Page 21 of 257
24
I
D A S H B O A R D
WARNING LAMPS
LH direction indicator
RH direction indicator
Dipped beam
I f t h i s w a r n i n g l a m p fl a s h e s , it is indicating a malfunctio-ning of the directional hea-dlamps.
Contact a CITROËN dealer.
Sidelamps
Foglamps (rear)
Main beam
Foglamps (front)
The direction indicator lamps all operate simultaneously when the hazard warning is on.
Lighting and signalling lamps
See "Visibility".
Alert warning lamps
Imperative stop warning lamp
When the warning lamp comes on, it is imperative to stop the vehicle and switch off the engine.
Contact a CITROËN dealer.
Warning lamp for handbrake, brake fl u i d l e v e l a n d b r a k i n g distribution fault
When the engine is running, this warning lamp indicates that the handbrake is applied or incomple- t e l y r e l e a s e d , t h a t t h e b r a k e fl u i d l e - v e l i s i n s u f fi c i e n t , o r t h a t t h e b r a k i n g system is malfunctioning.
If the warning lamp remains lit when the handbrake is released, stop immediately and contact a CITROËN the handbrake is released, stop released, stop
Dealer (See "Safety").
Page 121 of 257
1 1 0
IX
D R I V I N G
This driving assistance function allows you to drive at the speed of your choice without the need to action the accelerator.
This system is available above 4 0 k m / h ( 2 5 m p h ) , w i t h 4 t h g e a r or higher on a manual gearbox or 2 n d g e a r o r h i g h e r o n a n a u t o m a t i c gearbox.
Note: Information relating to the cruise control is displayed in zone A of the instrument panel.
To select the function
Turn control 1 to position "REG".
To select a cruising speed
At the time you select the function via the control 1, there is no cruise speed previously memorised:
Note: you can use successive presses to modify the cruise speed in steps of 1 mph and a continuous p r e s s t o j u m p i n s t e p s o f 5 m p h .
Accelerate to the desired speed, then press button 2 or button 4. The cruise speed will then be memorised and displayed in zone A on the instrument panel.
You can then release the accelerator pedal. The vehicle will automatically keep to that chosen speed.
Note: The vehicle speed may vary slightly from that memorised.
CRUISE CONTROL
Adjustment of the memorised speed while cruise control is in operation
To adjust the memorised speed, displayed in zone A, press on:
- b u t t o n 4 to increase the speed,
- b u t t o n 2 to decrease the speed.
To exceed the cruise speed temporarily
While cruise control is in use, it is always possible to go above the cruise speed simply by pressing the accelerator pedal (for example to overtake another vehicle). The speed displayed in zone A fl a s h e s .
You have only to release the accelator pedal to return to your cruise speed.
Note: if during cruise control the system cannot keep to the cruise speed (e.g. on a steep descent), t h e n t h e s p e e d fl a s h e s . I f n e c e s s a r y , brake to curb your speed.
Page 133 of 257
122
X
M A I N T E N A N C E
Protection cover
HDi 135 and 140 engines
Remove the protection cover by fi r s t u n c l i p p i n g p o i n t 1, then 3 and4 . D e t a c h p o i n t 2 by pulling towards you, then lift.
To reposition the protection cover, attach point 2 fi r s t . L o w e r t h e c o v e r , keeping it centred. Clip points 1 and4, pushing vertically and slightly rearwards. Clip point 3 pushing down vertically.
HDi engines are of a highly technical nature.
A l l m a i n t e n a n c e a n d r e p a i r s r e q u i r e s p e c i fi c q u a l i fi c a t i o n s which only your CITROËN Dealer can guarantee. A l l m a i n t e n a n c e a n d r e p a i r s r e q u i r e s p e c i fi c q u a l i fi c a t i o n s A l l m a i n t e n a n c e a n d r e p a i r s r e q u i r e s p e c i fi c q u a l i fi c a t i o n s
Bleeding of water from the diesel f u e l fi l t e r
To be bled on a regular basis (at every oil change).
To evacuate the water, slacken the bleed screw or the water in diesel fuel sensor, which is located at the b a s e o f t h e fi l t e r , u n t i l w a t e r c e a s e s t o fl o w o u t .
Then retighten the bleed screw or the water in diesel fuel sensor.
DIESEL INJECTION EQUIPMENTWear of brake discs, brake pads and brake drums
The rate of wear of the brake pads depends on the use of your vehicle (urban use, frequent stops), and on your style of driving or the type of journey.
For information on checking the discs and drums for wear, contact a CITROËN dealer.
After washing the vehicle, brake progressively to dry out the brake linings.
Page 134 of 257
122
X
M A I N T E N A N C E
Protection cover
HDi 135 and 140 engines
Remove the protection cover by fi r s t u n c l i p p i n g p o i n t 1, then 3 and4 . D e t a c h p o i n t 2 by pulling towards you, then lift.
To reposition the protection cover, attach point 2 fi r s t . L o w e r t h e c o v e r , keeping it centred. Clip points 1 and4, pushing vertically and slightly rearwards. Clip point 3 pushing down vertically.
HDi engines are of a highly technical nature.
A l l m a i n t e n a n c e a n d r e p a i r s r e q u i r e s p e c i fi c q u a l i fi c a t i o n s which only your CITROËN Dealer can guarantee. A l l m a i n t e n a n c e a n d r e p a i r s r e q u i r e s p e c i fi c q u a l i fi c a t i o n s A l l m a i n t e n a n c e a n d r e p a i r s r e q u i r e s p e c i fi c q u a l i fi c a t i o n s
Bleeding of water from the diesel f u e l fi l t e r
To be bled on a regular basis (at every oil change).
To evacuate the water, slacken the bleed screw or the water in diesel fuel sensor, which is located at the b a s e o f t h e fi l t e r , u n t i l w a t e r c e a s e s t o fl o w o u t .
Then retighten the bleed screw or the water in diesel fuel sensor.
DIESEL INJECTION EQUIPMENTWear of brake discs, brake pads and brake drums
The rate of wear of the brake pads depends on the use of your vehicle (urban use, frequent stops), and on your style of driving or the type of journey.
For information on checking the discs and drums for wear, contact a CITROËN dealer.
After washing the vehicle, brake progressively to dry out the brake linings.