
175 Gordon Baker Road
North York, Ontario M2H 2N7
1-800-663-8255
www.volvocanada.com
2006 ©  Volvo Car  Corporation
pg. 2 Introduction
General Information
Shiftlock (automatic transmission)
When your vehicle is parked, the gear selector is locked in the (P)ark position. To release the selector from  this
position, turn the ignition key  to position II (or start the engine), depress the brake pedal, press the button on the front
side of the gear selector and  move the selector from  ( P)ark.
Keylock (automatic transmission)
When the ignition is switched off, the gear selector must  be  in the ( P)ark position before the key  can be  removed from
the ignition switch.
Anti-lock Brake System (ABS)
The ABS  system in your vehicle performs a  self -diagnostic test when the vehicle first reaches the speed of
approximately 12 mph (20 km/h). The brake pedal will pulsate several times and  a  sound may be  audible  from  the
ABS  control module. This is normal.
Fuel filler door
The fuel filler  door, located on the right rear fender, is connected to your vehicle's central locking system.
Press the button on the light switch panel (see illustration on page 53
) when the vehicle is at a  standstill to unlock the
fuel filler  door. Please note that the fuel filler  door will remain unlocked until the vehicle begins to move forward. An
audible  click  will be  heard when the fuel filler  door relocks.
Fuel filler cap
After refueling, close the fuel filler  cap by turning it clockwise until it clicks into place. If this  cap is not closed tightly
or if the engine is running when the car is refueled, the Malfunction  Indicator Lamp ("Check Engine" light) may
indicate a  fault.
Important  information  
Before you operate  your vehicle for the first time, please familiarize yourself with the new-engine oil consumption
information on page 49
. You should also be  familiar with the information in chapters one,  two and  eight of this
manual.
Information contained in the balance of the manual  is extremely useful  and  should be  read after operating the vehicle
for the first time.
The manual  is structured so that it can be  used for reference. For this  reason, it should be  kept in the vehicle for ready
access.
Do not export your Volvo to another country before investigating that country's applicable safety and  exhaust emission
requirements. In some cases it may be  difficult or impossible to comply with these requirements. Modifications to the
emission control system(s) may render your Volvo not certifiable for legal  operation in the U.S., Canada and  other
countries.
All information, illustrations and  specifications contained in this  manual  are based on the latest product information
ProCarManuals.com 

2 0 0 7
VOLVO S60
Instruments and controls
pg. 41 Instruments and controls
Instrument overview 42
Instrument panel44
Indicator and  warning symbols45
Switches in the center  console50
Steering wheel adjustment52
Lighting  panel53
Left-side steering wheel lever55
Right-side steering wheel lever56
Hazard  warning flashers, rear window/sideview mirror defroster58
Trip computer59
Cruise control60
Parking brake, auxiliary socket/cigarette lighter62
Power windows63
Rearview mirror/sideview mirrors65
Power moonroof  (option)68
pg. 42 Instruments and controls
Instrument overview
ProCarManuals.com 

pg. 43 Instruments and controls
Instrument overview
1. Front fog lights54
2. Headlights/Parking lights/switch for unlocking fuel filler  door54
3. Rear fog light54
4. Turn  signals/High/low beams53
5. Cruise control60
6. Horn7
7. Instrument panel44
8. Audio controls in steering wheel218
9. Windshield wipers56
10. Parking brake (hand brake)62
ProCarManuals.com 

started within 5 seconds, all symbols except CHECK ENGINE and   go out. Certain  symbols may not have their
functions illustrated, depending on the vehicle's equipment. The symbol  for the parking brake goes out when the
parking brake is released.
Warning symbol 
in center of the instrument panel
This symbol  shines as a  red or yellow light depending on the severity of the discovered fault.
Red symbol  - Stop the vehicle as soon as possible in a  suitable location and  read the message shown in the text
window. The symbol  and  accompanying text will remain on until the fault has been corrected.
Yellow  symbol - Follow the instructions shown in the text window. The text can be  erased by pressing the READ
button (see page 48
), or will disappear automatically  after two minutes.
When the message "TIME FOR  REGULAR SERVICE" is displayed, the text can be  erased and  the yellow symbol
light can be  turned off by pressing the READ button. The text will disappear and  the symbol  light will go out
automatically  after two minutes.
 Seat belt reminder
This symbol  lights up to indicate that the driver has not fastened his/her seat belt.
 Supplemental Restraint System SRS
If this  light comes on while the vehicle is being driven, or remains on for longer than approximately 10 seconds after
the vehicle has been started, the SRS system's diagnostic functions have detected a  fault in a  seat belt lock or
tensioner, a  front  airbag, side impact airbag, and/or an  inflatable curtain. Have the system(s) inspected by a  trained and
qualified Volvo service technician as soon as possible.
pg. 46 Instruments and controls
Indicator and warning symbols
BRAKE Brake failure warning light
If the light comes on while driving or braking, stop immediately, open  the hood and  check the brake fluid level  in the
reservoir. See  page 173
 for reservoir position and  page 177 for instructions.
Canadian models are equipped with this  warning light.
If the BRAKE and ABS  warning lights come on at the same time, this could indicate a fault in the brake system.
- Stop the vehicle in a  suitable place and  switch off the engine.
- Restart the engine.
- If both warning lights go off, no further action  is required.
- If both lights are still  on after the engine has been restarted,  switch off the engine again and  check the brake fluid
level  (see page 173
 for the location of the brake fluid reservoir).
- If the brake fluid level  is above the MIN  mark, drive carefully to an  authorized Volvo retailer and  have the brake
system inspected.
WARNING!
ProCarManuals.com 

If the fluid level  is below  the MIN  mark in the reservoir or if a  "Brake failure - Service urgent" message is displayed
in the text window: DO  NOT DRIVE. Have the vehicle towed  to an  authorized Volvo retailer and  have the brake
system inspected.
PARK BRAKE  Parking brake applied  This light will be  on when the parking brake (hand brake) is applied.  The
parking brake lever is situated between the front  seats.  See  also page 62
 for additional information.
 Canadian models are equipped with this  symbol.
 Oil pressure warning light
If the light  comes on while driving, stop the vehicle  and then stop the engine immediately and check  the engine
oil level.  See  page 49
. R-models are also equipped with an  oil level  warning system. If the light stays on after restart,
have the vehicle towed  to the nearest authorized Volvo retailer. After hard driving, the light may come on occasionally
when the engine is idling. This is normal, provided it goes off when the engine speed is increased.
 Generator  warning light
If the light comes on while the engine is running, have the charging system checked.
 Rear fog light
This light indicates that the fog light is on.
CHECK ENGINE  Malfunction indicator light
On-Board  Diagnostics II (OBDII): As you drive, a  computer called "OBDII" monitors your vehicle's engine,
transmission, electrical and  emission systems. The CHECK ENGINE light will light up if the computer senses a
condition that potentially may need correcting. When this  happens, please have your vehicle checked by a  Volvo
retailer as soon as possible.
A CHECK ENGINE light may have many causes. Sometimes,  you may not notice  a  change in your vehicle's behavior.
Even so, an  uncorrected condition could hurt fuel economy, emission cleanliness, and  driveability. Extended driving
without correcting the cause could even damage other components in your vehicle.
Canadian models are equipped with this  warning light.
pg. 47 Instruments and controls
Indicator and warning symbols
 Anti-lock brake system ABS
If the warning light comes on, there is a  malfunction of the ABS  system (the standard braking system will still
function). The vehicle should be  driven to a  Volvo retailer for inspection. See  page 123
 for additional information.
 Stability Traction Control (STC)
1 system or  Dynamic Stability Traction Control (DSTC) system2
ProCarManuals.com 

WARNING!
Cruise control should not be  used in heavy traffic  or when driving on wet  or slippery roads, or when driving on
unpaved or uneven road surfaces. Cruise control may not maintain set speed on steep downgrades.
pg. 62 Instruments and controls
Parking brake, auxiliary socket/cigarette lighter
Parking  brake (hand  brake)
The lever is located between the front  seats.  The brake is applied  to the rear wheels.
When applying the parking brake 
- Press firmly on the brake pedal.
- Pull up the parking brake lever as far as possible.
WARNING!
Always apply the parking brake fully when the vehicle is parked. The indicator light will light up even if the parking
brake has only been partially applied.  Always pull up the lever as far as possible.
- Release the brake pedal and  ensure that the vehicle is at a  standstill.
- Put the gear selector in P (automatic transmission) or in 1st gear (manual transmission).
Parking  on a hill
 If the vehicle is pointing uphill, turn the front  wheels so that they point away from  the curb.
 If the vehicle is pointing downhill, turn the front  wheels so that they point toward the curb.
Releasing the parking brake
- Press firmly on the brake pedal. - Pull the lever up slightly,  press the button at the end  of the lever and  lower the lever
completely.
Auxiliary sockets
The 12 volt sockets  can be  used to plug in certain accessories such as cellular telephones, etc. The key  must  be  in
position I (or higher) for the auxiliary socket to function.
NOTE:  The cover should be  folded down when the auxiliary socket is not in use.
ProCarManuals.com 

2 0 0 7
VOLVO S60
Interior
pg. 79 Interior
Front seats 80
Interior lighting84
Storage compartments86
Rear seat and  trunk90
Spare wheel, tools  and  jack93
pg. 80 Interior
Front seats
Manually adjusted front seats
1. Front-rear adjustment: lift the bar and  move the seat to the position of your choice.
2. Raise/lower the front  edge of the seat cushion (option): use the control to pump the front  edge of the cushion up or
down.
3. Raise/lower seat height: pump the seat up or down.
4. Lumbar support: turn the control for firmer or softer lumbar support.
5. Backrest tilt: turn the control to adjust the angle of the backrest.
6. Control panel for optional power seat (see page 82
 for more information).
WARNING!
 Do not adjust the seat while driving. The seat should be  adjusted so that the brake pedal can be  depressed  fully. In
addition, position the seat as far rearward as comfort and  control allow.
 Check that the seat is securely locked into position after adjusting.
ProCarManuals.com 

 Because the driver's seat can be  adjusted with the ignition off, children should never be  left unattended in the
vehicle.
 Movement of the seat can be  STOPPED at any  time by pressing any  button on the power seat control panel.
 Do not adjust the seat while driving. The seat should be  adjusted so that the brake pedal can be  depressed  fully. In
addition, position the seat as far rearward as comfort and  control allow.
 The seat rails on the floor  must  not be  obstructed in any  way when the seat is in motion.
Programming the memory (option)
Three different  seating and  door mirror positions can be  stored  in the driver seat's memory.
The following example explains how button 1 can be  programmed. Buttons 2 and  3 can be  programmed in the same
way.
To program (store) a  seat position in button 1:
- Move the seat to the desired position using the seat adjustment controls (see the previous  page).
- Press and  hold down the MEM (memory) button.
- With the MEM button depressed,  press button 1 briefly to store  the seat's current position.
To move the seat to the position that it was in when button 1 was programmed:
Press and  hold down button 1 until the seat stops moving.
As a  safety precaution, the seat will stop automatically  if the button is released before the seat has reached the preset
position.
pg. 84 Interior
Interior lighting
Reading lights and courtesy light
ProCarManuals.com