2008 Citroen C4 clutch
[x] Cancel search: clutchPage 105 of 257
98
IX
D R I V I N G
Manual gearbox
- Ensure that the gear lever is in the neutral position.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- I n t h e c a s e o f d i e s e l e n g i n e vehicles: turn the key to the drive p o s i t i o n . W a i t f o r t h e p r e - h e a t e r warning lamp to go off, if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine starts (but not for more than ten seconds).
- I n t e m p e r a t u r e s l o w e r t h a n 0 ° C , apply the clutch during the action on the starter in order to aid starting. Then release the clutch slowly.
DO NOT RUN THE ENGINE IN A SPACE THAT IS ENCLOSED OR INSUFFICIENTLY VENTILATED.
Automatic gearbox
- C h e c k t h a t y o u a r e i n p o s i t i o n P or N.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Advice
Vehicles equipped with a Turbo:
Turbo equipped engines MUST be allowed to return to idle for several seconds before switching off the ignition. Failure to do so could cause serious damage to the turbo unit.
Flicking the throttle pedal as the ignition is turned off can lead to severe damage to the turbo unit.
(6 speed) Electronic Gearbox System
- C h e c k t h a t y o u a r e i n p o s i t i o n N.
- F u l l y d e p r e s s t h e b r a k e p e d a l .
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Note: If the vehicle has been stationary for a long time, or if you have pressed the brake pedal a number of times while stationary, it will be necessary to press the brake pedal hard down in order to authorise the engine to start.
STARTING
Page 106 of 257
98
IX
D R I V I N G
Manual gearbox
- Ensure that the gear lever is in the neutral position.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- I n t h e c a s e o f d i e s e l e n g i n e vehicles: turn the key to the drive p o s i t i o n . W a i t f o r t h e p r e - h e a t e r warning lamp to go off, if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine starts (but not for more than ten seconds).
- I n t e m p e r a t u r e s l o w e r t h a n 0 ° C , apply the clutch during the action on the starter in order to aid starting. Then release the clutch slowly.
DO NOT RUN THE ENGINE IN A SPACE THAT IS ENCLOSED OR INSUFFICIENTLY VENTILATED.
Automatic gearbox
- C h e c k t h a t y o u a r e i n p o s i t i o n P or N.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Advice
Vehicles equipped with a Turbo:
Turbo equipped engines MUST be allowed to return to idle for several seconds before switching off the ignition. Failure to do so could cause serious damage to the turbo unit.
Flicking the throttle pedal as the ignition is turned off can lead to severe damage to the turbo unit.
(6 speed) Electronic Gearbox System
- C h e c k t h a t y o u a r e i n p o s i t i o n N.
- F u l l y d e p r e s s t h e b r a k e p e d a l .
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Note: If the vehicle has been stationary for a long time, or if you have pressed the brake pedal a number of times while stationary, it will be necessary to press the brake pedal hard down in order to authorise the engine to start.
STARTING
Page 107 of 257
99
IX
D R I V I N G
6 speed gearbox
Reverse gear
Lift the collar Acollar to engage reverse gear.
Do not select reverse gear until the vehicle is completely stationary.
Depress the clutch pedal and wait a few moments before gently engaging reverse gear.
5 speed gearbox
Reverse gear
Do not select reverse gear until the vehicle is completely stationary.
Depress the clutch pedal and wait a few moments before gently engaging reverse gear.
MANUAL GEARBOX
Page 108 of 257
98
IX
D R I V I N G
Manual gearbox
- Ensure that the gear lever is in the neutral position.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- I n t h e c a s e o f d i e s e l e n g i n e vehicles: turn the key to the drive p o s i t i o n . W a i t f o r t h e p r e - h e a t e r warning lamp to go off, if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine starts (but not for more than ten seconds).
- I n t e m p e r a t u r e s l o w e r t h a n 0 ° C , apply the clutch during the action on the starter in order to aid starting. Then release the clutch slowly.
DO NOT RUN THE ENGINE IN A SPACE THAT IS ENCLOSED OR INSUFFICIENTLY VENTILATED.
Automatic gearbox
- C h e c k t h a t y o u a r e i n p o s i t i o n P or N.
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Advice
Vehicles equipped with a Turbo:
Turbo equipped engines MUST be allowed to return to idle for several seconds before switching off the ignition. Failure to do so could cause serious damage to the turbo unit.
Flicking the throttle pedal as the ignition is turned off can lead to severe damage to the turbo unit.
(6 speed) Electronic Gearbox System
- C h e c k t h a t y o u a r e i n p o s i t i o n N.
- F u l l y d e p r e s s t h e b r a k e p e d a l .
- D o n o t t o u c h t h e a c c e l e r a t o r .
- F o r D i e s e l e n g i n e s : t u r n t h e k e y t o position M . W a i t f o r t h e p r e - h e a t e r warning lamp to go off if it is on.
- A c t i o n t h e s t a r t e r b y t u r n i n g t h e key until the engine turns over (not for longer than ten seconds).
Note: If the vehicle has been stationary for a long time, or if you have pressed the brake pedal a number of times while stationary, it will be necessary to press the brake pedal hard down in order to authorise the engine to start.
STARTING
Page 109 of 257
99
IX
D R I V I N G
6 speed gearbox
Reverse gear
Lift the collar Acollar to engage reverse gear.
Do not select reverse gear until the vehicle is completely stationary.
Depress the clutch pedal and wait a few moments before gently engaging reverse gear.
5 speed gearbox
Reverse gear
Do not select reverse gear until the vehicle is completely stationary.
Depress the clutch pedal and wait a few moments before gently engaging reverse gear.
MANUAL GEARBOX
Page 122 of 257
111
IX
D R I V I N G
Deactivation of cruise control with memorised speed
- E i t h e r b y p r e s s i n g t h e b r a k e p e d a l or the clutch pedal.
- O r w i t h a p r e s s o n b u t t o n 3.
- O r w h e n E S P o r A S R i s a c t i v e .
Note: cruise control is disengaged when the gear lever is in neutral position.
These actions bring up the display "OFF" in zone A in the instrument panel.
These actions do not cancel your cruise speed which remains displayed on the instrument panel.
Cruise control must only be used where road conditions permit driving at a constant speed.
Do not use it on congested roads or when weather and road conditions are poor.
The driver must still remain attentive and in complete control of the vehicle.
You are recommended to keep your feet within range of the pedals.To avoid any interference with the pedals:To avoid any To avoid any
- ensure that any over-mats are c o r r e c t l y fi t t e d ,
- never superimpose one over-mat on another.
Reactivation of cruise control
- by recalling the memorised speed:
Following a deactivation, press on button 3. Your vehicle automatically resumes the memorised cruise speed displayed in zone A.
- by selecting the current speed:
Press on button 2 or 4 as soon as the desired speed is reached. The information "OFF" will then disappear from zone A.
In the event of a malfunction, a message is displayed, accompanied by a sound signal and lighting of the S E R V I C E w a r n i n g l a m p .
C o n s u l t y o u r C I T R O Ë N d e a l e r .
To cancel the function
- b y m o v i n g t h e c o n t r o l f r o m p o s i t i o n "REG" to position 0.
- b y s t o p p i n g t h e e n g i n e .
T h e c r u i s e s p e e d c h o s e n p r e -viously is no longer memorised.