2007 TOYOTA CAMRY HYBRID light

’07Camry hybrid_U (L/O 0610)
19
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Slip indicator light
∗1: For details, see “Service reminder indicators and warning
buzzers” on page 150 in Section 1 −6.
∗
2: If this light flashes, see “Cruise control” on page 176 in Sec-
tion 1 −7. Cruise control indicator light
∗
2
Turn signal indicator lights
“AIRBAG OFF” indicator light
Headlight indicator light
Tail light indicator light
Headlight high beam indicator light
“AIRBAG ON” indicator light
Driving ready light
Master warning light∗1
Low tire pressure warning light∗1

’07Camry hybrid_U (L/O 0610)
23
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
NOTICE
When using a electronic key contain-
ing a transponder chip, observe the
following precautions:
Do not affix any material that cuts
off electromagnetic waves (such as
a metal seal) on the electronic key.
 Do not knock the electronic key
hard against other objects.
 Do not leave the electronic key ex-
posed to high temperatures for a
long period, such as on the dash-
board or hood under direct sun-
light.
 Do not put the electronic key in
water or wash it in an ultrasonic
washer.
 Do not keep the electronic key to-
gether with the products emitting
electromagnetic waves such as a
cellular phone.
USING A MECHANICAL KEY
When you use the mechanical key, push
the release button and take out the me-
chanical key as shown. Be sure to put the
mechanical key back when not in use.KEY NUMBER PLATE
Your key number is shown on the plate.
Keep the plate in a safe place such as
your wallet, not in the vehicle.
If you should lose your keys or if you
need additional keys, duplicates can be
made by Toyota dealer using the key
number.
We recommend writing down the key num-
ber and storing it in a safe place.

’07Camry hybrid_U (L/O 0610)
24
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
The engine immobilizer system is a
theft prevention system. The transpond-
er chip in the key transmits an elec-
tronic code to the vehicle. The hybrid
system will start only when the elec-
tronic code in the chip corresponds to
the registered ID code for the vehicle.
The engine immobilizer system is automat-
ically set when the “POWER” switch is
turned off.
The indicator light will start flashing to
show that the system is set.
If any of the following indicator conditions
occur, contact your Toyota dealer.
The indicator light remains on.
The indicator light does not start flash-
ing when the “POWER” switch is
turned off.
The indicator light flashes inconsistent-
ly.The engine immobilizer system is automat-
ically canceled when you enter the vehicle
carrying an electronic key and press the
“POWER” switch.
Even if the key battery is discharged, the
hybrid system can be turned on. See
“Smart key system” on page 32 in this
Section.
When the system is canceled, the indica-
tor light will go off.
For your Toyota dealer to make you a
new key with built
−in transponder chip,
your dealer will need your key number
and electronic key. However, there is a
limit to the number of additional keys your
Toyota dealer can make for you.
NOTICE
Do not modify, remove or disas-
semble the engine immobilizer sys-
tem. If any unauthorized changes or
modifications are made, proper opera-
tion of the system cannot be guaran-
teed.
Engine immobilizer system

’07Camry hybrid_U (L/O 0610)
25
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
For vehicles sold in U.S.A.
FCC ID: NI4TMIMB1
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received, includ-
ing interference that may cause unde-
sired operation.
CAUTION
Changes or modifications not ex-
pressly approved by the party respon-
sible for compliance could void the
user’s authority to operate the equip-
ment.
For vehicles sold in Canada
This device complies with RSS−210 of
Industry Canada. Operation is subject to
the following two conditions:
(1) This device may not cause interfer-
ence, and (2) this device must accept
any interference, including interference
that may cause undesired operation of
the device.
1. Indicator light
2. Lock switch
3. Alarm switch
4. Unlock switch
5. Trunk opener switch
Wireless remote control—

’07Camry hybrid_U (L/O 0610)
26
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
The wireless remote control function is
designed to lock or unlock all the
doors, open the trunk lid, or activate
the alarm from a distance within
approximately 1 m (3 ft.) of the vehicle.
When you operate any switch, push it
slowly and securely.
When the switch is operated, the indicator
light flashes once. If not, the battery may
be discharged. Replace the battery at the
earliest opportunity.
Observe the following precautions to pre-
vent damage the key.
Do not leave the electronic key in
places where the temperature becomes
high such as on the dashboard.
Do not disassemble it.
Avoid knocking it hard against other
objects or dropping it.
Avoid putting it in water.If the wireless remote control function
does not actuate the doors, or does not
operate from a normal distance, or if the
indicator on the key is dimmed or does
not come on:
Check for closeness to a radio trans-
mitter such as a radio station or an
airport which can interfere with normal
operation of the key.
The battery may have been consumed.
Check the battery in the key. To re-
place the battery, see “—Replacing bat-
tery” on page 30 in this Section.
If you lose your key, contact your Toyota
dealer as soon as possible to avoid the
possibility of theft, or an accident. (See “If
you lose your keys” on page 330 in Sec-
tion 4.)
It is possible to disable the wireless re-
mote control system. For details, contact
your Toyota dealer. For vehicles sold in U.S.A.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received, includ-
ing interference that may cause unde-
sired operation.

’07Camry hybrid_U (L/O 0610)
28
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
To lock or unlock all the doors, push
the switches slowly and securely.
To lock: Push the lock switch. All the
doors are locked simultaneously. At this
time one beep will sound and turn signal
lights flash once.
Check to see that the doors are securely
locked.
If any of the doors is not securely closed,
or if the key is left in the vehicle, locking
cannot be performed by the lock switch
and a beep will sound continuously for 10
seconds.
To stop the beep, take out the key from
the vehicle or push the unlock switch.
The answerback function (the turn signal
flash and the beep) can be disabled. For
details, contact your Toyota dealer.
To unlock: Push the unlock switch once to
unlock the driver ’s door alone. Pushing
the switch twice within 3 seconds unlocks
all the doors simultaneously. Each time
the unlock switch is pushed, two beeps
will sound and turn signal lights flash
twice.
This double switch operation to unlock all
doors can be changed to a single switch
operation. For details, contact your Toyota
dealer.If the “POWER” switch is set at ACC or
ON, the vehicle cannot be unlocked via
the unlock switch.
You have 60 seconds to open a door after
using the wireless remote unlock feature.
If a door is not opened by then, all the
doors will be automatically locked again.
If the wireless remote control is used to
lock the doors near the window or door
handle, there is a possibility that the door
may not unlocked by entry function of
smart key system. Under these circum-
stances, use the wireless remote control
function to unlock the doors.
The automatic locking time can also be
set to 30 seconds. For details, contact
your Toyota dealer.
If the lock or unlock switch is kept
pressed in, the locking or unlocking opera-
tion is not repeated. Release the switch
and then push again.
When you unlock doors using the wireless
remote control, the illuminated entry func-
tion will be activated. (For further informa-
tion, see “Illuminated entry system” on
page 127 in Section 1
−5.)
To open the trunk lid, push the trunk
opener switch of the electronic key for
1 second. A long beep will sound.
If the “POWER” switch is set at ACC or
ON, the trunk lid cannot be opened by the
trunk opener switch.
—Opening trunk lid

’07Camry hybrid_U (L/O 0610)
29
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Opening of the trunk lid with the wireless
remote control can be changed as follows.
Contact your Toyota dealer for details.
Trunk lid opens by pushing the trunk
opener switch twice in succession.
Trunk lid opens by pushing the trunk
opener switch once regardless of how
long the switch is being pressed.
Opening of the trunk lid with the wire-
less remote control function is dis-
abled.
Pushing the switch blows the horn in-
termittently and flashes the exterior
lights and interior light.
When pushing the switch, the indicator
light flashes.
The alarm switch is used to deter vehicle
theft when you witness anyone attempting
to break into or damage your vehicle.
The alarm will last for one minute. To stop
the alarm midway, push the switch once
again, unlock a door with the wireless
remote control function, or set the
“POWER” switch at ON.If the “POWER” switch is set at ACC or
ON, the alarm does not work.
This alarm function can be disabled. For
details, contact your Toyota dealer.
—Activating alarm

’07Camry hybrid_U (L/O 0610)
33
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
ENTRY FUNCTION AND START
FUNCTION
Simply by carrying the key, you can
lock and unlock the doors and start the
hybrid system.
Entry function—You can lock and unlock
the doors and open the trunk without in-
serting the key in the keyholes. For fur-
ther information, see “Side doors” on page
38 and “Trunk lid” on page 47 in this
Section.
Start function— You can shift the power
supply mode and start the hybrid system
when the electronic key is in the vehicle.
For further information, see “‘POWER’
switch” on page 160 in Section 1 −7 and
“How to start the hybrid system” on page
301 in Section 3.
If the smart key system does not oper-
ate properly because of a system mal-
function, consult your Toyota dealer.
Make sure to bring all of the keys. They
may be necessary to repair the system. STEERING LOCK FUNCTION
When the driver ’s door is opened after
turning off the hybrid system, the steering
wheel will lock.
The steering lock is automatically un-
locked when the “POWER” switch is
pressed. If the indicator light on the
“POWER” switch flashes green, this indi-
cates that the steering wheel remains
locked. If the amber indicator light flashes,
this indicates that the steering lock is mal-
functioning. For details, see “How to start
the hybrid system” on page 301 in Section
3.