2008 Citroen BERLINGO FIRST DAG Owner's Manual

COMFORT AND SAFETY64 -

65COMFORT AND SAFETY-
FRONT LAYOUT
4. Courtesy lights 5. Sun visors
Permanently off.
On entering the vehicle: - they come on when the vehicle is unlocked or
when a door is opened,
- they switch off after approximately 30 seconds with the doors closed,
or when the ignition is switched on.
On leaving the vehicle:
- they come on when the key is removed from the ignition (timing
of approximately 30 seconds) or
when a door is opened,
- they switch off after approximately 30 seconds with all of the doors
closed, or immediately when the
vehicle is locked.
In this position, the courtesy light
may fl ash while driving if a door is not
closed correctly.
If a door is open, it will switch off auto-
matically after approximately 10 minutes
or when the ignition is switched on. Permanently on when the
key is in the accessories po-
sition or the ignition is on.
1. Storage in the doors

A. Bottle holder.

B. Can holder.

C. Storage compartment.
2. Overhead storage
Maximum load: 5 kg .
3. Map reading lights
Turn the dial to the right or to the left
to switch them on.
Place the dial in the centre to switch
them off. 6. Glove box
7. Lighter
It permits the connection of a telephone
charger, a baby's bottle warmer, ...
8. Removable ashtray
Pull the cover to open the ashtray.
To empty, after opening, remove it by
pulling upwards.
9. Storage drawer (passenger)
To open the drawer, lift it slightly and
pull it forwards.

COMFORT AND SAFETY66 -
STEERING WHEEL HEIGHT ADJUSTMENT HEADLAMP ADJUSTMENT HORN
HAZARD WARNING LIGHTS
Press the button, the direction indicators
fl ash.
They can operate with the ignition off. Press one of the spokes or
the centre of the steering
wheel.

0 - With no load.

1 - With partial load.

2 - With average load.

3 - With maximum authorised load.

0 - 1 or 2 people in the front seats.

- - 3 people.

1 - 5 people.

2 - 5 people + maximum authorised
load.

3 - Driver + maximum authorised
load.

Initial setting is position 0.
Depending on the load in your vehicle,
it is recommended that the headlamp
beam is adjusted.
When stationary, lower the handle to
unlock the steering wheel.
Adjust to the desired height and
lift the handle to lock the steering
wheel.

67COMFORT AND SAFETY-
LASHING RINGS
It is recommended that the
load is immobilised by secur-
ing it fi rmly using the lashing
rings on the fl oor.
Use the 6 lashing rings on the luggage
compartment fl oor to secure your loads.
You can use suitable load retainers
(half-height partitions, grille, etc.)
supplied by the CITROËN network.

COMFORT AND SAFETY68 -

69COMFORT AND SAFETY-
1.
Trays between the front and
rear seats
2. Load-space cover

To install it:
- position the front ends of the load space cover on its support and press gently to put it in place,
- unfold the load space cover fully,
- position the rear ends of the load space cover on its support and press gently to put it in place.
To remove it:
- unclip the rear ends,
- fold the load space cover fully,
- unclip the front ends and remove the load space cover.
To store it, fold it like an accordion. Do not roll it .
3. Stowing rings
4. High load retaining net

The high load retaining net can be fi tted behind the front or rear seats.
Open the covers A of the corresponding Aupper fastenings.
Fit the ends of the metal bar in these fastenings.
Secure the two net strap hooks be-hind the front seats, with the rear seat folded, or in the stowing rings Bon the fl oor.
The rings are located directly below the corresponding upper fastenings.
Pull the two straps C taut.
5. Side door storage compartments
6. Seat back storage pockets

DRIVING70 -
HANDBRAKE
Illumination of this warning
light and of the STOP warn-
ing light, accompanied by
an audible signal (while the
vehicle is moving), indicates that the
handbrake is still applied or has not
been released fully.
ANTI-LOCK BRAKING SYSTEM (ABS) AND THE ELECTRONIC BRAKE FORCE DISTRIBUTION (EBFD)
The ABS, in conjunction with the
electronic brake force distribution,
increases the stability and manoeu-
vrability of your vehicle on braking,
in particular on poor or slippery road
surfaces.

Note: when changing wheels (tyres
and rims), make sure that these are
approved.
The anti-lock braking system comes
into operation automatically when
there is a risk of wheel lock.
When this warning light
comes on, connected to the

STOP and ABS warning
lights, it indicates that there
is a malfunction of the electronic
brake force distribution, which can
cause a loss of control of the vehicle
when braking.

Stop immediately.
In both cases, consult a CITROËN dealer.
When this warning light
comes on, accompanied by a
buzzer, it indicates that there
is a malfunction of the ABS,
which can cause a loss of control of
the vehicle when braking. Normal operation of the ABS may
make itself felt by slight vibrations
of the brake pedal.

In emergency braking, press
very fi rmly without releasing the
pressure.
Releasing
Pull the handle and press the button
to release the handbrake.
Applying
When parking, pull the handbrake to
immobilise your vehicle.

DRIVING72 -
SPEED LIMITER

The operating actions must be
carried out when stationary, with
the engine running, or with the ve-
hicle moving. The status of the function is displayed
on the instrument panel in accordance
with the following sequences:
Function selected,
displaying of the "Speed
Limiter" symbol.
Function deactivated,
last programmed speed - OFF (example at 66 mph
(107 km/h)).
Function activated
(example at 66 mph (107 km/h)).
Vehicle speed above
66 mph (107 km/h),
the programmed speed is
displayed fl ashing.
Operating fault detected,
OFF - the dashes fl ash.
Selecting the function


Place the dial in the LIMIT position.
The limiter is selected but is not yet
active. The display indicates dashes
or the last programmed speed.
Programming a speed
A speed can be programmed without
activating the limiter but with the en-
gine running.

 A brief or extended press of the
SET - button decreases the speed.

 A brief or extended press of the
SET + button increases the speed.
Activation/deactivation (off)
When you have programmed your
speed, pressing this button once acti-
vates the limiter and the programmed
speed is displayed, pressing the button
again deactivates it (OFF).