2007 YAMAHA YBR250 AUX

TABLE OF CONTENTES
Replacing the auxiliary lightb u l b ........................................... 6-28
Supporting the motorcycle .........6-29
Front wheel .................................. 6-29
Rear wheel .................................. 6-30
Troubleshooting ..........................6-31
Troubleshooting chart ................6-32
MOTORCYCLE CARE AND
STORAGE ........................................... 7-1
C a r e ............................................... 7 - 1
Storage .......................................... 7 - 3
SPECIFICATIONS .............................. 8-1
CONSUMER INFORMATION ............. 9-1 Identification numbers .................. 9 - 1
Vehicle identification number ...... 9 - 1
Model label .................................... 9 - 1
indice.pmd 24/1/2007, 14:37
2

3-1
3
INSTRUMENT AND CONTROL FUNCTIONS
EAU10460
Main switch/steering lockThe main switch/steering lock controls
the ignition and lighting systems, and is
used to lock the steering. The various
positions are described below.
OFF ON
LOCK
EAU10570
ON
All electrical circuits are supplied with
power; the meter lighting, taillight and
auxiliary ligth come on, and the engine
can be started. The key cannot be
removed.The headlight comes on automatically
when the engine is started and stays
on until the key is turned to “OFF”
EAU10660
OFF
All electrical systems are off. The key
can be removed.
EAU10680
LOCK
The steering is locked, and all electrical
systems are off. The key can be
removed.To loc
k the steer
ing
1. Turn the handlebars all the way to the left.
2. Push the key in from the “OFF” position, and then turn it to “LOCK”
while still pushing it.
3. Remove the key.
1. Push
2. Turn
To unloc
k the steer
ing
Push the key in, and then turn it to “OFF”
while still pushing it.
1. Push
2. Turn
EWA10060
Never turn the key to “OFF” or
“LOCK” while the vehicle is moving,
otherwise the electrical systems will
be switched off, which may result in
loss of control or an accident. Make
sure that the vehicle is stopped before
turning the key to “OFF” or “LOCK”.
cap 3.pmd 24/1/2007, 14:37
1

6-28
6
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU24281
Replacing a turn signal light
bulb or the tail/brake light
bulb1. Remove the lens by removing thescrews.
1
1.Screw
1
1. Screw2. Remove the defective bulb bypushing it in and turning it
counterclockwise. 3. Insert a new bulb into the socket,
push it in, and then turn it clockwise
until it stops.
4. Install the lens by installing the screws.
ECA10680
Do not overtighten the screws,
otherwise the lens may break.
EAU37270
Replacing the auxiliary light
bulb
1
1. Auxiliary light bulbIf the auxiliary light bulb burns out,
replace it as follows.1. Remove the headlight unit by removing the screws.
2. Remove the socket (together with the bulb) by pulling it out.
3. Remove the defective bulb by pulling it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the bulb) by pushing it in.
6. Install the headlight unit by installing the screws.
cap 6.pmd 24/1/2007, 14:38
28