330 OperationEngine compartment
4
\1
Slowly unscrew cap
1
counter-
clockwise to reduce excess pres-
sure.
\1
Continue turning the cap and remove
it.
\1
Add coolant as far as the MAX mark.
\1
Twist cap
1
back on.
For coolant specifications, see "Service
products and capacities" (
\2
page 604).
Warning
G
When opening the coolant expansion tank
there is a risk of scalding from hot coolant
spraying out. The cooling system and the
coolant expansion tank are pressurized
when the engine is at normal operating
temperature.
Wear gloves and eye protection. Only
open the coolant expansion tank when
the coolant temperature is less than
122 °F (50 °C).
Warning
G
Coolant contains glycol and is therefore
toxic. Do not swallow coolant. Consult a
doctor immediately if any coolant is swal-
lowed.
Do not allow coolant to come into contact
with your skin, eyes or clothing. In the
event of contact with the eyes, rinse them
thoroughly with clean water. Clean skin
and clothes immediately with soap and
water. Change out of soiled clothing with-
out delay.
!
CAUTION
Check the cooling and heating sys-
tems regularly for leaks. If a large
quantity of coolant is lost, have the
cause traced and rectified at an au-
thorized Sprinter Dealer.
nf_BA.book Page 330 Friday, January 25, 2008 3:53 PM

334 OperationEngine compartment
4
Adapt the mixing ratio to the outside
temperature. Use:\4
Summerwash to protect against
smearing at temperatures above
freezing.
\4
Winterwash when there is a risk of
frost so that the water does not
freeze onto the windshield.
\1
Mix the windshield washer fluid in a
container and in the specified pro-
portions.
\1
Remove cap
3
.
\1
Fill up the windshield washer fluid.
\1
Press cap
3
back on.
Check assemblies regularly for leaks. In
the event of fluid loss (e.g. spots of oil
under the vehicle when it has been
parked), have the cause traced and rec-
tified immediately at an authorized
Sprinter Dealer which has the necessary
specialist knowledge and tools to carry
out the work required.The manufacturer recommends that you
use an authorized Sprinter Dealer for
this purpose. All work relevant to safety
or on safety-related systems must be
carried out at an authorized Sprinter
Dealer.
Warning
G
Windshield washer concentrate is highly
flammable. Fire, open flames and smok-
ing are prohibited when you are handling
windshield washer concentrate.
Vehicle assemblies
nf_BA.book Page 334 Friday, January 25, 2008 3:53 PM

401 Operation
Tires and wheels
4
Rotate tires before the characteristic
tire wear pattern becomes visible (shoul-
der wear on front tires and tread center
wear on rear tires).
The reasons for any rapid or unusual
wear should be corrected prior to rota-
tion being performed.
Thoroughly clean the mounting face of
wheels and brake disks, i.e. the inner
side of the wheels/tires, during each ro-
tation. Check for and ensure proper tire infla-
tion pressure, refer to "Recommended
tire inflation pressure" (
\2
page 361).
!
CAUTION
If your vehicle is equipped with the
tire pressure monitor*, each wheel
has an electronic component.
Tire mounting tools should not be ap-
plied in the area of the valve, as this
could damage the electronic compo-
nents.
Have the tires changed only at an
authorized Sprinter Dealer.
Warning
G
In order to avoid loosing a wheel and in or-
der to reduce the risk of fatal or serious
injuries or vehicle damage, please follow
these safety instructions:Always replace wheel bolts that are dam-
aged or rusted.Never apply oil or grease to wheel bolts.
Continued
nf_BA.book Page 401 Friday, January 25, 2008 3:53 PM

404 OperationWinter driving
4
\3 Winter drivingHave your vehicle winterproofed at the
onset of winter at an authorized Sprinter
Dealer. This service includes the follow-
ing:\4
Oil change, if the current engine oil
used has not been approved for win-
ter use
\4
The antifreeze / anti-corrosion con-
centration in the coolant is checked
\4
The addition of a concentrated
cleaning agent to the water in the
windshield washer system
\4
Battery check
\4
A tire changeYou will find information about diesel
fuel for use at low outside temperatures
in the “Technical data” section
(
\2
page 614).
Please also observe the information
about winter driving (
\2
page 406).
Winter tires should also be operated as
printed on the tire and loading informa-
tion placard
1 or on the tire inflation pres-
sure placard located on the driver’s door
B-pillar, refer to “Tires and wheels” (
\2
page 362). Not all M+S rated radial-
ply tires provide special winter perfor-
mance. Make sure the tires you use
show M+S and the mountain/snowflake
marking
.
on the tire side wall.
These tires meet specific snow traction
performance requirements of the Rub-
ber Manufacturers Association (RMA)
and the Rubber Association of Canada
(RAC) and have been designed specifi-
cally for use in snow conditions. Use of
winter tires is the only way to achieve
the maximum effectiveness of the ABS,
BAS, ASR and ESP
® in winter operation.
Winter tires1. For vehicles with a gross weight capacity less
than 10 000 lbs (4 536 kg) (USA only).
nf_BA.book Page 404 Friday, January 25, 2008 3:53 PM

441 Practical hints
What to do if ...
5
Problem
Possible cause / result
Suggested solutions
The transmission no longer changes gear cor-
rectly.
The transmission is losing oil.
\1Have the transmission checked imme-
diately at an authorized Sprinter Dealer.
The acceleration ability is deteriorating.
The transmission does not shift.
The transmission is in emergency mode.
It is only possible to shift into second gear or re-
verse gear.
\1Stop the vehicle.
\1Move the selector lever to positionP.
\1Switch off the engine.
\1Wait at least 10 seconds before restart-
ing the engine.
\1Move the selector lever to positionD or
R.
\1In positionD, the transmission shifts
into second gear; in positionR, the
transmission shifts into the reverse
gear.
\1Have the transmission checked imme-
diately at an authorized Sprinter Dealer.
nf_BA.book Page 441 Friday, January 25, 2008 3:53 PM