2008.5 Citroen C5 warning

52
3
C O M F O R T
PROGRAMMABLE HEATING *
With the engine off, programmable
heating preheats the coolant circuit
in order to optimise the engine op-
erating temperature prior to starting.
The programmable heating sys-
tem can be started immediately or
delayed thanks to its programming
function. With the engine idle or the vehicle
stationary, it is normal to hear a
high-pitched whistling noise and
to notice some smoke/emissions. Digital programmer
The heating system’s programmer is
located on the right-hand side of the
dashboard.

1. Time or remaining functioning
time.

2. Increase (time).

3. Select programme.

4. Programme number selected.

5. Immediate start-up of heating.

6. Time adjustment and reading
warning lamp.

7. Reduce (time).

8. Heating mode warning lamp.
9. Programmable heating system
warning lamp.

53
3
C O M F O R T
Adjusting the operating
duration

 Press button 3 and hold it down,
press button 2 or 7 at the same
time. Release button 3 . The time
and symbol 6 fl ash.

 Press again on button 3 and hold
it down, press button 2 or 7 at the
same time. Release button 3 .

 The programmed operating du-
ration is displayed and symbol 8
fl ashes.

 Adjust the operating duration
with button 2 or 7 .

 To memorise the setting, press
button 3 or wait until the display
goes off. Immediate start-up

 Press button 5 .
The screen displays the symbol 8
and the remaining operating dura-
tion. This can be adjusted. The maxi-
mum duration is 30 minutes.
The warning lamp 8 lights up and
remains lit for the whole duration of
the system’s operation. The dura-
tion of the system’s operation disap-
pears after 10 seconds.
Start-up of the heating system can
be programmed between 1 minute
and 24 hours in advance.
Adjusting the remaining
operating duration
When the heating mode is active,
the remaining operation duration
can be modifi ed by between 10 and
30 minutes using buttons
2 or 7 . Programming the start-up
time You can store up to three different
start-up times, but programme only
one delayed start-up time.
Factory settings
A :

54
3
C O M F O R T


Press button 3 several times until the
programme number corresponding
to the required programme time is
displayed. The chosen pre-selected
time is activated automatically after
10 seconds if no other buttons have
been pressed.
To confi rm that the mode is activated,
symbols 4 and 8 fl ash until the heat-
ing starts up.
When the heating starts up, the warn-
ing lamp 9 lights up on the dashboard
and the programmer screen.
 Press button 3 briefl y: the display
of the start-up time goes off.
In the event of a battery failure, the
factory settings are restored.
Stopping the heating system
while operating

 Press button 5 .
The warning lamp 8 and the screen
go out. When a programme is operating,
pressing button
2 or 7 displays the
heating start-up time. A second
press on these buttons displays the
time.
When a programme is not operat-
ing, pressing button 2 or 7 displays
the time.
When the heating is operating, the
remaining operating duration is dis-
played instead of the time.

58
3
C O M F O R T
This function provides the driver with a back massage. It only operates when the engine is running.
 Press on button A .
The warning lamp comes on and the massage function is activated for a period of 1 hour. During this time, massage is performed in cycles of 6 minutes (4 minutes of massage fol-lowed by 2 minutes break). In total, the system will perform 10 cycles.
After 1 hour, the function is deacti-vated. The warning lamp goes out.
Massage function The Welcome function The welcome function assists entry
and leaving the vehicle.
After switching off the ignition and
opening the driver’s door, the seat
moves back automatically and then
stays in this position, ready for the
next entry to the vehicle.
When switching on the ignition, the
seat moves forward to the memo-
rised driving position.
When moving the seat, take care
that no person or object hinders the
automatic movement of the seat.
This function is deactivated by de-
fault. You may activate or deactivate
this function using the "Main Menu"
on the instrument panel screen. To
do so, select "Vehicle parameters/
Comfort/Driver welcome".
Deactivation
You can deactivate the massage function at any time by pressing on button A .
Head restraint height and
angle adjustments on electric
seats

 To adjust the angle of the head
restraint, push back or pull for-
ward section C of the head
restraint until you reach the
desired position.

 To raise it, pull upwards.

 To lower it, press on the
control D to unlock it, and simul-
taneously on the head restraint
itself.

 To remove it, press on the
control D to unlock it, then pull it
upwards.

66
4
A C C E S S

 First press button A to fold the
key.
Locating your vehicle

 Press the closed padlock to locate
your locked vehicle in a car park.
This is indicated by switching on
of the interior lighting and fl ashing
of the direction indicators for a few
seconds.
The vehicle remains locked. Guide-me-home lighting Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip
which has a special code. When the
ignition is switched on, this code
must be recognised in order for
starting to be possible.
This electronic engine immobiliser
locks the engine management sys-
tem a few minutes after the ignition
is switched off and prevents starting
of the engine by anyone who does
not have the key. In the event of a mal-
function, you are in-
formed by lighting of
this warning lamp, an
audible signal and a message on
the multifunction screen.
In this case, your vehicle does not
start; contact a CITROËN dealer as
soon as possible.

Folding the key
A press on button B oper-
ates the guide-me-home
lighting (lighting of the
sidelamps, dipped beams
and number plate lamps).
A second press before the end of
the timing cancels the guide-me-
home lighting.
The timed duration can be set via the
"Lighting" menu on the "Main Menu"
of the instrument panel screen.

66
4
A C C E S S

 First press button A to fold the
key.
Locating your vehicle

 Press the closed padlock to locate
your locked vehicle in a car park.
This is indicated by switching on
of the interior lighting and fl ashing
of the direction indicators for a few
seconds.
The vehicle remains locked. Guide-me-home lighting Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip
which has a special code. When the
ignition is switched on, this code
must be recognised in order for
starting to be possible.
This electronic engine immobiliser
locks the engine management sys-
tem a few minutes after the ignition
is switched off and prevents starting
of the engine by anyone who does
not have the key. In the event of a mal-
function, you are in-
formed by lighting of
this warning lamp, an
audible signal and a message on
the multifunction screen.
In this case, your vehicle does not
start; contact a CITROËN dealer as
soon as possible.

Folding the key
A press on button B oper-
ates the guide-me-home
lighting (lighting of the
sidelamps, dipped beams
and number plate lamps).
A second press before the end of
the timing cancels the guide-me-
home lighting.
The timed duration can be set via the
"Lighting" menu on the "Main Menu"
of the instrument panel screen.

81
4
A C C E S S
FUEL TANK

Capacity of the tank: approxi-
mately 71 litres.
Low fuel level
When the minimum level
in the tank is reached,
this warning lamp comes
on in the instrument
panel, accompanied by an audible
warning and a message on the mul-
tifunction screen.

You have enough fuel left to drive
approximately 30 miles (approx.
50 km).
 Press at the top left corner, then
pull open from the left.
 turn the key a quarter turn to lock
and unlock the fi ller cap,

 when refuelling, place the cap on
hook A ,

 fi ll the tank, but do not persist
after the third cut-off ; this could
cause your vehicle to malfunc-
tion.

While you are refuelling, the en-
gine must be stopped and the ig-
nition switched off.

For a petrol engine with a cata-
lytic converter, unleaded fuel is
compulsory.
Opening the fuel flap
The fi ller neck is narrower to en-
sure that only unleaded petrol noz-
zles can be put in.
Refuelling

86
V I S I B I L I T Y
5
Linked with the automatic
"Guide-me-home" lighting
Link with the automatic lighting pro-
vides the "guide-me-home" lighting
with the following additional options:
- selection of the duration of light-ing for 15, 30 or 60 seconds in
the vehicle parameters on the
multifunction screen confi gura-
tion menu,
- automatic activation of "guide- me-home" lighting when auto-
matic lighting is in operation.
Operating fault
In the event of a malfunction of the
brightness sensor, the lamps come
on and a message appears on the
multifunction screen, accompanied
by an audible signal.
Consult a CITROËN dealer. In fog or snow, the brightness
sensor may detect suffi cient light.
Therefore, the lamps will not come
on automatically.
Do not cover the brightness sen-
sor, linked with the rain sensor and
located in the centre of the wind-
screen behind the interior mirror;
the associated functions would no
longer operate. MANUAL ADJUSTMENT OF THE HEADLAMPS
To avoid dazzling other road users,
the height of the halogen bulb head-
lamps must be adjusted according
to the load in the vehicle.

0.
1 or 2 people in the front seats.

-.
3 people.

1.
5 people.

-.
Intermediate setting.

2.
5 people + maximum authorised
loads.

-.
Intermediate setting.

3. Driver + maximum authorised
loads.
Initial setting is position "0".
AUTOMATIC ADJUSTMENT OF THE DIRECTIONAL HEADLAMPS
Do not touch the xenon bulbs.
Consult a CITROËN dealer. If a malfunction oc-
curs, this warning
lamp is displayed on
the instrument panel,
accompanied by an
audible signal and a
message on the multi-
function screen.
The system then places your head-
lamps in the lowest position.
In order to avoid causing a nuisance
to other road users, this system cor-
rects the height of the xenon head-
lamps beam automatically and when
stationary, in relation to the load in
the vehicle.