Page 2 of 257
5
F A M I L I A R I S A T I O N
Press once to lock the vehicle.
Press again to unlock the vehicle.
Remote control
A. Unfolding/folding the key.
B. Unlocking the vehicle.
C. Locking the vehicle.
57
Manual central locking
63
OPENING
In addition...
A long press on button C locks the vehicle and closes the windows.
Two successive presses on button C deadlocks the vehicle.
D. Activating/deactivating guide-me-home lighting.
59
Page 3 of 257
6
F A M I L I A R I S A T I O N
Unlock the vehicle with the remote control or the key.
Press up on the lever and lift the tailgate.
TailgateSpare wheel and tools
Access to the spare wheel
Lift the carpet, then remove the tool holder to gain access to the wheel.
OPENING
125
Access to the tools
The tools are located in a protective holder in the spare wheel.
Fuel tank
A. O p e n i n g t h e f u e l fi l l e r fl a p .
124
B. R e m o v i n g t h e fi l l e r c a p .If your spare wheel is of different dimensions to the wheels on the vehicle, it is essential to use it only on a temporary basis, and to not drive above 80 km/h (50 mph).
64
T o o p e n t h e f u e l fi l l e r fl a p , p u l l a t i t s notched edge. There is a fuel label on t h e i n s i d e o f t h e fl a p .
Locking filler cap
Turn the key a quarter turn to lock and u n l o c k t h e fi l l e r c a p .
When refuelling, place the cap on the c a r r i e r o n t h e i n s i d e f a c e o f t h e fi l l e r fl a p .
Fuel tank capacity: 60 litres approxi-mately.
Page 6 of 257
9
F A M I L I A R I S A T I O N
DASHBOARD
1. Steering lock and ignition switch.
2. Controls:
Page 11 of 257
14
F A M I L I A R I S A T I O N
SITTING COMFORTABLY
1. Unlock the steering column using the lever.
2. Adjust the position of the steering wheel for height and reach.
3. Lock the steering column with the lever.
Manual adjustment of steering wheel height and reach
56
Front seat belt
1. Locking.
87
Adjustment of front head restraints
Adjustment of rear head restraints
53
Height and angle.
A. Low position.
B. High position.
A. Height adjustment (5-door)
B. Holding the seat belt (3-door)
50
Page 20 of 257
23
I
D A S H B O A R D
Display lighting rheostat
On opening the driver’s door or unlocking with the remote control, for approximately 30 seconds the instrument panel is activated, dis-playing the mileage recorders and if applicable, the maintenance indica-tor spanner.
Central display
Display of warning lampsTrip mileage recorder reset button
Display of alerts and Status of functions
Display of warning lamps
INSTRUMENT PANEL
5 Trip mileage recorder
6 Fuel gauge
7 Engine oil level check
8 Coolant temperature
1 Rev counter
2 Cruise control or speed limiter settings
3 Speedometer
4 Maintenance indicator on switching on, then mileage recorder
Page 22 of 257
25
I
D A S H B O A R D
Driver’s seat belt not fastened
This lamp comes on if the driver's seat belt is not fas-tened when the ignition is switched on and while the vehicle is moving at up to 20 km/h (approx. 12 mph)
Above 20 km/h (12 mph), the war- n i n g l a m p fl a s h e s f o r a b o u t 1 2 0 s e -conds, accompanied by an audible signal.
Passenger seat belt not fastened/unfastened
On switching on the ignition, the war-ning lamp comes on when the pas-senger’s seat belt is not fastened.
It goes out when the engine is run-ning, doors closed, after 30 se-conds.
Then it comes on, if the belt is not fastened, while the vehicle is moving at up to 20 km/h (approx. 12 mph).
Above 20 km/h (12 mph), the warning l a m p fl a s h e s f o r a b o u t 1 2 0 s e c o n d s , accompanied by an audible signal.
Front passenger’s airbag deactivation warning lamp
(See "Safety").
Doors open detection
This warning lamp, when the engine is running, comes on if a door, the bonnet and/or the boot is open.
Front/side airbag fault warning lamp
(See "Safety").
Anti-lock Braking System
The ABS warning lamp li-ghts when the ignition is switched on and should go out after a few seconds.
If the warning lamp does not go out, there may be a system mal-function.
Diesel Preheater
Wait for it to go out before operating the starter.
Depollution system warning lamp
I f i t fl a s h e s o r l i g h t s u p w h i l e you are driving, this indica-tes a depollution system operating fault.
Urgently consult a CITROËN Dealer.
SERVICE warning lamp
If it comes on, this indi-cates a fault with one of the systems that do not h a v e a s p e c i fi c w a r n i n g lamp.
See the radio "Log of alerts" to dis-cover the origin of the corresponding alert message.
Child safety warning lamp
If child safety is activated, this warning lamp comes on then goes out approximately 10 seconds after starting the engine.
Page 26 of 257
28
I
D A S H B O A R D
Functioning if the service interval is exceeded
Each time the ignition is switched on, the maintenance symbol and the extra mileage travelled (with a minus i n f r o n t ) w i l l fl a s h .
For example: the preset service dis-tance has been exceeded by 300 km. Your vehicle must be serviced as soon as possible.
A few seconds after you have swit-ched on the ignition, the total mi-leage recorder returns to its normal operation and the maintenance symbol remains illuminated.
Resetting the mileage indicator to zero
Your CITROËN dealer performs this operation after each service. Howe-ver, if you carry out the servicing yourself, the procedure for resetting to zero is as follows:
- Switch off the ignition, then place the key on position S, steering lock.
- Press control 1 and keep it pressed.
- Switch on the ignition.
- Keep control 1 pressed until the zero appears and the maintenance symbol disappears.
- Switch off the ignition.
Maintenance intervals
If your vehicle is used in particularly harsh conditions, it is necessary to select the maintenance schedules for "special operating conditions" (see the Maintenance Guide) which consist of more frequent services.
Page 27 of 257
28
I
D A S H B O A R D
Functioning if the service interval is exceeded
Each time the ignition is switched on, the maintenance symbol and the extra mileage travelled (with a minus i n f r o n t ) w i l l fl a s h .
For example: the preset service dis-tance has been exceeded by 300 km. Your vehicle must be serviced as soon as possible.
A few seconds after you have swit-ched on the ignition, the total mi-leage recorder returns to its normal operation and the maintenance symbol remains illuminated.
Resetting the mileage indicator to zero
Your CITROËN dealer performs this operation after each service. Howe-ver, if you carry out the servicing yourself, the procedure for resetting to zero is as follows:
- Switch off the ignition, then place the key on position S, steering lock.
- Press control 1 and keep it pressed.
- Switch on the ignition.
- Keep control 1 pressed until the zero appears and the maintenance symbol disappears.
- Switch off the ignition.
Maintenance intervals
If your vehicle is used in particularly harsh conditions, it is necessary to select the maintenance schedules for "special operating conditions" (see the Maintenance Guide) which consist of more frequent services.
