2007 VOLVO C70 CONVERTIBLE tire pressure

2007 Volvo C70
156 07 Wheels and tires
Tire inflation
Tire inflation pressure tables - U.S. models
The following tire pressures are recommended by Volvo for your vehicle. \
Refer to the tire inflation
placard for information specific to the tires installed on your vehicle \
at the factory.
Load ratings
The load ratings in the tables above translate as follows:
91 = 1365 lbs (615 kg),
93 = 1433 lbs (650 kg),
99 = 1709 lbs (755 kg)
Speed ratings
The speed ratings in the tables translate as follows:
M = 81 mph (130 km/h),
V= 149 mph (240 km/h),
W= 168 mph (270 km/h)
See also
page 158 for an explanation of the designations on the sidewall of the tire.
The following tire pressures are recommended by Volvo for your vehicle. \
Refer to the tire inflation
placard for information specific to the tires installed on your vehicle \
at the factory.
file:///K|/delme/2007_C70/07c70_07.htm (7 of 30)12/22/2006 9:15:51 PM

2007 Volvo C70
157 07 Wheels and tires
Tire inflation
Tire inflation pressure table - Canadian models
The following tire pressures are recommended by Volvo for your vehicle. \
Refer to the tire inflation
placard for information specific to the tires installed on your vehicle \
at the factory
158 07 Wheels and tires
Tire designations
file:///K|/delme/2007_C70/07c70_07.htm (8 of 30)12/22/2006 9:15:51 PM

2007 Volvo C70
Federal law mandates that tire manufacturers place standardized informat\
ion on the sidewall of all tires
(see the illustration).
The following information is listed on the tire sidewall:
The tire designation (the following figures are examples of a tire desi\
gnation):
1. 215: the width of the tire (in millimeters) from sidewall edge to sidewal\
l edge. The larger the number,
the wider the tire.
2. 65: The ratio of the tire's height to its width.
3. R: Radial tire.
4. 15: The diameter of the wheel rim (in inches).
5. 95: The tire's load index. In this example, a load index of 95 equals a ma\
ximum load of 1521 lbs (690
kg).
6. H: The tire's speed rating, or the maximum speed at which the tire is des\
igned to be driven for extended
periods of time, carrying a permissible load for the vehicle, and with c\
orrect inflation pressure. For
example, H indicates a speed rating of 130 mph (210 km/h).
NOTE
This information may not appear on the tire because it is not required b\
y
law.
7. M+S or M/S = Mud and Snow, AT = All Terrain, AS = All Season
8. U.S. DOT Tire Identification Number (TIN): This begins with the letters "DOT" and indicates that
the tire meets all federal standards. The next two numbers or letters ar\
e the plant code where it was
manufactured, the next two are the tire size code and the last four numb\
ers represent the week and year
the tire was built. For example, the numbers 317 mean the 31st week of 1\
997. After 2000 the numbers go
to four digits. For example, 2501 means the 25th week of 2001. The numbe\
rs in between are marketing
codes used at the manufacturer's discretion. This information helps a ti\
re manufacturer identify a tire for
safety recall purposes.
9. Tire Ply Composition and Material Used: Indicates the number of plies indicates or the number of
layers of rubber-coated fabric in the tire tread and sidewall. Tire manu\
facturers also must indicate the ply
materials in the tire and the sidewall, which include steel, nylon, poly\
ester, and others.
file:///K|/delme/2007_C70/07c70_07.htm (9 of 30)12/22/2006 9:15:51 PM

2007 Volvo C70
10. Maximum Load: Indicates the maximum load in pounds and kilograms that can be carried\
by the tire.
Refer to the vehicle's tire information placard or the safety certificat\
ion label, located on the B-Pillar or
the driver's door or on the inside of the fuel filler door on Canadian m\
odels, for the correct tire pressure
for your vehicle.
11. Treadwear, Traction, and Temperature grades: See
page 163 for more information.
12. Maximum permissible inflation pressure: the greatest amount of air pressure that should ever be put
in the tire. This limit is set by the tire manufacturer.
159 07 Wheels and tires
Tire designations
The tire suppliers may have additional markings, notes or warnings such \
as standard load, radial tubeless,
etc.
160 07 Wheels and tires
Glossary of tire terminology
Tire terminology
l Tire information placard: A placard showing the OE (Original Equipment) tire sizes, recommende\
d
inflation pressure, and the maximum weight the vehicle can carry.
l Tire Identification Number (TIN): A number on the sidewall of each tire providing information about
the tire brand and manufacturing plant, tire size and date of manufactur\
er.
l Inflation pressure: A measure of the amount of air in a tire.
l Standard load: A class of P-metric or Metric tires designed to carry a maximum load a\
t 35 psi [37 psi
(2.5 bar) for Metric tires]. Increasing the inflation pressure beyond \
this pressure will not increase the tires
load carrying capability.
l Extra load: A class of P-metric or Metric tires designed to carry a heavier maximu\
m load at 41 psi [43
psi (2.9 bar) for Metric tires]. Increasing the inflation pressure bey\
ond this pressure will not increase the
tires load carrying capability.
l kPa: Kilopascal, a metric unit of air pressure.
l PSI: Pounds per square inch, a standard unit of air pressure.
l B-pillar: The structural member at the side of the vehicle behind the front door\
.
l Bead area of the tire: Area of the tire next to the rim.
l Sidewall of the tire: Area between the bead area and the tread.
l Tread area of the tire: Area of the perimeter of the tire that contacts the road when mounted \
on the
vehicle.
file:///K|/delme/2007_C70/07c70_07.htm (10 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
l Rim: The metal support (wheel) for a tire or a tire and tube assembly upo\
n which the tire beads are
seated.
l Maximum load rating: a figure indicating the maximum load in pounds and kilograms that can \
be
carried by the tire. This rating is established by the tire manufacturer\
.
l Maximum permissible inflation pressure: the greatest amount of air pressure that should ever be put
in the tire. This limit is set by the tire manufacturer.
l Recommended tire inflation pressure: inflation pressure, established by Volvo, which is based on the
type of tires that are mounted on a vehicle at the factory. This inflati\
on pressure is affected by the number
of occupants in the car, the amount of cargo, and the speed at which the\
vehicle will be driven for a
prolonged period.
This information can be found on the tire inflation placard(s) located\
on the driver's side B-pillar or on the
inside of the fuel filler door on Canadian models, and in the tire infla\
tion table in this chapter.
l Cold tires: The tires are considered to be cold when they have the same temperatur\
e as the surrounding
(ambient) air. This temperature is normally reached after the car has \
been parked for at least 3 hours.
161 07 Wheels and tires
Vehicle loading
Vehicle loading
Properly loading your vehicle will provide maximum return of vehicle des\
ign performance.
Before loading your vehicle, familiarize yourself with the following ter\
ms for determining your vehicle's
weight ratings, with or without a trailer, from the vehicle's Federal/Ca\
nadian Motor Vehicle Safety
Standards (FMVSS/ CMVSS) label, and the vehicle's tire information pla\
card:
Curb weight
The weight of the vehicle including a full tank of fuel and all standard\
equipment. It does not include
passengers, cargo, or optional equipment.
Capacity weight
All weight added to the curb weight, including cargo and optional equipm\
ent. When towing, trailer hitch
tongue load is also part of cargo weight.
NOTE
For trailer towing information, please refer to the section "Towing a tr\
ailer" on
page
146.
file:///K|/delme/2007_C70/07c70_07.htm (11 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
more tread on the rear tires will help reduce oversteer. Oversteer is wh\
en a vehicle wants to keep turning
because of momentum and dynamic forces on its suspension.
Suspension wear diagnostics
Every suspension needs periodic inspection and maintenance. A tire's wea\
r pattern can be an aid in
detecting a suspension problem. Each tire, if left in place, tells a sto\
ry about the suspension. Tire rotation,
on the other hand, could make suspension wear harder to detect. Early de\
tection is very important,
because suspension problems can make tire wear worse.
If you do rotate your tires...
Please follow the tire manufacturer's recommendations, as outlined in th\
e tire manufacturers tire warranty
pamphlet.
167 07 Wheels and tires
Temporary spare
Temporary spare (option)
The spare tire in your car is called a "Temporary Spare".
Recommended tire pressure (see the placard on the B-pillar) should be \
maintained irrespective of which
position on the car the temporary spare tire is used on.
In the event of damage to this tire, a new one can be purchased from you\
r Volvo retailer.
Location of the optional spare wheel and tools
The spare wheel is packed in a storage bag and is located under the pane\
l in the floor of the trunk.
file:///K|/delme/2007_C70/07c70_07.htm (18 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
Temporarily repairing a flat tire
Before using the tire sealing system, observe the following:
WARNING
l Never leave the tire sealing system unattended when it is operating.
l Keep the tire sealing system kit away from children.
l The vehicle's engine should be running when the tire sealing system is u\
sed to avoid battery drain.
Therefore, be sure the vehicle is parked in a well ventilated place befo\
re using the system.
l Be sure the vehicle is parked safely off the road and away from moving t\
raffic.
l Apply the parking brake.
l Do not remove any foreign objects (nails, etc.) from the tire.
172 07 Wheels and tires
Tire sealing system
Temporarily repairing a flat tire is done in two stages
l In the first stage, the hole is sealed by pumping sealing compound into \
the tire. The car is then driven a
short distance to distribute the sealing compound in the tire.
l In the second stage, the tire's inflation pressure is checked and adjust\
ed if necessary.
Stage 1 - Sealing the hole
Peel off the speed limit sticker (1) and affix it to the steering whee\
l hub where it will be clearly visible to
the driver.
file:///K|/delme/2007_C70/07c70_07.htm (24 of 30)12/22/2006 9:15:51 PM\

2007 Volvo C70
1. Ensure that the orange switch (2) is in position 0 (the 0 side of \
the switch should be pressed down).
2. Pull out the electrical wire (5) and hose (4) from the side compa\
rtment (3).
3. Remove the valve cap from the tire's inflation valve and screw the ho\
se connector onto the valve as
tightly as possible by hand.
4. Connect the electrical wire to the nearest 12-volt socket in the vehi\
cle.
5. Release the safety catch (6) and turn the orange colored section of\
the sealing kit (7), which holds the
sealing compound container, 90 degrees until it clicks into the vertical\
position.
6. Start the vehicle's engine.
7. Start the tire sealing system's compressor by pressing the switch (2\
) to position I.
NOTE
The air pressure gauge (9) will temporarily show an increase in pressu\
re to approximately 88 psi (6 bar)
while the sealing compound is being pumped into the tire. The pressure s\
hould return to a normal level
after approximately one minute.
WARNING
l Contact with the sealing compound may cause skin irritation. If contact \
occurs, wash the affected area
immediately.
l Never stand next to the tire being inflated when the compressor is in op\
eration.
l If cracks, bubbles, etc. form on the tire, switch off the compressor imm\
ediately.
l If there is visible damage to the sidewall or the rim, the tire cannot b\
e repaired. The vehicle should
not be driven if this occurs.
Contact a towing service or Volvo On Call Roadside Assistance if applica\
ble.
8. Within seven minutes, inflate the tire to between 22 - 50 psi (1.8 -\
3.5 bar). Switch off the compressor
briefly to get a clear reading from the pressure gauge (9).
9. Disconnect the electrical wire from the 12-volt socket.
NOTE
file:///K|/delme/2007_C70/07c70_07.htm (25 of 30)12/22/2006 9:15:51 PM\