2008 Citroen C4 Speed
[x] Cancel search: SpeedPage 64 of 257
63
IV
A C C E S S
If you decide to drive with the doors locked, remem-ber that in the event of an accident this renders a c c e s s m o r e d i f fi c u l t f o r t h e emergency services.
Locking the doors from the inside
With the doors closed, press button B once to operate the electric central locking and unlocking.
The doors can still be opened from inside.
The central locking will not operate if a door is open, or not properly closed.
The lamp on the control B can signal any of 3 statuses:
- I t fl a s h e s i f t h e d o o r s a r e o p e n when the vehicle is stationary, engine stopped.
- It lights up if the doors are locked and the ignition is switched on.
- It goes out if the doors are not locked.
DOORSNote: Control B is inactive if the vehicle has been locked with the remote control or with the key.
Personal security
When the vehicle is started, the system automatically locks the doors and tailgate as soon as you reach a speed of approx. 10 km/h (6 mph).
Note: If a door is opened, this door will automatically relock as soon as the vehicle reaches approx. 6 mph.
Activation/Deactivation of the function
After switching on the ignition, give a long press on the central unlocking button until a message is displayed.
This allows from the front, deactivation of the opening of the rear doors and the use of the rear windows.
It is activated by means of a press on control A located on the electric windows control panel. The warning lamp in the instrument panel lights up for approx. 10 seconds.
Each time the ignition is switched on, the warning lamp comes on for approx. 10 seconds.
Opening of the doors from the outside and operation of the rear electric windows remain possible from the front of the vehicle.
Electric child safety
Page 72 of 257
68
V
V I S I B I L I T Y
Function activated
If there is a malfunction, the "Dipped beams" w a r n i n g l a m p fl a s h e s .
Have the system checked by a CITROËN dealer.
You are recommended to have both Xenon bulbs changed if there has been a malfunction in either of them.
Function deactivated
This function is associated with headlamps that have Xenon bulbs.
Whether on dipped beam or main beam, your headlamps follow the di-rection of the road ahead.
Lighting quality when driving round bends is considerably improved.
Activation/Deactivation
This can be activated/deactivated in the "Main menu". See "Multifunction displays".
See "Multifunction displays".
DIRECTIONAL HEADLAMPS
The status of the function is memo-rised on switching off the ignition.
By default, this function is in activated mode.
Note: At zero or very low speed, or in reverse gear, this function is in-active.
Page 73 of 257
69
V
V I S I B I L I T Y
Windscreen wiper stalk
2 Fast speed
1 Normal speed
I Intermittent
0 OffAUTO Automatic wiping.
Position I: The timing of the inter-mittent wipe adjusts automatically to the speed of the vehicle.
Position 1 or 2: or when stationary, the windscreen wiper speed automati-cally reduces.
SCREEN WIPE
Deactivating automatic wiping
Go to position I then return to posi-tion 0.
WARNING:
Do not cover the rain sensor, which is visible from the outside of the wind-screen, behind the interior rear view mirror.
When washing the vehicle, switch off the ignition or deactivate auto-matic wiping.
Automatic wiping
AUTO position: press downwards to activate automatic wiping.
Press downwards: Automatic wipe activated.
Note: A press downwards triggers a single wipe, but without deactivating automatic wipe.As a safety precaution, the wiper system is deactivated approx. 1 minute after the ignition has been switched off.
On switching the ignition back on, to reactivate the function:
- return to the Off position,
- change to the position desired.
Page 105 of 257
98
IX
D R I V I N G
Manual gearbox
- Ensure that the gear lever is in the neutral position.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- I n t h e c a s e o f d i e s e l e n g i n e vehicles: turn the key to the drive p o s i t i o n . W a i t f o r t h e p r e - h e a t e r warning lamp to go off, if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine starts (but not for more than ten seconds).
- I n t e m p e r a t u r e s l o w e r t h a n 0 ° C , apply the clutch during the action on the starter in order to aid starting. Then release the clutch slowly.
DO NOT RUN THE ENGINE IN A SPACE THAT IS ENCLOSED OR INSUFFICIENTLY VENTILATED.
Automatic gearbox
- C h e c k t h a t y o u a r e i n p o s i t i o n P or N.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Advice
Vehicles equipped with a Turbo:
Turbo equipped engines MUST be allowed to return to idle for several seconds before switching off the ignition. Failure to do so could cause serious damage to the turbo unit.
Flicking the throttle pedal as the ignition is turned off can lead to severe damage to the turbo unit.
(6 speed) Electronic Gearbox System
- C h e c k t h a t y o u a r e i n p o s i t i o n N.
- F u l l y d e p r e s s t h e b r a k e p e d a l .
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Note: If the vehicle has been stationary for a long time, or if you have pressed the brake pedal a number of times while stationary, it will be necessary to press the brake pedal hard down in order to authorise the engine to start.
STARTING
Page 106 of 257
98
IX
D R I V I N G
Manual gearbox
- Ensure that the gear lever is in the neutral position.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- I n t h e c a s e o f d i e s e l e n g i n e vehicles: turn the key to the drive p o s i t i o n . W a i t f o r t h e p r e - h e a t e r warning lamp to go off, if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine starts (but not for more than ten seconds).
- I n t e m p e r a t u r e s l o w e r t h a n 0 ° C , apply the clutch during the action on the starter in order to aid starting. Then release the clutch slowly.
DO NOT RUN THE ENGINE IN A SPACE THAT IS ENCLOSED OR INSUFFICIENTLY VENTILATED.
Automatic gearbox
- C h e c k t h a t y o u a r e i n p o s i t i o n P or N.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Advice
Vehicles equipped with a Turbo:
Turbo equipped engines MUST be allowed to return to idle for several seconds before switching off the ignition. Failure to do so could cause serious damage to the turbo unit.
Flicking the throttle pedal as the ignition is turned off can lead to severe damage to the turbo unit.
(6 speed) Electronic Gearbox System
- C h e c k t h a t y o u a r e i n p o s i t i o n N.
- F u l l y d e p r e s s t h e b r a k e p e d a l .
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Note: If the vehicle has been stationary for a long time, or if you have pressed the brake pedal a number of times while stationary, it will be necessary to press the brake pedal hard down in order to authorise the engine to start.
STARTING
Page 107 of 257
99
IX
D R I V I N G
6 speed gearbox
Reverse gear
Lift the collar Acollar to engage reverse gear.
Do not select reverse gear until the vehicle is completely stationary.
Depress the clutch pedal and wait a few moments before gently engaging reverse gear.
5 speed gearbox
Reverse gear
Do not select reverse gear until the vehicle is completely stationary.
Depress the clutch pedal and wait a few moments before gently engaging reverse gear.
MANUAL GEARBOX
Page 108 of 257
98
IX
D R I V I N G
Manual gearbox
- Ensure that the gear lever is in the neutral position.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- I n t h e c a s e o f d i e s e l e n g i n e vehicles: turn the key to the drive p o s i t i o n . W a i t f o r t h e p r e - h e a t e r warning lamp to go off, if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine starts (but not for more than ten seconds).
- I n t e m p e r a t u r e s l o w e r t h a n 0 ° C , apply the clutch during the action on the starter in order to aid starting. Then release the clutch slowly.
DO NOT RUN THE ENGINE IN A SPACE THAT IS ENCLOSED OR INSUFFICIENTLY VENTILATED.
Automatic gearbox
- C h e c k t h a t y o u a r e i n p o s i t i o n P or N.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Advice
Vehicles equipped with a Turbo:
Turbo equipped engines MUST be allowed to return to idle for several seconds before switching off the ignition. Failure to do so could cause serious damage to the turbo unit.
Flicking the throttle pedal as the ignition is turned off can lead to severe damage to the turbo unit.
(6 speed) Electronic Gearbox System
- C h e c k t h a t y o u a r e i n p o s i t i o n N.
- F u l l y d e p r e s s t h e b r a k e p e d a l .
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Note: If the vehicle has been stationary for a long time, or if you have pressed the brake pedal a number of times while stationary, it will be necessary to press the brake pedal hard down in order to authorise the engine to start.
STARTING
Page 109 of 257
99
IX
D R I V I N G
6 speed gearbox
Reverse gear
Lift the collar Acollar to engage reverse gear.
Do not select reverse gear until the vehicle is completely stationary.
Depress the clutch pedal and wait a few moments before gently engaging reverse gear.
5 speed gearbox
Reverse gear
Do not select reverse gear until the vehicle is completely stationary.
Depress the clutch pedal and wait a few moments before gently engaging reverse gear.
MANUAL GEARBOX