2008 CHEVROLET AVEO Owners Manual

Page 25 of 384

CHEVROLET AVEO 2008 1.G Owners Manual Q:What is wrong with this?
A:The lap belt is too loose. It will not give as much
protection this way.
{CAUTION:
You can be seriously hurt if your lap belt is
too loose. In a crash, you could slide und

Page 26 of 384

CHEVROLET AVEO 2008 1.G Owners Manual Q:What is wrong with this?
A:The belt is buckled in the wrong place.
{CAUTION:
You can be seriously injured if your belt is
buckled in the wrong place like this. In a crash,
the belt would go up over

Page 27 of 384

CHEVROLET AVEO 2008 1.G Owners Manual Q:What is wrong with this?
A:The belt is over an armrest.
{CAUTION:
You can be seriously injured if your belt goes
over an armrest like this. The belt would be
much too high. In a crash, you can slide

Page 28 of 384

CHEVROLET AVEO 2008 1.G Owners Manual Q:What is wrong with this?
A:The shoulder belt is worn under the arm.
It should be worn over the shoulder at all times.
{CAUTION:
You can be seriously injured if you wear the
shoulder belt under your

Page 29 of 384

CHEVROLET AVEO 2008 1.G Owners Manual Q:What is wrong with this?
A:The belt is behind the body.
{CAUTION:
You can be seriously injured by not wearing
the lap-shoulder belt properly. In a crash,
you would not be restrained by the shoulder

Page 30 of 384

CHEVROLET AVEO 2008 1.G Owners Manual Q:What is wrong with this?
A:The belt is twisted across the body.
{CAUTION:
You can be seriously injured by a twisted belt.
In a crash, you would not have the full width
of the belt to spread impact f

Page 31 of 384

CHEVROLET AVEO 2008 1.G Owners Manual Lap-Shoulder Belt
All seating positions in your vehicle have a
lap-shoulder belt.
If you are using a rear seating position with a detachable
safety belt and the safety belt is not attached, see
Rear S

Page 32 of 384

CHEVROLET AVEO 2008 1.G Owners Manual 4. Push the latch plate into the buckle until it clicks.
If you find that the latch plate will not go fully into
the buckle, see if you are using the correct buckle.Pull up on the latch plate to make