2008 CHRYSLER SEBRING CONVERTIBLE instrument cluster

To Arm the System:
1. Remove the keys from the ignition switch and exit the
vehicle.
2. Lock the doors by pressing the power door lock switch
or the LOCK button on the Remote Keyless Entry (RKE)
transmitter.
NOTE:The system will not arm if you lock the doors
with the manual door lock plungers.
3. Close all doors. The VSA Indicator Light in the instru-
ment cluster will flash rapidly for 16 seconds. This shows
that the system is arming. After 16 seconds, the indicator
light will flash slowly. This shows that the system is fully
armed.
NOTE:
²During the 16 second arming period, if a door is
opened or the ignition switch is turned ON, the system
will automatically disarm.
²Once armed, the system disables the unlock switch on
the driver door trim panel and passenger door trim
panel, the trunk release button on the instrument
panel, and the HomeLinkt/Garage Door Opener (if
equipped).
To Disarm the System:
Either press the UNLOCK button on the RKE transmitter
or insert a valid sentry key into the ignition switch lock
cylinder and turn the key to the ON or START position.
NOTE:
²The driver's door key cylinder and the trunk button on
the RKE transmitter cannot arm or disarm the system.
²The system remains armed during trunk entry. Press-
ing the trunk button will not disarm the system. If
someone enters the vehicle through the trunk and
opens any door, the alarm will sound.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 19
2

The ORC also turns on the AIRBAG warning
light in the instrument panel for six to eight
seconds for a self-check when the ignition is first
turned on. After the self-check, the AIRBAG
warning light will turn off. If the ORC detects a malfunction
in any part of the system, it turns on the AIRBAG warning
light either momentarily or continuously. A single chime
will sound if the light comes on again after initial start up.
It also includes diagnostics that will illuminate the instru-
ment cluster airbag warning light if a malfunction is noted.
The diagnostics also record the nature of the malfunction.
WARNING!
Ignoring the AIRBAG light in your instrument panel
could mean you won't have the airbags to protect you
in a collision. If the light does not come on, stays on
after you start the vehicle, or if it comes on as you
drive, have the airbag system checked right away.
²Impact Sensors
Two sensors, located on the front body structure, trigger
airbag deployment in direct frontal impacts and aid the
ORC in determining appropriate response to frontal
impact events. Additional sensors in the ORC determine
the level of airbag deployment and provide verification.
²Supplemental Front-Seat-Mounted Side and Head
Airbags
Front-seat-mounted side and head airbags provide en-
hanced protection to help protect an occupant during a
side impact. The seat-mounted side and head airbags are
marked with an SRS label sewn into the outboard side of
the seat.
54 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

CAUTION!
²Correctly position the cargo protector in the trunk
before stowing the top. Doing so closes a switch
that allows top operation (stowing) to proceed. If
the switch is not closed, a warning message dis-
plays in the instrument cluster to notify the driver.
²Always place items carefully into the trunk.
²Do not push items too far into the trunk, particu-
larly when the top is retracted into its stowage area
in the trunk.
²Do not use the area near the tonneau cover for
storage.
Failure to follow these cautions can cause damage to
the convertible top components, trunk contents, and
the vehicle interior.
CAUTION!
Before operating the Power Top:
1. Always check the tonneau cover area to be sure that it is
clear of debris or other items.
2. Make sure the ambient temperature is above 0ÉF (-18ÉC).
a. Never attempt to lower a frozen convertible top. Wait until
the top is thawed before lowering it into the stowage
compartment.
b. Make sure the convertible top is dry before lowering it
into the stowage compartment. Lowering the top when
damp, wet, or dirty can cause stains, mildew, and damage to
the inside of your vehicle.
3. Make sure there is sufficient clearance of at least 7.5 ft. (2.2
m) for the top to move up.
a. To prevent striking a low ceiling or automatic door opener
with the top, it is strongly recommended that you do not
operate the power top inside a garage or parking structure.
Failure to follow these cautions can cause damage to the
convertible top components, trunk contents, and the vehicle
interior.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 83
3

Cargo Protector
The cargo protector is located in the trunk. Before low-
ering the convertible top, you must unfold the cargo
protector and seat the tabs at each end of the cargo
protector in the V slots in the trunk liner. Doing so closes
a switch that allows top operation. If the switch is not
closed, a warning message displays in the instrument
cluster to notify the driver.
Positioning the Cargo Protector for Top Operation
Pull the cargo protector toward you to begin unfolding
the panels. Grasp the handle in the center of the outer-
most (top) panel and raise the cargo protector. Then,
align and seat the tabs at each end of the cargo protector
in the V slots in the trunk liner as shown in the illustra-
tion.
Cargo Protector
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85
3

Turning Confirmation Prompts On/Off
Turning confirmation prompts off will stop the system
from confirming your choices (e.g., the UConnecttsys-
tem will not repeat a phone number before you dial it).
²Press the PHONE button to begin.
²After the9Ready9prompt and the following beep, say
9Setup Confirmations.9The UConnecttsystem will
play the current confirmation prompt status and you
will be given the choice to change it.
Phone and Network Status Indicators
If available on the radio and/or on a premium display
such as the instrument panel cluster, and supported by
your cell phone, the UConnecttsystem will provide
notification to inform you of your phone and network
status when you are attempting to make a phone call
using UConnectt. The status is given for roaming, net-
work signal strength, phone battery strength, etc.
Dialing Using the Cellular Phone Keypad
You can dial a phone number with your cellular phone
keypad and still use the UConnecttsystem (while dial-
ing via the cell phone keypad, the user must exercise
caution and take precautionary safety measures). By
dialing a number with your paired Bluetoothtcellular
phone, the audio will be played through your vehicle's
audio system. The UConnecttsystem will work the same
as if you dial the number using voice recognition.
NOTE:Certain brands of mobile phones do not send the
dial ring to the UConnecttsystem to play it on the
vehicle audio system, so you will not hear it. Under this
situation, after successfully dialing a number the user
may feel that the call did not go through even though the
call is in progress. Once your call is answered, you will
hear the audio.
114 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
Do not adjust the steering wheel while driving. The
tilt/telescoping adjustment must be locked while
driving. Adjusting the steering wheel while driving
or driving without the tilt/telescoping adjustment
locked could cause the driver to lose control of the
vehicle.
ELECTRONIC SPEED CONTROL Ð IF EQUIPPED
When engaged, this device takes over the accelerator
operation at speeds greater than 25 mph (40 km/h).
Electronic Speed Control Operation
The Speed Control Lever is located on the right side of
the steering wheel.
To Activate:
Push and release the ONOFF button located on
the end of the Speed Control Lever. The
CRUISE indicator in the instrument cluster will
illuminate. To turn the system OFF, push and
Speed Control Location
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 151
3

UNDERSTANDING YOUR INSTRUMENT PANEL
CONTENTS
mInstrument Panel Features.................173
mBase Instrument Cluster..................174
mPremium Instrument Cluster...............175
mInstrument Cluster Descriptions............176
mElectronic Vehicle Information Center (EVIC) ±
If Equipped...........................187
NElectronic Vehicle Information Center (EVIC)
Displays............................188
NOil Change Required...................189
NTrip Functions.......................190NCompass Display.....................191
NPersonal Settings (Customer Programmable
Features)...........................194
mSetting The Analog Clock.................196
mRadio General Information................197
NRadio Broadcast Signals.................197
NTwo Types Of Signals..................197
NElectrical Disturbances..................197
NAM Reception.......................1974

INSTRUMENT PANEL FEATURES
1 Ð Air Outlet 6 Ð Radio 11 Ð Hazard Switch
2 Ð Side Window Demister Outlet 7 Ð Passenger Airbag 12 Ð Storage Compartment
3 Ð Instrument Cluster 8 Ð Glove Box 13 Ð Climate Control
4 Ð Ignition Switch 9 Ð Heated Seat Switch* 14 Ð Trunk Release Switch
5 Ð Analog Clock 10 Ð Electronic Stability Program Off Button* 15 Ð Power Top Switch
* If Equipped UNDERSTANDING YOUR INSTRUMENT PANEL 173
4